1/* SPDX-License-Identifier: GPL-2.0-only */
2/*
3 * relocate_kernel.S - put the kernel image in place to boot
4 * Copyright (C) 2002-2005 Eric Biederman  <ebiederm@xmission.com>
5 */
6
7#include <linux/linkage.h>
8#include <asm/page_types.h>
9#include <asm/kexec.h>
10#include <asm/processor-flags.h>
11#include <asm/pgtable_types.h>
12#include <asm/nospec-branch.h>
13#include <asm/unwind_hints.h>
14
15/*
16 * Must be relocatable PIC code callable as a C function
17 */
18
19#define PTR(x) (x << 3)
20#define PAGE_ATTR (_PAGE_PRESENT | _PAGE_RW | _PAGE_ACCESSED | _PAGE_DIRTY)
21
22/*
23 * control_page + KEXEC_CONTROL_CODE_MAX_SIZE
24 * ~ control_page + PAGE_SIZE are used as data storage and stack for
25 * jumping back
26 */
27#define DATA(offset)		(KEXEC_CONTROL_CODE_MAX_SIZE+(offset))
28
29/* Minimal CPU state */
30#define RSP			DATA(0x0)
31#define CR0			DATA(0x8)
32#define CR3			DATA(0x10)
33#define CR4			DATA(0x18)
34
35/* other data */
36#define CP_PA_TABLE_PAGE	DATA(0x20)
37#define CP_PA_SWAP_PAGE		DATA(0x28)
38#define CP_PA_BACKUP_PAGES_MAP	DATA(0x30)
39
40	.text
41	.align PAGE_SIZE
42	.code64
43SYM_CODE_START_NOALIGN(relocate_kernel)
44	UNWIND_HINT_EMPTY
45	/*
46	 * %rdi indirection_page
47	 * %rsi page_list
48	 * %rdx start address
49	 * %rcx preserve_context
50	 * %r8  host_mem_enc_active
51	 */
52
53	/* Save the CPU context, used for jumping back */
54	pushq %rbx
55	pushq %rbp
56	pushq %r12
57	pushq %r13
58	pushq %r14
59	pushq %r15
60	pushf
61
62	movq	PTR(VA_CONTROL_PAGE)(%rsi), %r11
63	movq	%rsp, RSP(%r11)
64	movq	%cr0, %rax
65	movq	%rax, CR0(%r11)
66	movq	%cr3, %rax
67	movq	%rax, CR3(%r11)
68	movq	%cr4, %rax
69	movq	%rax, CR4(%r11)
70
71	/* Save CR4. Required to enable the right paging mode later. */
72	movq	%rax, %r13
73
74	/* zero out flags, and disable interrupts */
75	pushq $0
76	popfq
77
78	/* Save SME active flag */
79	movq	%r8, %r12
80
81	/*
82	 * get physical address of control page now
83	 * this is impossible after page table switch
84	 */
85	movq	PTR(PA_CONTROL_PAGE)(%rsi), %r8
86
87	/* get physical address of page table now too */
88	movq	PTR(PA_TABLE_PAGE)(%rsi), %r9
89
90	/* get physical address of swap page now */
91	movq	PTR(PA_SWAP_PAGE)(%rsi), %r10
92
93	/* save some information for jumping back */
94	movq	%r9, CP_PA_TABLE_PAGE(%r11)
95	movq	%r10, CP_PA_SWAP_PAGE(%r11)
96	movq	%rdi, CP_PA_BACKUP_PAGES_MAP(%r11)
97
98	/* Switch to the identity mapped page tables */
99	movq	%r9, %cr3
100
101	/* setup a new stack at the end of the physical control page */
102	lea	PAGE_SIZE(%r8), %rsp
103
104	/* jump to identity mapped page */
105	addq	$(identity_mapped - relocate_kernel), %r8
106	pushq	%r8
107	RET
108SYM_CODE_END(relocate_kernel)
109
110SYM_CODE_START_LOCAL_NOALIGN(identity_mapped)
111	UNWIND_HINT_EMPTY
112	/* set return address to 0 if not preserving context */
113	pushq	$0
114	/* store the start address on the stack */
115	pushq   %rdx
116
117	/*
118	 * Set cr0 to a known state:
119	 *  - Paging enabled
120	 *  - Alignment check disabled
121	 *  - Write protect disabled
122	 *  - No task switch
123	 *  - Don't do FP software emulation.
124	 *  - Protected mode enabled
125	 */
126	movq	%cr0, %rax
127	andq	$~(X86_CR0_AM | X86_CR0_WP | X86_CR0_TS | X86_CR0_EM), %rax
128	orl	$(X86_CR0_PG | X86_CR0_PE), %eax
129	movq	%rax, %cr0
130
131	/*
132	 * Set cr4 to a known state:
133	 *  - physical address extension enabled
134	 *  - 5-level paging, if it was enabled before
135	 */
136	movl	$X86_CR4_PAE, %eax
137	testq	$X86_CR4_LA57, %r13
138	jz	1f
139	orl	$X86_CR4_LA57, %eax
1401:
141	movq	%rax, %cr4
142
143	jmp 1f
1441:
145
146	/* Flush the TLB (needed?) */
147	movq	%r9, %cr3
148
149	/*
150	 * If SME is active, there could be old encrypted cache line
151	 * entries that will conflict with the now unencrypted memory
152	 * used by kexec. Flush the caches before copying the kernel.
153	 */
154	testq	%r12, %r12
155	jz 1f
156	wbinvd
1571:
158
159	movq	%rcx, %r11
160	call	swap_pages
161
162	/*
163	 * To be certain of avoiding problems with self-modifying code
164	 * I need to execute a serializing instruction here.
165	 * So I flush the TLB by reloading %cr3 here, it's handy,
166	 * and not processor dependent.
167	 */
168	movq	%cr3, %rax
169	movq	%rax, %cr3
170
171	/*
172	 * set all of the registers to known values
173	 * leave %rsp alone
174	 */
175
176	testq	%r11, %r11
177	jnz 1f
178	xorl	%eax, %eax
179	xorl	%ebx, %ebx
180	xorl    %ecx, %ecx
181	xorl    %edx, %edx
182	xorl    %esi, %esi
183	xorl    %edi, %edi
184	xorl    %ebp, %ebp
185	xorl	%r8d, %r8d
186	xorl	%r9d, %r9d
187	xorl	%r10d, %r10d
188	xorl	%r11d, %r11d
189	xorl	%r12d, %r12d
190	xorl	%r13d, %r13d
191	xorl	%r14d, %r14d
192	xorl	%r15d, %r15d
193
194	RET
195
1961:
197	popq	%rdx
198	leaq	PAGE_SIZE(%r10), %rsp
199	ANNOTATE_RETPOLINE_SAFE
200	call	*%rdx
201
202	/* get the re-entry point of the peer system */
203	movq	0(%rsp), %rbp
204	leaq	relocate_kernel(%rip), %r8
205	movq	CP_PA_SWAP_PAGE(%r8), %r10
206	movq	CP_PA_BACKUP_PAGES_MAP(%r8), %rdi
207	movq	CP_PA_TABLE_PAGE(%r8), %rax
208	movq	%rax, %cr3
209	lea	PAGE_SIZE(%r8), %rsp
210	call	swap_pages
211	movq	$virtual_mapped, %rax
212	pushq	%rax
213	RET
214SYM_CODE_END(identity_mapped)
215
216SYM_CODE_START_LOCAL_NOALIGN(virtual_mapped)
217	UNWIND_HINT_EMPTY
218	movq	RSP(%r8), %rsp
219	movq	CR4(%r8), %rax
220	movq	%rax, %cr4
221	movq	CR3(%r8), %rax
222	movq	CR0(%r8), %r8
223	movq	%rax, %cr3
224	movq	%r8, %cr0
225	movq	%rbp, %rax
226
227	popf
228	popq	%r15
229	popq	%r14
230	popq	%r13
231	popq	%r12
232	popq	%rbp
233	popq	%rbx
234	RET
235SYM_CODE_END(virtual_mapped)
236
237	/* Do the copies */
238SYM_CODE_START_LOCAL_NOALIGN(swap_pages)
239	UNWIND_HINT_EMPTY
240	movq	%rdi, %rcx 	/* Put the page_list in %rcx */
241	xorl	%edi, %edi
242	xorl	%esi, %esi
243	jmp	1f
244
2450:	/* top, read another word for the indirection page */
246
247	movq	(%rbx), %rcx
248	addq	$8,	%rbx
2491:
250	testb	$0x1,	%cl   /* is it a destination page? */
251	jz	2f
252	movq	%rcx,	%rdi
253	andq	$0xfffffffffffff000, %rdi
254	jmp	0b
2552:
256	testb	$0x2,	%cl   /* is it an indirection page? */
257	jz	2f
258	movq	%rcx,   %rbx
259	andq	$0xfffffffffffff000, %rbx
260	jmp	0b
2612:
262	testb	$0x4,	%cl   /* is it the done indicator? */
263	jz	2f
264	jmp	3f
2652:
266	testb	$0x8,	%cl   /* is it the source indicator? */
267	jz	0b	      /* Ignore it otherwise */
268	movq	%rcx,   %rsi  /* For ever source page do a copy */
269	andq	$0xfffffffffffff000, %rsi
270
271	movq	%rdi, %rdx
272	movq	%rsi, %rax
273
274	movq	%r10, %rdi
275	movl	$512, %ecx
276	rep ; movsq
277
278	movq	%rax, %rdi
279	movq	%rdx, %rsi
280	movl	$512, %ecx
281	rep ; movsq
282
283	movq	%rdx, %rdi
284	movq	%r10, %rsi
285	movl	$512, %ecx
286	rep ; movsq
287
288	lea	PAGE_SIZE(%rax), %rsi
289	jmp	0b
2903:
291	RET
292SYM_CODE_END(swap_pages)
293
294	.globl kexec_control_code_size
295.set kexec_control_code_size, . - relocate_kernel
296