1 #ifndef _ASM_SPARC_DMA_H 2 #define _ASM_SPARC_DMA_H 3 4 /* These are irrelevant for Sparc DMA, but we leave it in so that 5 * things can compile. 6 */ 7 #define MAX_DMA_CHANNELS 8 8 #define DMA_MODE_READ 1 9 #define DMA_MODE_WRITE 2 10 #define MAX_DMA_ADDRESS (~0UL) 11 12 /* Useful constants */ 13 #define SIZE_16MB (16*1024*1024) 14 #define SIZE_64K (64*1024) 15 16 /* SBUS DMA controller reg offsets */ 17 #define DMA_CSR 0x00UL /* rw DMA control/status register 0x00 */ 18 #define DMA_ADDR 0x04UL /* rw DMA transfer address register 0x04 */ 19 #define DMA_COUNT 0x08UL /* rw DMA transfer count register 0x08 */ 20 #define DMA_TEST 0x0cUL /* rw DMA test/debug register 0x0c */ 21 22 /* Fields in the cond_reg register */ 23 /* First, the version identification bits */ 24 #define DMA_DEVICE_ID 0xf0000000 /* Device identification bits */ 25 #define DMA_VERS0 0x00000000 /* Sunray DMA version */ 26 #define DMA_ESCV1 0x40000000 /* DMA ESC Version 1 */ 27 #define DMA_VERS1 0x80000000 /* DMA rev 1 */ 28 #define DMA_VERS2 0xa0000000 /* DMA rev 2 */ 29 #define DMA_VERHME 0xb0000000 /* DMA hme gate array */ 30 #define DMA_VERSPLUS 0x90000000 /* DMA rev 1 PLUS */ 31 32 #define DMA_HNDL_INTR 0x00000001 /* An IRQ needs to be handled */ 33 #define DMA_HNDL_ERROR 0x00000002 /* We need to take an error */ 34 #define DMA_FIFO_ISDRAIN 0x0000000c /* The DMA FIFO is draining */ 35 #define DMA_INT_ENAB 0x00000010 /* Turn on interrupts */ 36 #define DMA_FIFO_INV 0x00000020 /* Invalidate the FIFO */ 37 #define DMA_ACC_SZ_ERR 0x00000040 /* The access size was bad */ 38 #define DMA_FIFO_STDRAIN 0x00000040 /* DMA_VERS1 Drain the FIFO */ 39 #define DMA_RST_SCSI 0x00000080 /* Reset the SCSI controller */ 40 #define DMA_RST_ENET DMA_RST_SCSI /* Reset the ENET controller */ 41 #define DMA_ST_WRITE 0x00000100 /* write from device to memory */ 42 #define DMA_ENABLE 0x00000200 /* Fire up DMA, handle requests */ 43 #define DMA_PEND_READ 0x00000400 /* DMA_VERS1/0/PLUS Pending Read */ 44 #define DMA_ESC_BURST 0x00000800 /* 1=16byte 0=32byte */ 45 #define DMA_READ_AHEAD 0x00001800 /* DMA read ahead partial longword */ 46 #define DMA_DSBL_RD_DRN 0x00001000 /* No EC drain on slave reads */ 47 #define DMA_BCNT_ENAB 0x00002000 /* If on, use the byte counter */ 48 #define DMA_TERM_CNTR 0x00004000 /* Terminal counter */ 49 #define DMA_SCSI_SBUS64 0x00008000 /* HME: Enable 64-bit SBUS mode. */ 50 #define DMA_CSR_DISAB 0x00010000 /* No FIFO drains during csr */ 51 #define DMA_SCSI_DISAB 0x00020000 /* No FIFO drains during reg */ 52 #define DMA_DSBL_WR_INV 0x00020000 /* No EC inval. on slave writes */ 53 #define DMA_ADD_ENABLE 0x00040000 /* Special ESC DVMA optimization */ 54 #define DMA_E_BURSTS 0x000c0000 /* ENET: SBUS r/w burst mask */ 55 #define DMA_E_BURST32 0x00040000 /* ENET: SBUS 32 byte r/w burst */ 56 #define DMA_E_BURST16 0x00000000 /* ENET: SBUS 16 byte r/w burst */ 57 #define DMA_BRST_SZ 0x000c0000 /* SCSI: SBUS r/w burst size */ 58 #define DMA_BRST64 0x000c0000 /* SCSI: 64byte bursts (HME on UltraSparc only) */ 59 #define DMA_BRST32 0x00040000 /* SCSI: 32byte bursts */ 60 #define DMA_BRST16 0x00000000 /* SCSI: 16byte bursts */ 61 #define DMA_BRST0 0x00080000 /* SCSI: no bursts (non-HME gate arrays) */ 62 #define DMA_ADDR_DISAB 0x00100000 /* No FIFO drains during addr */ 63 #define DMA_2CLKS 0x00200000 /* Each transfer = 2 clock ticks */ 64 #define DMA_3CLKS 0x00400000 /* Each transfer = 3 clock ticks */ 65 #define DMA_EN_ENETAUI DMA_3CLKS /* Put lance into AUI-cable mode */ 66 #define DMA_CNTR_DISAB 0x00800000 /* No IRQ when DMA_TERM_CNTR set */ 67 #define DMA_AUTO_NADDR 0x01000000 /* Use "auto nxt addr" feature */ 68 #define DMA_SCSI_ON 0x02000000 /* Enable SCSI dma */ 69 #define DMA_PARITY_OFF 0x02000000 /* HME: disable parity checking */ 70 #define DMA_LOADED_ADDR 0x04000000 /* Address has been loaded */ 71 #define DMA_LOADED_NADDR 0x08000000 /* Next address has been loaded */ 72 #define DMA_RESET_FAS366 0x08000000 /* HME: Assert RESET to FAS366 */ 73 74 /* Values describing the burst-size property from the PROM */ 75 #define DMA_BURST1 0x01 76 #define DMA_BURST2 0x02 77 #define DMA_BURST4 0x04 78 #define DMA_BURST8 0x08 79 #define DMA_BURST16 0x10 80 #define DMA_BURST32 0x20 81 #define DMA_BURST64 0x40 82 #define DMA_BURSTBITS 0x7f 83 84 /* From PCI */ 85 86 #ifdef CONFIG_PCI 87 extern int isa_dma_bridge_buggy; 88 #else 89 #define isa_dma_bridge_buggy (0) 90 #endif 91 92 #ifdef CONFIG_SPARC32 93 94 /* Routines for data transfer buffers. */ 95 BTFIXUPDEF_CALL(char *, mmu_lockarea, char *, unsigned long) 96 BTFIXUPDEF_CALL(void, mmu_unlockarea, char *, unsigned long) 97 98 #define mmu_lockarea(vaddr,len) BTFIXUP_CALL(mmu_lockarea)(vaddr,len) 99 #define mmu_unlockarea(vaddr,len) BTFIXUP_CALL(mmu_unlockarea)(vaddr,len) 100 101 struct page; 102 struct device; 103 struct scatterlist; 104 105 /* These are implementations for sbus_map_sg/sbus_unmap_sg... collapse later */ 106 BTFIXUPDEF_CALL(__u32, mmu_get_scsi_one, struct device *, char *, unsigned long) 107 BTFIXUPDEF_CALL(void, mmu_get_scsi_sgl, struct device *, struct scatterlist *, int) 108 BTFIXUPDEF_CALL(void, mmu_release_scsi_one, struct device *, __u32, unsigned long) 109 BTFIXUPDEF_CALL(void, mmu_release_scsi_sgl, struct device *, struct scatterlist *, int) 110 111 #define mmu_get_scsi_one(dev,vaddr,len) BTFIXUP_CALL(mmu_get_scsi_one)(dev,vaddr,len) 112 #define mmu_get_scsi_sgl(dev,sg,sz) BTFIXUP_CALL(mmu_get_scsi_sgl)(dev,sg,sz) 113 #define mmu_release_scsi_one(dev,vaddr,len) BTFIXUP_CALL(mmu_release_scsi_one)(dev,vaddr,len) 114 #define mmu_release_scsi_sgl(dev,sg,sz) BTFIXUP_CALL(mmu_release_scsi_sgl)(dev,sg,sz) 115 116 /* 117 * mmu_map/unmap are provided by iommu/iounit; Invalid to call on IIep. 118 * 119 * The mmu_map_dma_area establishes two mappings in one go. 120 * These mappings point to pages normally mapped at 'va' (linear address). 121 * First mapping is for CPU visible address at 'a', uncached. 122 * This is an alias, but it works because it is an uncached mapping. 123 * Second mapping is for device visible address, or "bus" address. 124 * The bus address is returned at '*pba'. 125 * 126 * These functions seem distinct, but are hard to split. On sun4c, 127 * at least for now, 'a' is equal to bus address, and retured in *pba. 128 * On sun4m, page attributes depend on the CPU type, so we have to 129 * know if we are mapping RAM or I/O, so it has to be an additional argument 130 * to a separate mapping function for CPU visible mappings. 131 */ 132 BTFIXUPDEF_CALL(int, mmu_map_dma_area, struct device *, dma_addr_t *, unsigned long, unsigned long, int len) 133 BTFIXUPDEF_CALL(void, mmu_unmap_dma_area, struct device *, unsigned long busa, int len) 134 135 #define mmu_map_dma_area(dev,pba,va,a,len) BTFIXUP_CALL(mmu_map_dma_area)(dev,pba,va,a,len) 136 #define mmu_unmap_dma_area(dev,ba,len) BTFIXUP_CALL(mmu_unmap_dma_area)(dev,ba,len) 137 #endif 138 139 #endif /* !(_ASM_SPARC_DMA_H) */ 140