1// SPDX-License-Identifier: GPL-2.0-or-later 2/* 3 * a4m072 board Device Tree Source 4 * 5 * Copyright (C) 2011 DENX Software Engineering GmbH 6 * Heiko Schocher <hs@denx.de> 7 * 8 * Copyright (C) 2007 Semihalf 9 * Marian Balakowicz <m8@semihalf.com> 10 */ 11 12/include/ "mpc5200b.dtsi" 13 14&gpt0 { fsl,has-wdt; }; 15&gpt3 { gpio-controller; }; 16&gpt4 { gpio-controller; }; 17&gpt5 { gpio-controller; }; 18 19/ { 20 model = "anonymous,a4m072"; 21 compatible = "anonymous,a4m072"; 22 23 soc5200@f0000000 { 24 #address-cells = <1>; 25 #size-cells = <1>; 26 compatible = "fsl,mpc5200b-immr"; 27 ranges = <0 0xf0000000 0x0000c000>; 28 reg = <0xf0000000 0x00000100>; 29 bus-frequency = <0>; /* From boot loader */ 30 system-frequency = <0>; /* From boot loader */ 31 32 cdm@200 { 33 fsl,init-ext-48mhz-en = <0x0>; 34 fsl,init-fd-enable = <0x01>; 35 fsl,init-fd-counters = <0x3333>; 36 }; 37 38 spi@f00 { 39 status = "disabled"; 40 }; 41 42 psc@2000 { 43 compatible = "fsl,mpc5200b-psc-uart","fsl,mpc5200-psc-uart"; 44 reg = <0x2000 0x100>; 45 interrupts = <2 1 0>; 46 }; 47 48 psc@2200 { 49 compatible = "fsl,mpc5200b-psc-uart","fsl,mpc5200-psc-uart"; 50 reg = <0x2200 0x100>; 51 interrupts = <2 2 0>; 52 }; 53 54 psc@2400 { 55 compatible = "fsl,mpc5200b-psc-uart","fsl,mpc5200-psc-uart"; 56 reg = <0x2400 0x100>; 57 interrupts = <2 3 0>; 58 }; 59 60 psc@2600 { 61 status = "disabled"; 62 }; 63 64 psc@2800 { 65 status = "disabled"; 66 }; 67 68 psc@2c00 { 69 compatible = "fsl,mpc5200b-psc-uart","fsl,mpc5200-psc-uart"; 70 reg = <0x2c00 0x100>; 71 interrupts = <2 4 0>; 72 }; 73 74 ethernet@3000 { 75 phy-handle = <&phy0>; 76 }; 77 78 mdio@3000 { 79 phy0: ethernet-phy@1f { 80 reg = <0x1f>; 81 interrupts = <1 2 0>; /* IRQ 2 active low */ 82 }; 83 }; 84 85 i2c@3d00 { 86 status = "disabled"; 87 }; 88 89 i2c@3d40 { 90 hwmon@2e { 91 compatible = "nsc,lm87"; 92 reg = <0x2e>; 93 }; 94 rtc@51 { 95 compatible = "nxp,rtc8564"; 96 reg = <0x51>; 97 }; 98 }; 99 }; 100 101 localbus { 102 compatible = "fsl,mpc5200b-lpb","simple-bus"; 103 #address-cells = <2>; 104 #size-cells = <1>; 105 ranges = <0 0 0xfe000000 0x02000000 106 1 0 0x62000000 0x00400000 107 2 0 0x64000000 0x00200000 108 3 0 0x66000000 0x01000000 109 6 0 0x68000000 0x01000000 110 7 0 0x6a000000 0x00000004>; 111 112 flash@0,0 { 113 compatible = "cfi-flash"; 114 reg = <0 0 0x02000000>; 115 bank-width = <2>; 116 #size-cells = <1>; 117 #address-cells = <1>; 118 }; 119 sram0@1,0 { 120 compatible = "mtd-ram"; 121 reg = <1 0x00000 0x00400000>; 122 bank-width = <2>; 123 }; 124 }; 125 126 pci@f0000d00 { 127 #interrupt-cells = <1>; 128 #size-cells = <2>; 129 #address-cells = <3>; 130 device_type = "pci"; 131 compatible = "fsl,mpc5200-pci"; 132 reg = <0xf0000d00 0x100>; 133 interrupt-map-mask = <0xf800 0 0 7>; 134 interrupt-map = < 135 /* IDSEL 0x16 */ 136 0xc000 0 0 1 &mpc5200_pic 1 3 3 137 0xc000 0 0 2 &mpc5200_pic 1 3 3 138 0xc000 0 0 3 &mpc5200_pic 1 3 3 139 0xc000 0 0 4 &mpc5200_pic 1 3 3>; 140 clock-frequency = <0>; /* From boot loader */ 141 interrupts = <2 8 0 2 9 0 2 10 0>; 142 bus-range = <0 0>; 143 ranges = <0x42000000 0 0x80000000 0x80000000 0 0x10000000>, 144 <0x02000000 0 0x90000000 0x90000000 0 0x10000000>, 145 <0x01000000 0 0x00000000 0xa0000000 0 0x01000000>; 146 }; 147}; 148