xref: /openbmc/linux/Documentation/devicetree/bindings/spi/spi-mux.yaml (revision 2fa5ebe3bc4e31e07a99196455498472417842f2) 
1# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
2%YAML 1.2
3---
4$id: http://devicetree.org/schemas/spi/spi-mux.yaml#
5$schema: http://devicetree.org/meta-schemas/core.yaml#
6
7title: Generic SPI Multiplexer
8
9description: |
10  This binding describes a SPI bus multiplexer to route the SPI chip select
11  signals. This can be used when you need more devices than the SPI controller
12  has chip selects available. An example setup is shown in ASCII art; the actual
13  setting of the multiplexer to a channel needs to be done by a specific SPI mux
14  driver.
15
16        MOSI /--------------------------------+--------+--------+--------\
17        MISO |/------------------------------+|-------+|-------+|-------\|
18         SCL ||/----------------------------+||------+||------+||------\||
19             |||                            |||      |||      |||      |||
20      +------------+                        |||      |||      |||      |||
21      | SoC  |||   |                      +-+++-+  +-+++-+  +-+++-+  +-+++-+
22      |      |||   |                      | dev |  | dev |  | dev |  | dev |
23      |   +--+++-+ | CS-X  +------+\      +--+--+  +--+--+  +--+--+  +--+--+
24      |   | SPI  +-|-------+ Mux  |\\   CS-0 |        |        |        |
25      |   +------+ |       +--+---+\\\-------/   CS-1 |        |        |
26      |            |          |    \\\----------------/   CS-2 |        |
27      |   +------+ |          |     \\-------------------------/   CS-3 |
28      |   | ?    +-|----------/      \----------------------------------/
29      |   +------+ |
30      +------------+
31
32allOf:
33  - $ref: /schemas/spi/spi-controller.yaml#
34  - $ref: /schemas/spi/spi-peripheral-props.yaml#
35
36maintainers:
37  - Chris Packham <chris.packham@alliedtelesis.co.nz>
38
39properties:
40  compatible:
41    const: spi-mux
42
43  mux-controls:
44    maxItems: 1
45
46required:
47  - compatible
48  - reg
49  - spi-max-frequency
50  - mux-controls
51
52unevaluatedProperties: false
53
54examples:
55  - |
56    #include <dt-bindings/gpio/gpio.h>
57    mux: mux-controller {
58        compatible = "gpio-mux";
59        #mux-control-cells = <0>;
60
61        mux-gpios = <&gpio0 3 GPIO_ACTIVE_HIGH>;
62    };
63
64    spi {
65        #address-cells = <1>;
66        #size-cells = <0>;
67        spi@0 {
68            compatible = "spi-mux";
69            reg = <0>;
70            #address-cells = <1>;
71            #size-cells = <0>;
72            spi-max-frequency = <100000000>;
73
74            mux-controls = <&mux>;
75
76            flash@0 {
77                compatible = "jedec,spi-nor";
78                reg = <0>;
79                spi-max-frequency = <40000000>;
80            };
81
82            sensor@1 {
83                compatible = "bosch,bme680";
84                reg = <1>;
85                spi-max-frequency = <10000000>;
86            };
87        };
88    };
89