xref: /openbmc/linux/arch/alpha/kernel/sys_ruffian.c (revision 12eb4683)
1 /*
2  *	linux/arch/alpha/kernel/sys_ruffian.c
3  *
4  *	Copyright (C) 1995 David A Rusling
5  *	Copyright (C) 1996 Jay A Estabrook
6  *	Copyright (C) 1998, 1999, 2000 Richard Henderson
7  *
8  * Code supporting the RUFFIAN.
9  */
10 
11 #include <linux/kernel.h>
12 #include <linux/types.h>
13 #include <linux/mm.h>
14 #include <linux/sched.h>
15 #include <linux/pci.h>
16 #include <linux/ioport.h>
17 #include <linux/timex.h>
18 #include <linux/init.h>
19 
20 #include <asm/ptrace.h>
21 #include <asm/dma.h>
22 #include <asm/irq.h>
23 #include <asm/mmu_context.h>
24 #include <asm/io.h>
25 #include <asm/pgtable.h>
26 #include <asm/core_cia.h>
27 #include <asm/tlbflush.h>
28 
29 #include "proto.h"
30 #include "irq_impl.h"
31 #include "pci_impl.h"
32 #include "machvec_impl.h"
33 
34 
35 static void __init
36 ruffian_init_irq(void)
37 {
38 	/* Invert 6&7 for i82371 */
39 	*(vulp)PYXIS_INT_HILO  = 0x000000c0UL; mb();
40 	*(vulp)PYXIS_INT_CNFG  = 0x00002064UL; mb();	 /* all clear */
41 
42 	outb(0x11,0xA0);
43 	outb(0x08,0xA1);
44 	outb(0x02,0xA1);
45 	outb(0x01,0xA1);
46 	outb(0xFF,0xA1);
47 
48 	outb(0x11,0x20);
49 	outb(0x00,0x21);
50 	outb(0x04,0x21);
51 	outb(0x01,0x21);
52 	outb(0xFF,0x21);
53 
54 	/* Finish writing the 82C59A PIC Operation Control Words */
55 	outb(0x20,0xA0);
56 	outb(0x20,0x20);
57 
58 	init_i8259a_irqs();
59 
60 	/* Not interested in the bogus interrupts (0,3,6),
61 	   NMI (1), HALT (2), flash (5), or 21142 (8).  */
62 	init_pyxis_irqs(0x16f0000);
63 
64 	common_init_isa_dma();
65 }
66 
67 #define RUFFIAN_LATCH	DIV_ROUND_CLOSEST(PIT_TICK_RATE, HZ)
68 
69 static void __init
70 ruffian_init_rtc(void)
71 {
72 	/* Ruffian does not have the RTC connected to the CPU timer
73 	   interrupt.  Instead, it uses the PIT connected to IRQ 0.  */
74 
75 	/* Setup interval timer.  */
76 	outb(0x34, 0x43);		/* binary, mode 2, LSB/MSB, ch 0 */
77 	outb(RUFFIAN_LATCH & 0xff, 0x40);	/* LSB */
78 	outb(RUFFIAN_LATCH >> 8, 0x40);		/* MSB */
79 
80 	outb(0xb6, 0x43);		/* pit counter 2: speaker */
81 	outb(0x31, 0x42);
82 	outb(0x13, 0x42);
83 
84 	setup_irq(0, &timer_irqaction);
85 }
86 
87 static void
88 ruffian_kill_arch (int mode)
89 {
90 	cia_kill_arch(mode);
91 #if 0
92 	/* This only causes re-entry to ARCSBIOS */
93 	/* Perhaps this works for other PYXIS as well?  */
94 	*(vuip) PYXIS_RESET = 0x0000dead;
95 	mb();
96 #endif
97 }
98 
99 /*
100  *  Interrupt routing:
101  *
102  *		Primary bus
103  *	  IdSel		INTA	INTB	INTC	INTD
104  * 21052   13		  -	  -	  -	  -
105  * SIO	   14		 23	  -	  -	  -
106  * 21143   15		 44	  -	  -	  -
107  * Slot 0  17		 43	 42	 41	 40
108  *
109  *		Secondary bus
110  *	  IdSel		INTA	INTB	INTC	INTD
111  * Slot 0   8 (18)	 19	 18	 17	 16
112  * Slot 1   9 (19)	 31	 30	 29	 28
113  * Slot 2  10 (20)	 27	 26	 25	 24
114  * Slot 3  11 (21)	 39	 38	 37	 36
115  * Slot 4  12 (22)	 35	 34	 33	 32
116  * 53c875  13 (23)	 20	  -	  -	  -
117  *
118  */
119 
120 static int __init
121 ruffian_map_irq(const struct pci_dev *dev, u8 slot, u8 pin)
122 {
123         static char irq_tab[11][5] __initdata = {
124 	      /*INT  INTA INTB INTC INTD */
125 		{-1,  -1,  -1,  -1,  -1},  /* IdSel 13,  21052	     */
126 		{-1,  -1,  -1,  -1,  -1},  /* IdSel 14,  SIO	     */
127 		{44,  44,  44,  44,  44},  /* IdSel 15,  21143	     */
128 		{-1,  -1,  -1,  -1,  -1},  /* IdSel 16,  none	     */
129 		{43,  43,  42,  41,  40},  /* IdSel 17,  64-bit slot */
130 		/* the next 6 are actually on PCI bus 1, across the bridge */
131 		{19,  19,  18,  17,  16},  /* IdSel  8,  slot 0	     */
132 		{31,  31,  30,  29,  28},  /* IdSel  9,  slot 1	     */
133 		{27,  27,  26,  25,  24},  /* IdSel 10,  slot 2	     */
134 		{39,  39,  38,  37,  36},  /* IdSel 11,  slot 3	     */
135 		{35,  35,  34,  33,  32},  /* IdSel 12,  slot 4	     */
136 		{20,  20,  20,  20,  20},  /* IdSel 13,  53c875	     */
137         };
138 	const long min_idsel = 13, max_idsel = 23, irqs_per_slot = 5;
139 	return COMMON_TABLE_LOOKUP;
140 }
141 
142 static u8 __init
143 ruffian_swizzle(struct pci_dev *dev, u8 *pinp)
144 {
145 	int slot, pin = *pinp;
146 
147 	if (dev->bus->number == 0) {
148 		slot = PCI_SLOT(dev->devfn);
149 	}
150 	/* Check for the built-in bridge.  */
151 	else if (PCI_SLOT(dev->bus->self->devfn) == 13) {
152 		slot = PCI_SLOT(dev->devfn) + 10;
153 	}
154 	else
155 	{
156 		/* Must be a card-based bridge.  */
157 		do {
158 			if (PCI_SLOT(dev->bus->self->devfn) == 13) {
159 				slot = PCI_SLOT(dev->devfn) + 10;
160 				break;
161 			}
162 			pin = pci_swizzle_interrupt_pin(dev, pin);
163 
164 			/* Move up the chain of bridges.  */
165 			dev = dev->bus->self;
166 			/* Slot of the next bridge.  */
167 			slot = PCI_SLOT(dev->devfn);
168 		} while (dev->bus->self);
169 	}
170 	*pinp = pin;
171 	return slot;
172 }
173 
174 #ifdef BUILDING_FOR_MILO
175 /*
176  * The DeskStation Ruffian motherboard firmware does not place
177  * the memory size in the PALimpure area.  Therefore, we use
178  * the Bank Configuration Registers in PYXIS to obtain the size.
179  */
180 static unsigned long __init
181 ruffian_get_bank_size(unsigned long offset)
182 {
183 	unsigned long bank_addr, bank, ret = 0;
184 
185 	/* Valid offsets are: 0x800, 0x840 and 0x880
186 	   since Ruffian only uses three banks.  */
187 	bank_addr = (unsigned long)PYXIS_MCR + offset;
188 	bank = *(vulp)bank_addr;
189 
190 	/* Check BANK_ENABLE */
191 	if (bank & 0x01) {
192 		static unsigned long size[] __initdata = {
193 			0x40000000UL, /* 0x00,   1G */
194 			0x20000000UL, /* 0x02, 512M */
195 			0x10000000UL, /* 0x04, 256M */
196 			0x08000000UL, /* 0x06, 128M */
197 			0x04000000UL, /* 0x08,  64M */
198 			0x02000000UL, /* 0x0a,  32M */
199 			0x01000000UL, /* 0x0c,  16M */
200 			0x00800000UL, /* 0x0e,   8M */
201 			0x80000000UL, /* 0x10,   2G */
202 		};
203 
204 		bank = (bank & 0x1e) >> 1;
205 		if (bank < ARRAY_SIZE(size))
206 			ret = size[bank];
207 	}
208 
209 	return ret;
210 }
211 #endif /* BUILDING_FOR_MILO */
212 
213 /*
214  * The System Vector
215  */
216 
217 struct alpha_machine_vector ruffian_mv __initmv = {
218 	.vector_name		= "Ruffian",
219 	DO_EV5_MMU,
220 	DO_DEFAULT_RTC,
221 	DO_PYXIS_IO,
222 	.machine_check		= cia_machine_check,
223 	.max_isa_dma_address	= ALPHA_RUFFIAN_MAX_ISA_DMA_ADDRESS,
224 	.min_io_address		= DEFAULT_IO_BASE,
225 	.min_mem_address	= DEFAULT_MEM_BASE,
226 	.pci_dac_offset		= PYXIS_DAC_OFFSET,
227 
228 	.nr_irqs		= 48,
229 	.device_interrupt	= pyxis_device_interrupt,
230 
231 	.init_arch		= pyxis_init_arch,
232 	.init_irq		= ruffian_init_irq,
233 	.init_rtc		= ruffian_init_rtc,
234 	.init_pci		= cia_init_pci,
235 	.kill_arch		= ruffian_kill_arch,
236 	.pci_map_irq		= ruffian_map_irq,
237 	.pci_swizzle		= ruffian_swizzle,
238 };
239 ALIAS_MV(ruffian)
240