1// SPDX-License-Identifier: GPL-2.0-or-later
2/*
3 * Digsy MTC board Device Tree Source
4 *
5 * Copyright (C) 2009 Semihalf
6 *
7 * Based on the CM5200 by M. Balakowicz
8 */
9
10/include/ "mpc5200b.dtsi"
11
12&gpt0 { gpio-controller; fsl,has-wdt; };
13&gpt1 { gpio-controller; };
14
15/ {
16	model = "intercontrol,digsy-mtc";
17	compatible = "intercontrol,digsy-mtc";
18
19	memory@0 {
20		reg = <0x00000000 0x02000000>;	// 32MB
21	};
22
23	soc5200@f0000000 {
24		rtc@800 {
25			status = "disabled";
26		};
27
28		spi@f00 {
29			msp430@0 {
30				compatible = "spidev";
31				spi-max-frequency = <32000>;
32				reg = <0>;
33			};
34		};
35
36		psc@2000 {		// PSC1
37			status = "disabled";
38		};
39
40		psc@2200 {		// PSC2
41			status = "disabled";
42		};
43
44		psc@2400 {		// PSC3
45			status = "disabled";
46		};
47
48		psc@2600 {		// PSC4
49			compatible = "fsl,mpc5200b-psc-uart","fsl,mpc5200-psc-uart";
50		};
51
52		psc@2800 {		// PSC5
53			compatible = "fsl,mpc5200b-psc-uart","fsl,mpc5200-psc-uart";
54		};
55
56		psc@2c00 {		// PSC6
57			status = "disabled";
58		};
59
60		ethernet@3000 {
61			phy-handle = <&phy0>;
62		};
63
64		mdio@3000 {
65			phy0: ethernet-phy@0 {
66				reg = <0>;
67			};
68		};
69
70		i2c@3d00 {
71			eeprom@50 {
72				compatible = "atmel,24c08";
73				reg = <0x50>;
74			};
75
76			rtc@56 {
77				compatible = "microcrystal,rv3029";
78				reg = <0x56>;
79			};
80
81			rtc@68 {
82				compatible = "dallas,ds1339";
83				reg = <0x68>;
84			};
85		};
86
87		i2c@3d40 {
88			status = "disabled";
89		};
90	};
91
92	pci@f0000d00 {
93		interrupt-map-mask = <0xf800 0 0 7>;
94		interrupt-map = <0xc000 0 0 1 &mpc5200_pic 0 0 3
95				 0xc000 0 0 2 &mpc5200_pic 0 0 3
96				 0xc000 0 0 3 &mpc5200_pic 0 0 3
97				 0xc000 0 0 4 &mpc5200_pic 0 0 3>;
98		clock-frequency = <0>; // From boot loader
99		interrupts = <2 8 0 2 9 0 2 10 0>;
100		bus-range = <0 0>;
101		ranges = <0x42000000 0 0x80000000 0x80000000 0 0x10000000>,
102			 <0x02000000 0 0x90000000 0x90000000 0 0x10000000>,
103			 <0x01000000 0 0x00000000 0xa0000000 0 0x01000000>;
104	};
105
106	localbus {
107		ranges = <0 0 0xff000000 0x1000000
108			  4 0 0x60000000 0x0001000>;
109
110		// 16-bit flash device at LocalPlus Bus CS0
111		flash@0,0 {
112			compatible = "cfi-flash";
113			reg = <0 0 0x1000000>;
114			bank-width = <2>;
115			device-width = <2>;
116			#size-cells = <1>;
117			#address-cells = <1>;
118
119			partition@0 {
120				label = "kernel";
121				reg = <0x0 0x00200000>;
122			};
123			partition@200000 {
124				label = "root";
125				reg = <0x00200000 0x00300000>;
126			};
127			partition@500000 {
128				label = "user";
129				reg = <0x00500000 0x00a00000>;
130			};
131			partition@f00000 {
132				label = "u-boot";
133				reg = <0x00f00000 0x100000>;
134			};
135		};
136
137		can@4,0 {
138			compatible = "nxp,sja1000";
139			reg = <4 0x000 0x80>;
140			nxp,external-clock-frequency = <24000000>;
141			interrupts = <1 2 3>; // Level-low
142		};
143
144		can@4,100 {
145			compatible = "nxp,sja1000";
146			reg = <4 0x100 0x80>;
147			nxp,external-clock-frequency = <24000000>;
148			interrupts = <1 2 3>;  // Level-low
149		};
150
151		serial@4,200 {
152			compatible = "nxp,sc28l92";
153			reg = <4 0x200 0x10>;
154			interrupts = <1 3 3>;
155		};
156	};
157};
158