1Broadcom BCM2835 GPIO (and pinmux) controller
2
3The BCM2835 GPIO module is a combined GPIO controller, (GPIO) interrupt
4controller, and pinmux/control device.
5
6Required properties:
7- compatible: "brcm,bcm2835-gpio"
8- reg: Should contain the physical address of the GPIO module's registers.
9- gpio-controller: Marks the device node as a GPIO controller.
10- #gpio-cells : Should be two. The first cell is the pin number and the
11  second cell is used to specify optional parameters:
12  - bit 0 specifies polarity (0 for normal, 1 for inverted)
13- interrupts : The interrupt outputs from the controller. One interrupt per
14  individual bank followed by the "all banks" interrupt.
15- interrupt-controller: Marks the device node as an interrupt controller.
16- #interrupt-cells : Should be 2.
17  The first cell is the GPIO number.
18  The second cell is used to specify flags:
19    bits[3:0] trigger type and level flags:
20      1 = low-to-high edge triggered.
21      2 = high-to-low edge triggered.
22      4 = active high level-sensitive.
23      8 = active low level-sensitive.
24    Valid combinations are 1, 2, 3, 4, 8.
25
26Please refer to ../gpio/gpio.txt for a general description of GPIO bindings.
27
28Please refer to pinctrl-bindings.txt in this directory for details of the
29common pinctrl bindings used by client devices, including the meaning of the
30phrase "pin configuration node".
31
32Each pin configuration node lists the pin(s) to which it applies, and one or
33more of the mux function to select on those pin(s), and pull-up/down
34configuration. Each subnode only affects those parameters that are explicitly
35listed. In other words, a subnode that lists only a mux function implies no
36information about any pull configuration. Similarly, a subnode that lists only
37a pul parameter implies no information about the mux function.
38
39Required subnode-properties:
40- brcm,pins: An array of cells. Each cell contains the ID of a pin. Valid IDs
41  are the integer GPIO IDs; 0==GPIO0, 1==GPIO1, ... 53==GPIO53.
42
43Optional subnode-properties:
44- brcm,function: Integer, containing the function to mux to the pin(s):
45  0: GPIO in
46  1: GPIO out
47  2: alt5
48  3: alt4
49  4: alt0
50  5: alt1
51  6: alt2
52  7: alt3
53- brcm,pull: Integer, representing the pull-down/up to apply to the pin(s):
54  0: none
55  1: down
56  2: up
57
58Each of brcm,function and brcm,pull may contain either a single value which
59will be applied to all pins in brcm,pins, or 1 value for each entry in
60brcm,pins.
61
62Example:
63
64	gpio: gpio {
65		compatible = "brcm,bcm2835-gpio";
66		reg = <0x2200000 0xb4>;
67		interrupts = <2 17>, <2 19>, <2 18>, <2 20>;
68
69		gpio-controller;
70		#gpio-cells = <2>;
71
72		interrupt-controller;
73		#interrupt-cells = <2>;
74	};
75