1RT5650/RT5645 audio CODEC
2
3This device supports I2C only.
4
5Required properties:
6
7- compatible : One of "realtek,rt5645" or "realtek,rt5650".
8
9- reg : The I2C address of the device.
10
11- interrupts : The CODEC's interrupt output.
12
13Optional properties:
14
15- hp-detect-gpios:
16  a GPIO spec for the external headphone detect pin. If jd-mode = 0,
17  we will get the JD status by getting the value of hp-detect-gpios.
18
19- realtek,in2-differential
20  Boolean. Indicate MIC2 input are differential, rather than single-ended.
21
22- realtek,dmic1-data-pin
23  0: dmic1 is not used
24  1: using IN2P pin as dmic1 data pin
25  2: using GPIO6 pin as dmic1 data pin
26  3: using GPIO10 pin as dmic1 data pin
27  4: using GPIO12 pin as dmic1 data pin
28
29- realtek,dmic2-data-pin
30  0: dmic2 is not used
31  1: using IN2N pin as dmic2 data pin
32  2: using GPIO5 pin as dmic2 data pin
33  3: using GPIO11 pin as dmic2 data pin
34
35-- realtek,jd-mode : The JD mode of rt5645/rt5650
36   0 : rt5645/rt5650 JD function is not used
37   1 : Mode-0 (VDD=3.3V), two port jack detection
38   2 : Mode-1 (VDD=3.3V), one port jack detection
39   3 : Mode-2 (VDD=1.8V), one port jack detection
40
41Pins on the device (for linking into audio routes) for RT5645/RT5650:
42
43  * DMIC L1
44  * DMIC R1
45  * DMIC L2
46  * DMIC R2
47  * IN1P
48  * IN1N
49  * IN2P
50  * IN2N
51  * Haptic Generator
52  * HPOL
53  * HPOR
54  * LOUTL
55  * LOUTR
56  * PDM1L
57  * PDM1R
58  * SPOL
59  * SPOR
60
61Example:
62
63codec: rt5650@1a {
64	compatible = "realtek,rt5650";
65	reg = <0x1a>;
66	hp-detect-gpios = <&gpio 19 0>;
67	interrupt-parent = <&gpio>;
68	interrupts = <7 IRQ_TYPE_EDGE_FALLING>;
69	realtek,dmic-en = "true";
70	realtek,en-jd-func = "true";
71	realtek,jd-mode = <3>;
72};