1RT5677 audio CODEC
2
3This device supports I2C only.
4
5Required properties:
6
7- compatible : "realtek,rt5677".
8
9- reg : The I2C address of the device.
10
11- interrupts : The CODEC's interrupt output.
12
13- gpio-controller : Indicates this device is a GPIO controller.
14
15- #gpio-cells : Should be two. The first cell is the pin number and the
16  second cell is used to specify optional parameters (currently unused).
17
18Optional properties:
19
20- realtek,pow-ldo2-gpio : The GPIO that controls the CODEC's POW_LDO2 pin.
21- realtek,reset-gpio : The GPIO that controls the CODEC's RESET pin. Active low.
22
23- realtek,in1-differential
24- realtek,in2-differential
25- realtek,lout1-differential
26- realtek,lout2-differential
27- realtek,lout3-differential
28  Boolean. Indicate MIC1/2 input and LOUT1/2/3 outputs are differential,
29  rather than single-ended.
30
31- realtek,gpio-config
32  Array of six 8bit elements that configures GPIO.
33    0 - floating (reset value)
34    1 - pull down
35    2 - pull up
36
37- realtek,jd1-gpio
38  Configures GPIO Mic Jack detection 1.
39  Select 0 ~ 3 as OFF, GPIO1, GPIO2 and GPIO3 respectively.
40
41- realtek,jd2-gpio
42- realtek,jd3-gpio
43  Configures GPIO Mic Jack detection 2 and 3.
44  Select 0 ~ 3 as OFF, GPIO4, GPIO5 and GPIO6 respectively.
45
46Pins on the device (for linking into audio routes):
47
48  * IN1P
49  * IN1N
50  * IN2P
51  * IN2N
52  * MICBIAS1
53  * DMIC1
54  * DMIC2
55  * DMIC3
56  * DMIC4
57  * LOUT1
58  * LOUT2
59  * LOUT3
60
61Example:
62
63rt5677 {
64	compatible = "realtek,rt5677";
65	reg = <0x2c>;
66	interrupt-parent = <&gpio>;
67	interrupts = <TEGRA_GPIO(W, 3) GPIO_ACTIVE_HIGH>;
68
69	gpio-controller;
70	#gpio-cells = <2>;
71
72	realtek,pow-ldo2-gpio =
73		<&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_HIGH>;
74	realtek,reset-gpio = <&gpio TEGRA_GPIO(BB, 3) GPIO_ACTIVE_LOW>;
75	realtek,in1-differential = "true";
76	realtek,gpio-config = /bits/ 8  <0 0 0 0 0 2>;   /* pull up GPIO6 */
77	realtek,jd2-gpio = <3>;  /* Enables Jack detection for GPIO6 */
78};
79