1Binding for Thermal Sensor driver for STMicroelectronics STi series of SoCs.
2
3Required parameters:
4-------------------
5
6compatible : 	st,<SoC>-<module>-thermal; should be one of:
7		  "st,stih415-sas-thermal",
8		  "st,stih415-mpe-thermal",
9		  "st,stih416-sas-thermal"
10		  "st,stih416-mpe-thermal"
11		  "st,stid127-thermal" or
12		  "st,stih407-thermal"
13		according to the SoC type (stih415, stih416, stid127, stih407)
14		and module type (sas or mpe). On stid127 & stih407 there is only
15		one die/module, so there is no module type in the compatible
16		string.
17clock-names : 	Should be "thermal".
18		  See: Documentation/devicetree/bindings/resource-names.txt
19clocks : 	Phandle of the clock used by the thermal sensor.
20		  See: Documentation/devicetree/bindings/clock/clock-bindings.txt
21
22Optional parameters:
23-------------------
24
25reg : 		For non-sysconf based sensors, this should be the physical base
26		address and length of the sensor's registers.
27interrupts :	Standard way to define interrupt number.
28		Interrupt is mandatory to be defined when compatible is
29		"stih416-mpe-thermal".
30		  NB: For thermal sensor's for which no interrupt has been
31		  defined, a polling delay of 1000ms will be used to read the
32		  temperature from device.
33
34Example:
35
36	temp1@fdfe8000 {
37		compatible	= "st,stih416-mpe-thermal";
38		reg		= <0xfdfe8000 0x10>;
39		clock-names	= "thermal";
40		clocks		= <&clk_m_mpethsens>;
41		interrupts	= <GIC_SPI 23 IRQ_TYPE_NONE>;
42	};
43