xref: /openbmc/linux/Documentation/mm/highmem.rst (revision a347279d)
1====================
2High Memory Handling
3====================
4
5By: Peter Zijlstra <a.p.zijlstra@chello.nl>
6
7.. contents:: :local:
8
9What Is High Memory?
10====================
11
12High memory (highmem) is used when the size of physical memory approaches or
13exceeds the maximum size of virtual memory.  At that point it becomes
14impossible for the kernel to keep all of the available physical memory mapped
15at all times.  This means the kernel needs to start using temporary mappings of
16the pieces of physical memory that it wants to access.
17
18The part of (physical) memory not covered by a permanent mapping is what we
19refer to as 'highmem'.  There are various architecture dependent constraints on
20where exactly that border lies.
21
22In the i386 arch, for example, we choose to map the kernel into every process's
23VM space so that we don't have to pay the full TLB invalidation costs for
24kernel entry/exit.  This means the available virtual memory space (4GiB on
25i386) has to be divided between user and kernel space.
26
27The traditional split for architectures using this approach is 3:1, 3GiB for
28userspace and the top 1GiB for kernel space::
29
30		+--------+ 0xffffffff
31		| Kernel |
32		+--------+ 0xc0000000
33		|        |
34		| User   |
35		|        |
36		+--------+ 0x00000000
37
38This means that the kernel can at most map 1GiB of physical memory at any one
39time, but because we need virtual address space for other things - including
40temporary maps to access the rest of the physical memory - the actual direct
41map will typically be less (usually around ~896MiB).
42
43Other architectures that have mm context tagged TLBs can have separate kernel
44and user maps.  Some hardware (like some ARMs), however, have limited virtual
45space when they use mm context tags.
46
47
48Temporary Virtual Mappings
49==========================
50
51The kernel contains several ways of creating temporary mappings. The following
52list shows them in order of preference of use.
53
54* kmap_local_page().  This function is used to require short term mappings.
55  It can be invoked from any context (including interrupts) but the mappings
56  can only be used in the context which acquired them.
57
58  This function should always be used, whereas kmap_atomic() and kmap() have
59  been deprecated.
60
61  These mappings are thread-local and CPU-local, meaning that the mapping
62  can only be accessed from within this thread and the thread is bound to the
63  CPU while the mapping is active. Although preemption is never disabled by
64  this function, the CPU can not be unplugged from the system via
65  CPU-hotplug until the mapping is disposed.
66
67  It's valid to take pagefaults in a local kmap region, unless the context
68  in which the local mapping is acquired does not allow it for other reasons.
69
70  As said, pagefaults and preemption are never disabled. There is no need to
71  disable preemption because, when context switches to a different task, the
72  maps of the outgoing task are saved and those of the incoming one are
73  restored.
74
75  kmap_local_page() always returns a valid virtual address and it is assumed
76  that kunmap_local() will never fail.
77
78  On CONFIG_HIGHMEM=n kernels and for low memory pages this returns the
79  virtual address of the direct mapping. Only real highmem pages are
80  temporarily mapped. Therefore, users may call a plain page_address()
81  for pages which are known to not come from ZONE_HIGHMEM. However, it is
82  always safe to use kmap_local_page() / kunmap_local().
83
84  While it is significantly faster than kmap(), for the highmem case it
85  comes with restrictions about the pointers validity. Contrary to kmap()
86  mappings, the local mappings are only valid in the context of the caller
87  and cannot be handed to other contexts. This implies that users must
88  be absolutely sure to keep the use of the return address local to the
89  thread which mapped it.
90
91  Most code can be designed to use thread local mappings. User should
92  therefore try to design their code to avoid the use of kmap() by mapping
93  pages in the same thread the address will be used and prefer
94  kmap_local_page().
95
96  Nesting kmap_local_page() and kmap_atomic() mappings is allowed to a certain
97  extent (up to KMAP_TYPE_NR) but their invocations have to be strictly ordered
98  because the map implementation is stack based. See kmap_local_page() kdocs
99  (included in the "Functions" section) for details on how to manage nested
100  mappings.
101
102* kmap_atomic(). This function has been deprecated; use kmap_local_page().
103
104  NOTE: Conversions to kmap_local_page() must take care to follow the mapping
105  restrictions imposed on kmap_local_page(). Furthermore, the code between
106  calls to kmap_atomic() and kunmap_atomic() may implicitly depend on the side
107  effects of atomic mappings, i.e. disabling page faults or preemption, or both.
108  In that case, explicit calls to pagefault_disable() or preempt_disable() or
109  both must be made in conjunction with the use of kmap_local_page().
110
111  [Legacy documentation]
112
113  This permits a very short duration mapping of a single page.  Since the
114  mapping is restricted to the CPU that issued it, it performs well, but
115  the issuing task is therefore required to stay on that CPU until it has
116  finished, lest some other task displace its mappings.
117
118  kmap_atomic() may also be used by interrupt contexts, since it does not
119  sleep and the callers too may not sleep until after kunmap_atomic() is
120  called.
121
122  Each call of kmap_atomic() in the kernel creates a non-preemptible section
123  and disable pagefaults. This could be a source of unwanted latency. Therefore
124  users should prefer kmap_local_page() instead of kmap_atomic().
125
126  It is assumed that k[un]map_atomic() won't fail.
127
128* kmap(). This function has been deprecated; use kmap_local_page().
129
130  NOTE: Conversions to kmap_local_page() must take care to follow the mapping
131  restrictions imposed on kmap_local_page(). In particular, it is necessary to
132  make sure that the kernel virtual memory pointer is only valid in the thread
133  that obtained it.
134
135  [Legacy documentation]
136
137  This should be used to make short duration mapping of a single page with no
138  restrictions on preemption or migration. It comes with an overhead as mapping
139  space is restricted and protected by a global lock for synchronization. When
140  mapping is no longer needed, the address that the page was mapped to must be
141  released with kunmap().
142
143  Mapping changes must be propagated across all the CPUs. kmap() also
144  requires global TLB invalidation when the kmap's pool wraps and it might
145  block when the mapping space is fully utilized until a slot becomes
146  available. Therefore, kmap() is only callable from preemptible context.
147
148  All the above work is necessary if a mapping must last for a relatively
149  long time but the bulk of high-memory mappings in the kernel are
150  short-lived and only used in one place. This means that the cost of
151  kmap() is mostly wasted in such cases. kmap() was not intended for long
152  term mappings but it has morphed in that direction and its use is
153  strongly discouraged in newer code and the set of the preceding functions
154  should be preferred.
155
156  On 64-bit systems, calls to kmap_local_page(), kmap_atomic() and kmap() have
157  no real work to do because a 64-bit address space is more than sufficient to
158  address all the physical memory whose pages are permanently mapped.
159
160* vmap().  This can be used to make a long duration mapping of multiple
161  physical pages into a contiguous virtual space.  It needs global
162  synchronization to unmap.
163
164
165Cost of Temporary Mappings
166==========================
167
168The cost of creating temporary mappings can be quite high.  The arch has to
169manipulate the kernel's page tables, the data TLB and/or the MMU's registers.
170
171If CONFIG_HIGHMEM is not set, then the kernel will try and create a mapping
172simply with a bit of arithmetic that will convert the page struct address into
173a pointer to the page contents rather than juggling mappings about.  In such a
174case, the unmap operation may be a null operation.
175
176If CONFIG_MMU is not set, then there can be no temporary mappings and no
177highmem.  In such a case, the arithmetic approach will also be used.
178
179
180i386 PAE
181========
182
183The i386 arch, under some circumstances, will permit you to stick up to 64GiB
184of RAM into your 32-bit machine.  This has a number of consequences:
185
186* Linux needs a page-frame structure for each page in the system and the
187  pageframes need to live in the permanent mapping, which means:
188
189* you can have 896M/sizeof(struct page) page-frames at most; with struct
190  page being 32-bytes that would end up being something in the order of 112G
191  worth of pages; the kernel, however, needs to store more than just
192  page-frames in that memory...
193
194* PAE makes your page tables larger - which slows the system down as more
195  data has to be accessed to traverse in TLB fills and the like.  One
196  advantage is that PAE has more PTE bits and can provide advanced features
197  like NX and PAT.
198
199The general recommendation is that you don't use more than 8GiB on a 32-bit
200machine - although more might work for you and your workload, you're pretty
201much on your own - don't expect kernel developers to really care much if things
202come apart.
203
204
205Functions
206=========
207
208.. kernel-doc:: include/linux/highmem.h
209.. kernel-doc:: include/linux/highmem-internal.h
210