1High Speed Synchronous Serial Interface (HSI)
2=============================================
3
4Introduction
5---------------
6
7High Speed Syncronous Interface (HSI) is a fullduplex, low latency protocol,
8that is optimized for die-level interconnect between an Application Processor
9and a Baseband chipset. It has been specified by the MIPI alliance in 2003 and
10implemented by multiple vendors since then.
11
12The HSI interface supports full duplex communication over multiple channels
13(typically 8) and is capable of reaching speeds up to 200 Mbit/s.
14
15The serial protocol uses two signals, DATA and FLAG as combined data and clock
16signals and an additional READY signal for flow control. An additional WAKE
17signal can be used to wakeup the chips from standby modes. The signals are
18commonly prefixed by AC for signals going from the application die to the
19cellular die and CA for signals going the other way around.
20
21::
22
23    +------------+                                 +---------------+
24    |  Cellular  |                                 |  Application  |
25    |    Die     |                                 |      Die      |
26    |            | - - - - - - CAWAKE - - - - - - >|               |
27    |           T|------------ CADATA ------------>|R              |
28    |           X|------------ CAFLAG ------------>|X              |
29    |            |<----------- ACREADY ------------|               |
30    |            |                                 |               |
31    |            |                                 |               |
32    |            |< - - - - -  ACWAKE - - - - - - -|               |
33    |           R|<----------- ACDATA -------------|T              |
34    |           X|<----------- ACFLAG -------------|X              |
35    |            |------------ CAREADY ----------->|               |
36    |            |                                 |               |
37    |            |                                 |               |
38    +------------+                                 +---------------+
39
40HSI Subsystem in Linux
41-------------------------
42
43In the Linux kernel the hsi subsystem is supposed to be used for HSI devices.
44The hsi subsystem contains drivers for hsi controllers including support for
45multi-port controllers and provides a generic API for using the HSI ports.
46
47It also contains HSI client drivers, which make use of the generic API to
48implement a protocol used on the HSI interface. These client drivers can
49use an arbitrary number of channels.
50
51hsi-char Device
52------------------
53
54Each port automatically registers a generic client driver called hsi_char,
55which provides a charecter device for userspace representing the HSI port.
56It can be used to communicate via HSI from userspace. Userspace may
57configure the hsi_char device using the following ioctl commands:
58
59HSC_RESET
60 flush the HSI port
61
62HSC_SET_PM
63 enable or disable the client.
64
65HSC_SEND_BREAK
66 send break
67
68HSC_SET_RX
69 set RX configuration
70
71HSC_GET_RX
72 get RX configuration
73
74HSC_SET_TX
75 set TX configuration
76
77HSC_GET_TX
78 get TX configuration
79
80The kernel HSI API
81------------------
82
83.. kernel-doc:: include/linux/hsi/hsi.h
84   :internal:
85
86.. kernel-doc:: drivers/hsi/hsi_core.c
87   :export:
88
89