1Kernel driver shtc1 2=================== 3 4Supported chips: 5 6 * Sensirion SHTC1 7 8 Prefix: 'shtc1' 9 10 Addresses scanned: none 11 12 Datasheet: https://www.sensirion.com/file/datasheet_shtc1 13 14 15 16 * Sensirion SHTW1 17 18 Prefix: 'shtw1' 19 20 Addresses scanned: none 21 22 Datasheet: https://www.sensirion.com/file/datasheet_shtw1 23 24 25 26 * Sensirion SHTC3 27 28 Prefix: 'shtc3' 29 30 Addresses scanned: none 31 32 Datasheet: https://www.sensirion.com/file/datasheet_shtc3 33 34 35 36Author: 37 38 Johannes Winkelmann <johannes.winkelmann@sensirion.com> 39 40Description 41----------- 42 43This driver implements support for the Sensirion SHTC1, SHTW1, and SHTC3 44chips, a humidity and temperature sensor. Temperature is measured in degrees 45celsius, relative humidity is expressed as a percentage. 46 47The device communicates with the I2C protocol. All sensors are set to I2C 48address 0x70. See Documentation/i2c/instantiating-devices.rst for methods to 49instantiate the device. 50 51There are two options configurable by means of shtc1_platform_data: 52 531. blocking (pull the I2C clock line down while performing the measurement) or 54 non-blocking mode. Blocking mode will guarantee the fastest result but 55 the I2C bus will be busy during that time. By default, non-blocking mode 56 is used. Make sure clock-stretching works properly on your device if you 57 want to use blocking mode. 582. high or low accuracy. High accuracy is used by default and using it is 59 strongly recommended. 60 61sysfs-Interface 62--------------- 63 64temp1_input 65 - temperature input 66humidity1_input 67 - humidity input 68