xref: /openbmc/linux/arch/sh/include/asm/smc37c93x.h (revision 6c33a6f4)
1 /* SPDX-License-Identifier: GPL-2.0 */
2 #ifndef __ASM_SH_SMC37C93X_H
3 #define __ASM_SH_SMC37C93X_H
4 
5 /*
6  * linux/include/asm-sh/smc37c93x.h
7  *
8  * Copyright (C) 2000  Kazumoto Kojima
9  *
10  * SMSC 37C93x Super IO Chip support
11  */
12 
13 /* Default base I/O address */
14 #define FDC_PRIMARY_BASE	0x3f0
15 #define IDE1_PRIMARY_BASE	0x1f0
16 #define IDE1_SECONDARY_BASE	0x170
17 #define PARPORT_PRIMARY_BASE	0x378
18 #define COM1_PRIMARY_BASE	0x2f8
19 #define COM2_PRIMARY_BASE	0x3f8
20 #define RTC_PRIMARY_BASE	0x070
21 #define KBC_PRIMARY_BASE	0x060
22 #define AUXIO_PRIMARY_BASE	0x000	/* XXX */
23 
24 /* Logical device number */
25 #define LDN_FDC			0
26 #define LDN_IDE1		1
27 #define LDN_IDE2		2
28 #define LDN_PARPORT		3
29 #define LDN_COM1		4
30 #define LDN_COM2		5
31 #define LDN_RTC			6
32 #define LDN_KBC			7
33 #define LDN_AUXIO		8
34 
35 /* Configuration port and key */
36 #define CONFIG_PORT		0x3f0
37 #define INDEX_PORT		CONFIG_PORT
38 #define DATA_PORT		0x3f1
39 #define CONFIG_ENTER		0x55
40 #define CONFIG_EXIT		0xaa
41 
42 /* Configuration index */
43 #define CURRENT_LDN_INDEX	0x07
44 #define POWER_CONTROL_INDEX	0x22
45 #define ACTIVATE_INDEX		0x30
46 #define IO_BASE_HI_INDEX	0x60
47 #define IO_BASE_LO_INDEX	0x61
48 #define IRQ_SELECT_INDEX	0x70
49 #define DMA_SELECT_INDEX	0x74
50 
51 #define GPIO46_INDEX		0xc6
52 #define GPIO47_INDEX		0xc7
53 
54 /* UART stuff. Only for debugging.  */
55 /* UART Register */
56 
57 #define UART_RBR	0x0	/* Receiver Buffer Register (Read Only) */
58 #define UART_THR	0x0	/* Transmitter Holding Register (Write Only) */
59 #define UART_IER	0x2	/* Interrupt Enable Register */
60 #define UART_IIR	0x4	/* Interrupt Ident Register (Read Only) */
61 #define UART_FCR	0x4	/* FIFO Control Register (Write Only) */
62 #define UART_LCR	0x6	/* Line Control Register */
63 #define UART_MCR	0x8	/* MODEM Control Register */
64 #define UART_LSR	0xa	/* Line Status Register */
65 #define UART_MSR	0xc	/* MODEM Status Register */
66 #define UART_SCR	0xe	/* Scratch Register */
67 #define UART_DLL	0x0	/* Divisor Latch (LS) */
68 #define UART_DLM	0x2	/* Divisor Latch (MS) */
69 
70 #ifndef __ASSEMBLY__
71 typedef struct uart_reg {
72 	volatile __u16 rbr;
73 	volatile __u16 ier;
74 	volatile __u16 iir;
75 	volatile __u16 lcr;
76 	volatile __u16 mcr;
77 	volatile __u16 lsr;
78 	volatile __u16 msr;
79 	volatile __u16 scr;
80 } uart_reg;
81 #endif /* ! __ASSEMBLY__ */
82 
83 /* Alias for Write Only Register */
84 
85 #define thr	rbr
86 #define tcr	iir
87 
88 /* Alias for Divisor Latch Register */
89 
90 #define dll	rbr
91 #define dlm	ier
92 #define fcr	iir
93 
94 /* Interrupt Enable Register */
95 
96 #define IER_ERDAI	0x0100	/* Enable Received Data Available Interrupt */
97 #define IER_ETHREI	0x0200	/* Enable Transmitter Holding Register Empty Interrupt */
98 #define IER_ELSI	0x0400	/* Enable Receiver Line Status Interrupt */
99 #define IER_EMSI	0x0800	/* Enable MODEM Status Interrupt */
100 
101 /* Interrupt Ident Register */
102 
103 #define IIR_IP		0x0100	/* "0" if Interrupt Pending */
104 #define IIR_IIB0	0x0200	/* Interrupt ID Bit 0 */
105 #define IIR_IIB1	0x0400	/* Interrupt ID Bit 1 */
106 #define IIR_IIB2	0x0800	/* Interrupt ID Bit 2 */
107 #define IIR_FIFO	0xc000	/* FIFOs enabled */
108 
109 /* FIFO Control Register */
110 
111 #define FCR_FEN		0x0100	/* FIFO enable */
112 #define FCR_RFRES	0x0200	/* Receiver FIFO reset */
113 #define FCR_TFRES	0x0400	/* Transmitter FIFO reset */
114 #define FCR_DMA		0x0800	/* DMA mode select */
115 #define FCR_RTL		0x4000	/* Receiver triger (LSB) */
116 #define FCR_RTM		0x8000	/* Receiver triger (MSB) */
117 
118 /* Line Control Register */
119 
120 #define LCR_WLS0	0x0100	/* Word Length Select Bit 0 */
121 #define LCR_WLS1	0x0200	/* Word Length Select Bit 1 */
122 #define LCR_STB		0x0400	/* Number of Stop Bits */
123 #define LCR_PEN		0x0800	/* Parity Enable */
124 #define LCR_EPS		0x1000	/* Even Parity Select */
125 #define LCR_SP		0x2000	/* Stick Parity */
126 #define LCR_SB		0x4000	/* Set Break */
127 #define LCR_DLAB	0x8000	/* Divisor Latch Access Bit */
128 
129 /* MODEM Control Register */
130 
131 #define MCR_DTR		0x0100	/* Data Terminal Ready */
132 #define MCR_RTS		0x0200	/* Request to Send */
133 #define MCR_OUT1	0x0400	/* Out 1 */
134 #define MCR_IRQEN	0x0800	/* IRQ Enable */
135 #define MCR_LOOP	0x1000	/* Loop */
136 
137 /* Line Status Register */
138 
139 #define LSR_DR		0x0100	/* Data Ready */
140 #define LSR_OE		0x0200	/* Overrun Error */
141 #define LSR_PE		0x0400	/* Parity Error */
142 #define LSR_FE		0x0800	/* Framing Error */
143 #define LSR_BI		0x1000	/* Break Interrupt */
144 #define LSR_THRE	0x2000	/* Transmitter Holding Register Empty */
145 #define LSR_TEMT	0x4000	/* Transmitter Empty */
146 #define LSR_FIFOE	0x8000	/* Receiver FIFO error */
147 
148 /* MODEM Status Register */
149 
150 #define MSR_DCTS	0x0100	/* Delta Clear to Send */
151 #define MSR_DDSR	0x0200	/* Delta Data Set Ready */
152 #define MSR_TERI	0x0400	/* Trailing Edge Ring Indicator */
153 #define MSR_DDCD	0x0800	/* Delta Data Carrier Detect */
154 #define MSR_CTS		0x1000	/* Clear to Send */
155 #define MSR_DSR		0x2000	/* Data Set Ready */
156 #define MSR_RI		0x4000	/* Ring Indicator */
157 #define MSR_DCD		0x8000	/* Data Carrier Detect */
158 
159 /* Baud Rate Divisor */
160 
161 #define UART_CLK	(1843200)	/* 1.8432 MHz */
162 #define UART_BAUD(x)	(UART_CLK / (16 * (x)))
163 
164 /* RTC register definition */
165 #define RTC_SECONDS             0
166 #define RTC_SECONDS_ALARM       1
167 #define RTC_MINUTES             2
168 #define RTC_MINUTES_ALARM       3
169 #define RTC_HOURS               4
170 #define RTC_HOURS_ALARM         5
171 #define RTC_DAY_OF_WEEK         6
172 #define RTC_DAY_OF_MONTH        7
173 #define RTC_MONTH               8
174 #define RTC_YEAR                9
175 #define RTC_FREQ_SELECT		10
176 # define RTC_UIP 0x80
177 # define RTC_DIV_CTL 0x70
178 /* This RTC can work under 32.768KHz clock only.  */
179 # define RTC_OSC_ENABLE 0x20
180 # define RTC_OSC_DISABLE 0x00
181 #define RTC_CONTROL     	11
182 # define RTC_SET 0x80
183 # define RTC_PIE 0x40
184 # define RTC_AIE 0x20
185 # define RTC_UIE 0x10
186 # define RTC_SQWE 0x08
187 # define RTC_DM_BINARY 0x04
188 # define RTC_24H 0x02
189 # define RTC_DST_EN 0x01
190 
191 #endif  /* __ASM_SH_SMC37C93X_H */
192