1if MIPS_GENERIC 2 3config LEGACY_BOARDS 4 bool 5 help 6 Select this from your board if the board must use a legacy, non-UHI, 7 boot protocol. This will cause the kernel to scan through the list of 8 supported machines calling their detect functions in turn if the 9 kernel is booted without being provided with an FDT via the UHI 10 boot protocol. 11 12config YAMON_DT_SHIM 13 bool 14 help 15 Select this from your board if the board uses the YAMON bootloader 16 and you wish to include code which helps translate various 17 YAMON-provided environment variables into a device tree properties. 18 19comment "Legacy (non-UHI/non-FIT) Boards" 20 21config LEGACY_BOARD_SEAD3 22 bool "Support MIPS SEAD-3 boards" 23 select LEGACY_BOARDS 24 select YAMON_DT_SHIM 25 help 26 Enable this to include support for booting on MIPS SEAD-3 FPGA-based 27 development boards, which boot using a legacy boot protocol. 28 29comment "FIT/UHI Boards" 30 31config FIT_IMAGE_FDT_BOSTON 32 bool "Include FDT for MIPS Boston boards" 33 help 34 Enable this to include the FDT for the MIPS Boston development board 35 from Imagination Technologies in the FIT kernel image. You should 36 enable this if you wish to boot on a MIPS Boston board, as it is 37 expected by the bootloader. 38 39config FIT_IMAGE_FDT_NI169445 40 bool "Include FDT for NI 169445" 41 help 42 Enable this to include the FDT for the 169445 platform from 43 National Instruments in the FIT kernel image. 44 45endif 46