1Marvell 8897/8997 (sd8897/sd8997/pcie8997) SDIO/PCIE devices 2------ 3 4This node provides properties for controlling the Marvell SDIO/PCIE wireless device. 5The node is expected to be specified as a child node to the SDIO/PCIE controller that 6connects the device to the system. 7 8Required properties: 9 10 - compatible : should be one of the following: 11 * "marvell,sd8897" 12 * "marvell,sd8997" 13 * "pci11ab,2b42" 14 * "pci1b4b,2b42" 15 16Optional properties: 17 18 - marvell,caldata* : A series of properties with marvell,caldata prefix, 19 represent calibration data downloaded to the device during 20 initialization. This is an array of unsigned 8-bit values. 21 the properties should follow below property name and 22 corresponding array length: 23 "marvell,caldata-txpwrlimit-2g" (length = 566). 24 "marvell,caldata-txpwrlimit-5g-sub0" (length = 502). 25 "marvell,caldata-txpwrlimit-5g-sub1" (length = 688). 26 "marvell,caldata-txpwrlimit-5g-sub2" (length = 750). 27 "marvell,caldata-txpwrlimit-5g-sub3" (length = 502). 28 - marvell,wakeup-pin : a wakeup pin number of wifi chip which will be configured 29 to firmware. Firmware will wakeup the host using this pin 30 during suspend/resume. 31 - interrupt-parent: phandle of the parent interrupt controller 32 - interrupts : interrupt pin number to the cpu. driver will request an irq based on 33 this interrupt number. during system suspend, the irq will be enabled 34 so that the wifi chip can wakeup host platform under certain condition. 35 during system resume, the irq will be disabled to make sure 36 unnecessary interrupt is not received. 37 38Example: 39 40Tx power limit calibration data is configured in below example. 41The calibration data is an array of unsigned values, the length 42can vary between hw versions. 43IRQ pin 38 is used as system wakeup source interrupt. wakeup pin 3 is configured 44so that firmware can wakeup host using this device side pin. 45 46&mmc3 { 47 status = "okay"; 48 vmmc-supply = <&wlan_en_reg>; 49 bus-width = <4>; 50 cap-power-off-card; 51 keep-power-in-suspend; 52 53 #address-cells = <1>; 54 #size-cells = <0>; 55 mwifiex: wifi@1 { 56 compatible = "marvell,sd8897"; 57 reg = <1>; 58 interrupt-parent = <&pio>; 59 interrupts = <38 IRQ_TYPE_LEVEL_LOW>; 60 61 marvell,caldata_00_txpwrlimit_2g_cfg_set = /bits/ 8 < 62 0x01 0x00 0x06 0x00 0x08 0x02 0x89 0x01>; 63 marvell,wakeup-pin = <3>; 64 }; 65}; 66