1// SPDX-License-Identifier: GPL-2.0 2// Copyright (c) 2018, Linaro Limited 3 4#include <dt-bindings/spmi/spmi.h> 5#include <dt-bindings/input/linux-event-codes.h> 6#include <dt-bindings/iio/qcom,spmi-vadc.h> 7#include <dt-bindings/thermal/thermal.h> 8 9/ { 10 thermal-zones { 11 pms405 { 12 polling-delay-passive = <250>; 13 polling-delay = <1000>; 14 15 thermal-sensors = <&pms405_temp>; 16 17 trips { 18 pms405_alert0: pms405-alert0 { 19 temperature = <105000>; 20 hysteresis = <2000>; 21 type = "passive"; 22 }; 23 pms405_crit: pms405-crit { 24 temperature = <125000>; 25 hysteresis = <2000>; 26 type = "critical"; 27 }; 28 }; 29 }; 30 }; 31}; 32 33&spmi_bus { 34 pms405_0: pms405@0 { 35 compatible = "qcom,spmi-pmic"; 36 reg = <0x0 SPMI_USID>; 37 #address-cells = <1>; 38 #size-cells = <0>; 39 40 pms405_gpios: gpio@c000 { 41 compatible = "qcom,pms405-gpio"; 42 reg = <0xc000>; 43 gpio-controller; 44 #gpio-cells = <2>; 45 interrupts = <0 0xc0 0 IRQ_TYPE_NONE>, 46 <0 0xc1 0 IRQ_TYPE_NONE>, 47 <0 0xc2 0 IRQ_TYPE_NONE>, 48 <0 0xc3 0 IRQ_TYPE_NONE>, 49 <0 0xc4 0 IRQ_TYPE_NONE>, 50 <0 0xc5 0 IRQ_TYPE_NONE>, 51 <0 0xc6 0 IRQ_TYPE_NONE>, 52 <0 0xc7 0 IRQ_TYPE_NONE>, 53 <0 0xc8 0 IRQ_TYPE_NONE>, 54 <0 0xc9 0 IRQ_TYPE_NONE>, 55 <0 0xca 0 IRQ_TYPE_NONE>, 56 <0 0xcb 0 IRQ_TYPE_NONE>; 57 }; 58 59 pon@800 { 60 compatible = "qcom,pms405-pon"; 61 reg = <0x0800>; 62 mode-bootloader = <0x2>; 63 mode-recovery = <0x1>; 64 65 pwrkey { 66 compatible = "qcom,pm8941-pwrkey"; 67 interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>; 68 debounce = <15625>; 69 bias-pull-up; 70 linux,code = <KEY_POWER>; 71 }; 72 }; 73 74 pms405_temp: temp-alarm@2400 { 75 compatible = "qcom,spmi-temp-alarm"; 76 reg = <0x2400>; 77 interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>; 78 io-channels = <&pms405_adc ADC5_DIE_TEMP>; 79 io-channel-names = "thermal"; 80 #thermal-sensor-cells = <0>; 81 }; 82 83 pms405_adc: adc@3100 { 84 compatible = "qcom,pms405-adc", "qcom,spmi-adc-rev2"; 85 reg = <0x3100>; 86 interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>; 87 #address-cells = <1>; 88 #size-cells = <0>; 89 #io-channel-cells = <1>; 90 91 ref_gnd@0 { 92 reg = <ADC5_REF_GND>; 93 qcom,pre-scaling = <1 1>; 94 }; 95 96 vref_1p25@1 { 97 reg = <ADC5_1P25VREF>; 98 qcom,pre-scaling = <1 1>; 99 }; 100 101 pon_1: vph_pwr@131 { 102 reg = <ADC5_VPH_PWR>; 103 qcom,pre-scaling = <1 3>; 104 }; 105 106 die_temp@6 { 107 reg = <ADC5_DIE_TEMP>; 108 qcom,pre-scaling = <1 1>; 109 }; 110 111 pa_therm1: thermistor1@77 { 112 reg = <ADC5_AMUX_THM1_100K_PU>; 113 qcom,ratiometric; 114 qcom,hw-settle-time = <200>; 115 qcom,pre-scaling = <1 1>; 116 }; 117 118 pa_therm3: thermistor3@79 { 119 reg = <ADC5_AMUX_THM3_100K_PU>; 120 qcom,ratiometric; 121 qcom,hw-settle-time = <200>; 122 qcom,pre-scaling = <1 1>; 123 }; 124 125 xo_therm: xo_temp@76 { 126 reg = <ADC5_XO_THERM_100K_PU>; 127 qcom,ratiometric; 128 qcom,hw-settle-time = <200>; 129 qcom,pre-scaling = <1 1>; 130 }; 131 }; 132 133 rtc@6000 { 134 compatible = "qcom,pm8941-rtc"; 135 reg = <0x6000>; 136 reg-names = "rtc", "alarm"; 137 interrupts = <0x0 0x61 0x1 IRQ_TYPE_NONE>; 138 }; 139 }; 140 141 pms405_1: pms405@1 { 142 compatible = "qcom,spmi-pmic"; 143 reg = <0x1 SPMI_USID>; 144 145 pms405_spmi_regulators: regulators { 146 compatible = "qcom,pms405-regulators"; 147 }; 148 }; 149}; 150