1* Microchip ENC28J60
2
3This is a standalone 10 MBit ethernet controller with SPI interface.
4
5For each device connected to a SPI bus, define a child node within
6the SPI master node.
7
8Required properties:
9- compatible: Should be "microchip,enc28j60"
10- reg: Specify the SPI chip select the ENC28J60 is wired to
11- interrupt-parent: Specify the phandle of the source interrupt, see interrupt
12                    binding documentation for details. Usually this is the GPIO bank
13                    the interrupt line is wired to.
14- interrupts: Specify the interrupt index within the interrupt controller (referred
15              to above in interrupt-parent) and interrupt type. The ENC28J60 natively
16              generates falling edge interrupts, however, additional board logic
17              might invert the signal.
18- pinctrl-names: List of assigned state names, see pinctrl binding documentation.
19- pinctrl-0: List of phandles to configure the GPIO pin used as interrupt line,
20             see also generic and your platform specific pinctrl binding
21             documentation.
22
23Optional properties:
24- spi-max-frequency: Maximum frequency of the SPI bus when accessing the ENC28J60.
25  According to the ENC28J80 datasheet, the chip allows a maximum of 20 MHz, however,
26  board designs may need to limit this value.
27- local-mac-address: See ethernet.txt in the same directory.
28
29
30Example (for NXP i.MX28 with pin control stuff for GPIO irq):
31
32        ssp2: ssp@80014000 {
33                compatible = "fsl,imx28-spi";
34                pinctrl-names = "default";
35                pinctrl-0 = <&spi2_pins_b &spi2_sck_cfg>;
36                status = "okay";
37
38                enc28j60: ethernet@0 {
39                        compatible = "microchip,enc28j60";
40                        pinctrl-names = "default";
41                        pinctrl-0 = <&enc28j60_pins>;
42                        reg = <0>;
43                        interrupt-parent = <&gpio3>;
44                        interrupts = <3 IRQ_TYPE_EDGE_FALLING>;
45                        spi-max-frequency = <12000000>;
46                };
47        };
48
49        pinctrl@80018000 {
50                enc28j60_pins: enc28j60_pins@0 {
51                        reg = <0>;
52                        fsl,pinmux-ids = <
53                                MX28_PAD_AUART0_RTS__GPIO_3_3    /* Interrupt */
54                        >;
55                        fsl,drive-strength = <MXS_DRIVE_4mA>;
56                        fsl,voltage = <MXS_VOLTAGE_HIGH>;
57                        fsl,pull-up = <MXS_PULL_DISABLE>;
58                };
59        };
60