1// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
2/*
3 * Google Lazor board device tree source
4 *
5 * Copyright 2020 Google LLC.
6 */
7
8#include "sc7180-trogdor.dtsi"
9
10&ap_sar_sensor {
11	semtech,cs0-ground;
12	semtech,combined-sensors = <3>;
13	semtech,resolution = "fine";
14	semtech,startup-sensor = <0>;
15	semtech,proxraw-strength = <8>;
16	semtech,avg-pos-strength = <64>;
17};
18
19&ap_tp_i2c {
20	status = "okay";
21};
22
23/*
24 * Lazor is stuffed with a 47k NTC as charger thermistor which currently is
25 * not supported by the PM6150 ADC driver. Disable the charger thermal zone
26 * to avoid using bogus temperature values.
27 */
28&charger_thermal {
29	status = "disabled";
30};
31
32ap_ts_pen_1v8: &i2c4 {
33	status = "okay";
34	clock-frequency = <400000>;
35
36	ap_ts: touchscreen@10 {
37		compatible = "hid-over-i2c";
38		reg = <0x10>;
39		pinctrl-names = "default";
40		pinctrl-0 = <&ts_int_l>, <&ts_reset_l>;
41
42		interrupt-parent = <&tlmm>;
43		interrupts = <9 IRQ_TYPE_LEVEL_LOW>;
44
45		post-power-on-delay-ms = <20>;
46		hid-descr-addr = <0x0001>;
47
48		vdd-supply = <&pp3300_ts>;
49	};
50};
51
52&panel {
53	compatible = "boe,nv133fhm-n62";
54};
55
56&pm6150_adc {
57	status = "disabled";
58
59	/delete-node/ charger-thermistor@4f;
60};
61
62&pm6150_adc_tm {
63	status = "disabled";
64
65	/delete-node/ charger-thermistor@0;
66};
67
68&trackpad {
69	interrupts = <58 IRQ_TYPE_EDGE_FALLING>;
70};
71
72&wifi {
73	qcom,ath10k-calibration-variant = "GO_LAZOR";
74};
75
76/* PINCTRL - modifications to sc7180-trogdor.dtsi */
77
78&trackpad_int_1v8_odl {
79	pinmux {
80		pins = "gpio58";
81	};
82
83	pinconf {
84		pins = "gpio58";
85	};
86};
87
88&ts_reset_l {
89	pinconf {
90		/* This pin is not connected on -rev0, pull up to park. */
91		/delete-property/bias-disable;
92		bias-pull-up;
93	};
94};
95
96/* PINCTRL - board-specific pinctrl */
97
98&tlmm {
99	gpio-line-names = "ESIM_MISO",
100			  "ESIM_MOSI",
101			  "ESIM_CLK",
102			  "ESIM_CS_L",
103			  "",
104			  "",
105			  "AP_TP_I2C_SDA",
106			  "AP_TP_I2C_SCL",
107			  "TS_RESET_L",
108			  "TS_INT_L",
109			  "",
110			  "EDP_BRIJ_IRQ",
111			  "AP_EDP_BKLTEN",
112			  "AP_RAM_ID2",
113			  "",
114			  "EDP_BRIJ_I2C_SDA",
115			  "EDP_BRIJ_I2C_SCL",
116			  "HUB_RST_L",
117			  "",
118			  "AP_RAM_ID1",
119			  "AP_SKU_ID2",
120			  "",
121			  "",
122			  "AMP_EN",
123			  "P_SENSOR_INT_L",
124			  "AP_SAR_SENSOR_SDA",
125			  "AP_SAR_SENSOR_SCL",
126			  "",
127			  "HP_IRQ",
128			  "AP_RAM_ID0",
129			  "EN_PP3300_DX_EDP",
130			  "AP_BRD_ID2",
131			  "BRIJ_SUSPEND",
132			  "AP_BRD_ID0",
133			  "AP_H1_SPI_MISO",
134			  "AP_H1_SPI_MOSI",
135			  "AP_H1_SPI_CLK",
136			  "AP_H1_SPI_CS_L",
137			  "",
138			  "",
139			  "",
140			  "",
141			  "H1_AP_INT_ODL",
142			  "",
143			  "UART_AP_TX_DBG_RX",
144			  "UART_DBG_TX_AP_RX",
145			  "HP_I2C_SDA",
146			  "HP_I2C_SCL",
147			  "FORCED_USB_BOOT",
148			  "",
149			  "",
150			  "AMP_DIN",
151			  "",
152			  "HP_BCLK",
153			  "HP_LRCLK",
154			  "HP_DOUT",
155			  "HP_DIN",
156			  "HP_MCLK",
157			  "TRACKPAD_INT_1V8_ODL",
158			  "AP_EC_SPI_MISO",
159			  "AP_EC_SPI_MOSI",
160			  "AP_EC_SPI_CLK",
161			  "AP_EC_SPI_CS_L",
162			  "AP_SPI_CLK",
163			  "AP_SPI_MOSI",
164			  "AP_SPI_MISO",
165			  /*
166			   * AP_FLASH_WP_L is crossystem ABI. Schematics
167			   * call it BIOS_FLASH_WP_L.
168			   */
169			  "AP_FLASH_WP_L",
170			  "DBG_SPI_HOLD_L",
171			  "AP_SPI_CS0_L",
172			  "",
173			  "",
174			  "",
175			  "",
176			  "",
177			  "",
178			  "UIM2_DATA",
179			  "UIM2_CLK",
180			  "UIM2_RST",
181			  "UIM2_PRESENT",
182			  "UIM1_DATA",
183			  "UIM1_CLK",
184			  "UIM1_RST",
185			  "",
186			  "EN_PP3300_CODEC",
187			  "EN_PP3300_HUB",
188			  "",
189			  "",
190			  "",
191			  "",
192			  "",
193			  "AP_SKU_ID1",
194			  "AP_RST_REQ",
195			  "",
196			  "AP_BRD_ID1",
197			  "AP_EC_INT_L",
198			  "",
199			  "",
200			  "",
201			  "",
202			  "",
203			  "",
204			  "",
205			  "",
206			  "",
207			  "EDP_BRIJ_EN",
208			  "AP_SKU_ID0",
209			  "",
210			  "",
211			  "",
212			  "",
213			  "",
214			  "",
215			  "",
216			  "",
217			  "",
218			  "AP_TS_PEN_I2C_SDA",
219			  "AP_TS_PEN_I2C_SCL",
220			  "DP_HOT_PLUG_DET",
221			  "EC_IN_RW_ODL";
222};
223