1Nuvoton NPCM Peripheral Serial Peripheral Interface(PSPI) controller driver 2 3Nuvoton NPCM7xx SOC support two PSPI channels. 4 5Required properties: 6 - compatible : "nuvoton,npcm750-pspi" for NPCM7XX BMC 7 - #address-cells : should be 1. see spi-bus.txt 8 - #size-cells : should be 0. see spi-bus.txt 9 - specifies physical base address and size of the register. 10 - interrupts : contain PSPI interrupt. 11 - clocks : phandle of PSPI reference clock. 12 - clock-names: Should be "clk_apb5". 13 - pinctrl-names : a pinctrl state named "default" must be defined. 14 - pinctrl-0 : phandle referencing pin configuration of the device. 15 - cs-gpios: Specifies the gpio pins to be used for chipselects. 16 See: Documentation/devicetree/bindings/spi/spi-bus.txt 17 18Optional properties: 19- clock-frequency : Input clock frequency to the PSPI block in Hz. 20 Default is 25000000 Hz. 21 22Example: 23 24spi0: spi@f0200000 { 25 compatible = "nuvoton,npcm750-pspi"; 26 reg = <0xf0200000 0x1000>; 27 pinctrl-names = "default"; 28 pinctrl-0 = <&pspi1_pins>; 29 #address-cells = <1>; 30 #size-cells = <0>; 31 interrupts = <GIC_SPI 31 IRQ_TYPE_LEVEL_HIGH>; 32 clocks = <&clk NPCM7XX_CLK_APB5>; 33 clock-names = "clk_apb5"; 34 cs-gpios = <&gpio6 11 GPIO_ACTIVE_LOW>; 35}; 36