xref: /openbmc/linux/arch/arc/mm/init.c (revision babbdf5b)
1 // SPDX-License-Identifier: GPL-2.0-only
2 /*
3  * Copyright (C) 2004, 2007-2010, 2011-2012 Synopsys, Inc. (www.synopsys.com)
4  */
5 
6 #include <linux/kernel.h>
7 #include <linux/mm.h>
8 #include <linux/memblock.h>
9 #ifdef CONFIG_BLK_DEV_INITRD
10 #include <linux/initrd.h>
11 #endif
12 #include <linux/of_fdt.h>
13 #include <linux/swap.h>
14 #include <linux/module.h>
15 #include <linux/highmem.h>
16 #include <asm/page.h>
17 #include <asm/sections.h>
18 #include <asm/arcregs.h>
19 
20 pgd_t swapper_pg_dir[PTRS_PER_PGD] __aligned(PAGE_SIZE);
21 char empty_zero_page[PAGE_SIZE] __aligned(PAGE_SIZE);
22 EXPORT_SYMBOL(empty_zero_page);
23 
24 static const unsigned long low_mem_start = CONFIG_LINUX_RAM_BASE;
25 static unsigned long low_mem_sz;
26 
27 #ifdef CONFIG_HIGHMEM
28 static unsigned long min_high_pfn, max_high_pfn;
29 static phys_addr_t high_mem_start;
30 static phys_addr_t high_mem_sz;
31 unsigned long arch_pfn_offset;
32 EXPORT_SYMBOL(arch_pfn_offset);
33 #endif
34 
35 #ifdef CONFIG_DISCONTIGMEM
36 struct pglist_data node_data[MAX_NUMNODES] __read_mostly;
37 EXPORT_SYMBOL(node_data);
38 #endif
39 
40 long __init arc_get_mem_sz(void)
41 {
42 	return low_mem_sz;
43 }
44 
45 /* User can over-ride above with "mem=nnn[KkMm]" in cmdline */
46 static int __init setup_mem_sz(char *str)
47 {
48 	low_mem_sz = memparse(str, NULL) & PAGE_MASK;
49 
50 	/* early console might not be setup yet - it will show up later */
51 	pr_info("\"mem=%s\": mem sz set to %ldM\n", str, TO_MB(low_mem_sz));
52 
53 	return 0;
54 }
55 early_param("mem", setup_mem_sz);
56 
57 void __init early_init_dt_add_memory_arch(u64 base, u64 size)
58 {
59 	int in_use = 0;
60 
61 	if (!low_mem_sz) {
62 		if (base != low_mem_start)
63 			panic("CONFIG_LINUX_RAM_BASE != DT memory { }");
64 
65 		low_mem_sz = size;
66 		in_use = 1;
67 		memblock_add_node(base, size, 0);
68 	} else {
69 #ifdef CONFIG_HIGHMEM
70 		high_mem_start = base;
71 		high_mem_sz = size;
72 		in_use = 1;
73 		memblock_add_node(base, size, 1);
74 		memblock_reserve(base, size);
75 #endif
76 	}
77 
78 	pr_info("Memory @ %llx [%lldM] %s\n",
79 		base, TO_MB(size), !in_use ? "Not used":"");
80 }
81 
82 bool arch_has_descending_max_zone_pfns(void)
83 {
84 	return !IS_ENABLED(CONFIG_ARC_HAS_PAE40);
85 }
86 
87 /*
88  * First memory setup routine called from setup_arch()
89  * 1. setup swapper's mm @init_mm
90  * 2. Count the pages we have and setup bootmem allocator
91  * 3. zone setup
92  */
93 void __init setup_arch_memory(void)
94 {
95 	unsigned long max_zone_pfn[MAX_NR_ZONES] = { 0 };
96 
97 	init_mm.start_code = (unsigned long)_text;
98 	init_mm.end_code = (unsigned long)_etext;
99 	init_mm.end_data = (unsigned long)_edata;
100 	init_mm.brk = (unsigned long)_end;
101 
102 	/* first page of system - kernel .vector starts here */
103 	min_low_pfn = virt_to_pfn(CONFIG_LINUX_RAM_BASE);
104 
105 	/* Last usable page of low mem */
106 	max_low_pfn = max_pfn = PFN_DOWN(low_mem_start + low_mem_sz);
107 
108 	/*------------- bootmem allocator setup -----------------------*/
109 
110 	/*
111 	 * seed the bootmem allocator after any DT memory node parsing or
112 	 * "mem=xxx" cmdline overrides have potentially updated @arc_mem_sz
113 	 *
114 	 * Only low mem is added, otherwise we have crashes when allocating
115 	 * mem_map[] itself. NO_BOOTMEM allocates mem_map[] at the end of
116 	 * avail memory, ending in highmem with a > 32-bit address. However
117 	 * it then tries to memset it with a truncaed 32-bit handle, causing
118 	 * the crash
119 	 */
120 
121 	memblock_reserve(CONFIG_LINUX_LINK_BASE,
122 			 __pa(_end) - CONFIG_LINUX_LINK_BASE);
123 
124 #ifdef CONFIG_BLK_DEV_INITRD
125 	if (phys_initrd_size) {
126 		memblock_reserve(phys_initrd_start, phys_initrd_size);
127 		initrd_start = (unsigned long)__va(phys_initrd_start);
128 		initrd_end = initrd_start + phys_initrd_size;
129 	}
130 #endif
131 
132 	early_init_fdt_reserve_self();
133 	early_init_fdt_scan_reserved_mem();
134 
135 	memblock_dump_all();
136 
137 	/*----------------- node/zones setup --------------------------*/
138 	max_zone_pfn[ZONE_NORMAL] = max_low_pfn;
139 
140 #ifdef CONFIG_HIGHMEM
141 	/*
142 	 * Populate a new node with highmem
143 	 *
144 	 * On ARC (w/o PAE) HIGHMEM addresses are actually smaller (0 based)
145 	 * than addresses in normal ala low memory (0x8000_0000 based).
146 	 * Even with PAE, the huge peripheral space hole would waste a lot of
147 	 * mem with single mem_map[]. This warrants a mem_map per region design.
148 	 * Thus HIGHMEM on ARC is imlemented with DISCONTIGMEM.
149 	 *
150 	 * DISCONTIGMEM in turns requires multiple nodes. node 0 above is
151 	 * populated with normal memory zone while node 1 only has highmem
152 	 */
153 #ifdef CONFIG_DISCONTIGMEM
154 	node_set_online(1);
155 #endif
156 
157 	min_high_pfn = PFN_DOWN(high_mem_start);
158 	max_high_pfn = PFN_DOWN(high_mem_start + high_mem_sz);
159 
160 	/*
161 	 * max_high_pfn should be ok here for both HIGHMEM and HIGHMEM+PAE.
162 	 * For HIGHMEM without PAE max_high_pfn should be less than
163 	 * min_low_pfn to guarantee that these two regions don't overlap.
164 	 * For PAE case highmem is greater than lowmem, so it is natural
165 	 * to use max_high_pfn.
166 	 *
167 	 * In both cases, holes should be handled by pfn_valid().
168 	 */
169 	max_zone_pfn[ZONE_HIGHMEM] = max_high_pfn;
170 
171 	high_memory = (void *)(min_high_pfn << PAGE_SHIFT);
172 
173 	arch_pfn_offset = min(min_low_pfn, min_high_pfn);
174 	kmap_init();
175 
176 #else /* CONFIG_HIGHMEM */
177 	/* pfn_valid() uses this when FLATMEM=y and HIGHMEM=n */
178 	max_mapnr = max_low_pfn - min_low_pfn;
179 
180 #endif /* CONFIG_HIGHMEM */
181 
182 	free_area_init(max_zone_pfn);
183 }
184 
185 static void __init highmem_init(void)
186 {
187 #ifdef CONFIG_HIGHMEM
188 	unsigned long tmp;
189 
190 	memblock_free(high_mem_start, high_mem_sz);
191 	for (tmp = min_high_pfn; tmp < max_high_pfn; tmp++)
192 		free_highmem_page(pfn_to_page(tmp));
193 #endif
194 }
195 
196 /*
197  * mem_init - initializes memory
198  *
199  * Frees up bootmem
200  * Calculates and displays memory available/used
201  */
202 void __init mem_init(void)
203 {
204 	memblock_free_all();
205 	highmem_init();
206 }
207 
208 #ifdef CONFIG_HIGHMEM
209 int pfn_valid(unsigned long pfn)
210 {
211 	return (pfn >= min_high_pfn && pfn <= max_high_pfn) ||
212 		(pfn >= min_low_pfn && pfn <= max_low_pfn);
213 }
214 EXPORT_SYMBOL(pfn_valid);
215 #endif
216