1RT5663 audio CODEC
2
3This device supports I2C only.
4
5Required properties:
6
7- compatible : "realtek,rt5663".
8
9- reg : The I2C address of the device.
10
11- interrupts : The CODEC's interrupt output.
12
13Optional properties:
14
15- "realtek,dc_offset_l_manual"
16- "realtek,dc_offset_r_manual"
17- "realtek,dc_offset_l_manual_mic"
18- "realtek,dc_offset_r_manual_mic"
19  Based on the different PCB layout, add the manual offset value to
20  compensate the DC offset for each L and R channel, and they are different
21  between headphone and headset.
22- "realtek,impedance_sensing_num"
23  The matrix row number of the impedance sensing table.
24  If the value is 0, it means the impedance sensing is not supported.
25- "realtek,impedance_sensing_table"
26  The matrix rows of the impedance sensing table are consisted by impedance
27  minimum, impedance maximun, volume, DC offset w/o and w/ mic of each L and
28  R channel accordingly. Example is shown as following.
29  <   0    300  7  0xffd160  0xffd1c0  0xff8a10  0xff8ab0
30    301  65535  4  0xffe470  0xffe470  0xffb8e0  0xffb8e0>
31  The first and second column are defined for the impedance range. If the
32  detected impedance value is in the range, then the volume value of the
33  third column will be set to codec. In our codec design, each volume value
34  should compensate different DC offset to avoid the pop sound, and it is
35  also different between headphone and headset. In the example, the
36  "realtek,impedance_sensing_num" is 2. It means that there are 2 ranges of
37  impedance in the impedance sensing function.
38
39Pins on the device (for linking into audio routes) for RT5663:
40
41  * IN1P
42  * IN1N
43  * IN2P
44  * IN2N
45  * HPOL
46  * HPOR
47
48Example:
49
50codec: rt5663@12 {
51	compatible = "realtek,rt5663";
52	reg = <0x12>;
53	interrupts = <7 IRQ_TYPE_EDGE_FALLING>;
54};
55