1* palmas regulator IP block devicetree bindings 2 3Required properties: 4- compatible : Should be from the list 5 ti,twl6035-pmic 6 ti,twl6036-pmic 7 ti,twl6037-pmic 8 ti,tps65913-pmic 9 ti,tps65914-pmic 10and also the generic series names 11 ti,palmas-pmic 12- interrupt-parent : The parent interrupt controller which is palmas. 13- interrupts : The interrupt number and the type which can be looked up here: 14 arch/arm/boot/dts/include/dt-bindings/interrupt-controller/irq.h 15- interrupts-name: The names of the individual interrupts. 16 17Optional properties: 18- ti,ldo6-vibrator : ldo6 is in vibrator mode 19 20Optional nodes: 21- regulators : Must contain a sub-node per regulator from the list below. 22 Each sub-node should contain the constraints and initialization 23 information for that regulator. See regulator.txt for a 24 description of standard properties for these sub-nodes. 25 Additional custom properties are listed below. 26 27 For ti,palmas-pmic - smps12, smps123, smps3 depending on OTP, 28 smps45, smps457, smps7 depending on variant, smps6, smps[8-10], 29 ldo[1-9], ldoln, ldousb. 30 31 Optional sub-node properties: 32 ti,warm-reset - maintain voltage during warm reset(boolean) 33 ti,roof-floor - control voltage selection by pin(boolean) 34 ti,mode-sleep - mode to adopt in pmic sleep 0 - off, 1 - auto, 35 2 - eco, 3 - forced pwm 36 ti,smps-range - OTP has the wrong range set for the hardware so override 37 0 - low range, 1 - high range. 38 39Example: 40 41#include <dt-bindings/interrupt-controller/irq.h> 42 43pmic { 44 compatible = "ti,twl6035-pmic", "ti,palmas-pmic"; 45 interrupt-parent = <&palmas>; 46 interrupts = <14 IRQ_TYPE_NONE>; 47 interrupts-name = "short-irq"; 48 49 ti,ldo6-vibrator; 50 51 regulators { 52 smps12_reg : smps12 { 53 regulator-name = "smps12"; 54 regulator-min-microvolt = < 600000>; 55 regulator-max-microvolt = <1500000>; 56 regulator-always-on; 57 regulator-boot-on; 58 ti,warm-reset; 59 ti,roof-floor; 60 ti,mode-sleep = <0>; 61 ti,smps-range = <1>; 62 }; 63 64 ldo1_reg: ldo1 { 65 regulator-name = "ldo1"; 66 regulator-min-microvolt = <2800000>; 67 regulator-max-microvolt = <2800000>; 68 }; 69 }; 70}; 71