1* STMicroelectronics 10/100/1000 Ethernet driver (GMAC) 2 3Required properties: 4- compatible: Should be "snps,dwmac-<ip_version>" "snps,dwmac" 5 For backwards compatibility: "st,spear600-gmac" is also supported. 6- reg: Address and length of the register set for the device 7- interrupt-parent: Should be the phandle for the interrupt controller 8 that services interrupts for this device 9- interrupts: Should contain the STMMAC interrupts 10- interrupt-names: Should contain the interrupt names "macirq" 11 "eth_wake_irq" if this interrupt is supported in the "interrupts" 12 property 13- phy-mode: See ethernet.txt file in the same directory. 14- snps,reset-gpio gpio number for phy reset. 15- snps,reset-active-low boolean flag to indicate if phy reset is active low. 16- snps,reset-delays-us is triplet of delays 17 The 1st cell is reset pre-delay in micro seconds. 18 The 2nd cell is reset pulse in micro seconds. 19 The 3rd cell is reset post-delay in micro seconds. 20- snps,pbl Programmable Burst Length 21- snps,fixed-burst Program the DMA to use the fixed burst mode 22- snps,mixed-burst Program the DMA to use the mixed burst mode 23- snps,force_thresh_dma_mode Force DMA to use the threshold mode for 24 both tx and rx 25- snps,force_sf_dma_mode Force DMA to use the Store and Forward 26 mode for both tx and rx. This flag is 27 ignored if force_thresh_dma_mode is set. 28- snps,multicast-filter-bins: Number of multicast filter hash bins 29 supported by this device instance 30- snps,perfect-filter-entries: Number of perfect filter entries supported 31 by this device instance 32 33Optional properties: 34- resets: Should contain a phandle to the STMMAC reset signal, if any 35- reset-names: Should contain the reset signal name "stmmaceth", if a 36 reset phandle is given 37- max-frame-size: See ethernet.txt file in the same directory 38- clocks: If present, the first clock should be the GMAC main clock, 39 further clocks may be specified in derived bindings. 40- clock-names: One name for each entry in the clocks property, the 41 first one should be "stmmaceth". 42- clk_ptp_ref: this is the PTP reference clock; in case of the PTP is 43 available this clock is used for programming the Timestamp Addend Register. 44 If not passed then the system clock will be used and this is fine on some 45 platforms. 46 47Examples: 48 49 gmac0: ethernet@e0800000 { 50 compatible = "st,spear600-gmac"; 51 reg = <0xe0800000 0x8000>; 52 interrupt-parent = <&vic1>; 53 interrupts = <24 23>; 54 interrupt-names = "macirq", "eth_wake_irq"; 55 mac-address = [000000000000]; /* Filled in by U-Boot */ 56 max-frame-size = <3800>; 57 phy-mode = "gmii"; 58 snps,multicast-filter-bins = <256>; 59 snps,perfect-filter-entries = <128>; 60 clocks = <&clock>; 61 clock-names = "stmmaceth">; 62 }; 63