1# 2# Kconfig for uClinux(non-paged MM) depend configurations 3# Hyok S. Choi <hyok.choi@samsung.com> 4# 5 6config SET_MEM_PARAM 7 bool "Set flash/sdram size and base addr" 8 help 9 Say Y to manually set the base addresses and sizes. 10 otherwise, the default values are assigned. 11 12config DRAM_BASE 13 hex '(S)DRAM Base Address' if SET_MEM_PARAM 14 default 0x00800000 15 16config DRAM_SIZE 17 hex '(S)DRAM SIZE' if SET_MEM_PARAM 18 default 0x00800000 19 20config FLASH_MEM_BASE 21 hex 'FLASH Base Address' if SET_MEM_PARAM 22 default 0x00400000 23 24config FLASH_SIZE 25 hex 'FLASH Size' if SET_MEM_PARAM 26 default 0x00400000 27 28config PROCESSOR_ID 29 hex 'Hard wire the processor ID' 30 default 0x00007700 31 depends on !(CPU_CP15 || CPU_V7M) 32 help 33 If processor has no CP15 register, this processor ID is 34 used instead of the auto-probing which utilizes the register. 35 36config REMAP_VECTORS_TO_RAM 37 bool 'Install vectors to the beginning of RAM' 38 help 39 The kernel needs to change the hardware exception vectors. 40 In nommu mode, the hardware exception vectors are normally 41 placed at address 0x00000000. However, this region may be 42 occupied by read-only memory depending on H/W design. 43 44 If the region contains read-write memory, say 'n' here. 45 46 If your CPU provides a remap facility which allows the exception 47 vectors to be mapped to writable memory, say 'n' here. 48 49 Otherwise, say 'y' here. In this case, the kernel will require 50 external support to redirect the hardware exception vectors to 51 the writable versions located at DRAM_BASE. 52 53config ARM_MPU 54 bool 'Use the ARM v7 PMSA Compliant MPU' 55 depends on CPU_V7 56 default y 57 help 58 Some ARM systems without an MMU have instead a Memory Protection 59 Unit (MPU) that defines the type and permissions for regions of 60 memory. 61 62 If your CPU has an MPU then you should choose 'y' here unless you 63 know that you do not want to use the MPU. 64