1// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
2/*
3 * Google Lazor board device tree source
4 *
5 * Copyright 2020 Google LLC.
6 */
7
8#include "sc7180.dtsi"
9
10ap_ec_spi: &spi6 {};
11ap_h1_spi: &spi0 {};
12
13#include "sc7180-trogdor.dtsi"
14
15&ap_sar_sensor {
16	semtech,cs0-ground;
17	semtech,combined-sensors = <3>;
18	semtech,resolution = "fine";
19	semtech,startup-sensor = <0>;
20	semtech,proxraw-strength = <8>;
21	semtech,avg-pos-strength = <64>;
22};
23
24/*
25 * Lazor is stuffed with a 47k NTC as charger thermistor which currently is
26 * not supported by the PM6150 ADC driver. Disable the charger thermal zone
27 * to avoid using bogus temperature values.
28 */
29&charger_thermal {
30	status = "disabled";
31};
32
33ap_ts_pen_1v8: &i2c4 {
34	status = "okay";
35	clock-frequency = <400000>;
36
37	ap_ts: touchscreen@10 {
38		compatible = "hid-over-i2c";
39		reg = <0x10>;
40		pinctrl-names = "default";
41		pinctrl-0 = <&ts_int_l>, <&ts_reset_l>;
42
43		interrupt-parent = <&tlmm>;
44		interrupts = <9 IRQ_TYPE_LEVEL_LOW>;
45
46		post-power-on-delay-ms = <20>;
47		hid-descr-addr = <0x0001>;
48
49		vdd-supply = <&pp3300_ts>;
50	};
51};
52
53&panel {
54	compatible = "boe,nv133fhm-n62";
55};
56
57&trackpad {
58	interrupts = <58 IRQ_TYPE_EDGE_FALLING>;
59};
60
61&wifi {
62	qcom,ath10k-calibration-variant = "GO_LAZOR";
63};
64
65/* PINCTRL - modifications to sc7180-trogdor.dtsi */
66
67&trackpad_int_1v8_odl {
68	pinmux {
69		pins = "gpio58";
70	};
71
72	pinconf {
73		pins = "gpio58";
74	};
75};
76
77&ts_reset_l {
78	pinconf {
79		/* This pin is not connected on -rev0, pull up to park. */
80		/delete-property/bias-disable;
81		bias-pull-up;
82	};
83};
84
85/* PINCTRL - board-specific pinctrl */
86
87&tlmm {
88	gpio-line-names = "ESIM_MISO",
89			  "ESIM_MOSI",
90			  "ESIM_CLK",
91			  "ESIM_CS_L",
92			  "",
93			  "",
94			  "AP_TP_I2C_SDA",
95			  "AP_TP_I2C_SCL",
96			  "TS_RESET_L",
97			  "TS_INT_L",
98			  "",
99			  "EDP_BRIJ_IRQ",
100			  "AP_EDP_BKLTEN",
101			  "AP_RAM_ID2",
102			  "",
103			  "EDP_BRIJ_I2C_SDA",
104			  "EDP_BRIJ_I2C_SCL",
105			  "HUB_RST_L",
106			  "",
107			  "AP_RAM_ID1",
108			  "AP_SKU_ID2",
109			  "",
110			  "",
111			  "AMP_EN",
112			  "P_SENSOR_INT_L",
113			  "AP_SAR_SENSOR_SDA",
114			  "AP_SAR_SENSOR_SCL",
115			  "",
116			  "HP_IRQ",
117			  "AP_RAM_ID0",
118			  "EN_PP3300_DX_EDP",
119			  "AP_BRD_ID2",
120			  "BRIJ_SUSPEND",
121			  "AP_BRD_ID0",
122			  "AP_H1_SPI_MISO",
123			  "AP_H1_SPI_MOSI",
124			  "AP_H1_SPI_CLK",
125			  "AP_H1_SPI_CS_L",
126			  "",
127			  "",
128			  "",
129			  "",
130			  "H1_AP_INT_ODL",
131			  "",
132			  "UART_AP_TX_DBG_RX",
133			  "UART_DBG_TX_AP_RX",
134			  "HP_I2C_SDA",
135			  "HP_I2C_SCL",
136			  "FORCED_USB_BOOT",
137			  "",
138			  "",
139			  "AMP_DIN",
140			  "",
141			  "HP_BCLK",
142			  "HP_LRCLK",
143			  "HP_DOUT",
144			  "HP_DIN",
145			  "HP_MCLK",
146			  "TRACKPAD_INT_1V8_ODL",
147			  "AP_EC_SPI_MISO",
148			  "AP_EC_SPI_MOSI",
149			  "AP_EC_SPI_CLK",
150			  "AP_EC_SPI_CS_L",
151			  "AP_SPI_CLK",
152			  "AP_SPI_MOSI",
153			  "AP_SPI_MISO",
154			  /*
155			   * AP_FLASH_WP_L is crossystem ABI. Schematics
156			   * call it BIOS_FLASH_WP_L.
157			   */
158			  "AP_FLASH_WP_L",
159			  "DBG_SPI_HOLD_L",
160			  "AP_SPI_CS0_L",
161			  "",
162			  "",
163			  "",
164			  "",
165			  "",
166			  "",
167			  "UIM2_DATA",
168			  "UIM2_CLK",
169			  "UIM2_RST",
170			  "UIM2_PRESENT",
171			  "UIM1_DATA",
172			  "UIM1_CLK",
173			  "UIM1_RST",
174			  "",
175			  "EN_PP3300_CODEC",
176			  "EN_PP3300_HUB",
177			  "",
178			  "",
179			  "",
180			  "",
181			  "",
182			  "AP_SKU_ID1",
183			  "AP_RST_REQ",
184			  "",
185			  "AP_BRD_ID1",
186			  "AP_EC_INT_L",
187			  "",
188			  "",
189			  "",
190			  "",
191			  "",
192			  "",
193			  "",
194			  "",
195			  "",
196			  "EDP_BRIJ_EN",
197			  "AP_SKU_ID0",
198			  "",
199			  "",
200			  "",
201			  "",
202			  "",
203			  "",
204			  "",
205			  "",
206			  "",
207			  "AP_TS_PEN_I2C_SDA",
208			  "AP_TS_PEN_I2C_SCL",
209			  "DP_HOT_PLUG_DET",
210			  "EC_IN_RW_ODL";
211};
212