1NXP LPC32xx SoC NAND SLC controller
2
3Required properties:
4- compatible: "nxp,lpc3220-slc"
5- reg: Address and size of the controller
6- nand-on-flash-bbt: Use bad block table on flash
7- gpios: GPIO specification for NAND write protect
8
9The following required properties are very controller specific. See the LPC32xx
10User Manual:
11- nxp,wdr-clks: Delay before Ready signal is tested on write (W_RDY)
12- nxp,rdr-clks: Delay before Ready signal is tested on read (R_RDY)
13(The following values are specified in Hz, to make them independent of actual
14clock speed:)
15- nxp,wwidth: Write pulse width (W_WIDTH)
16- nxp,whold: Write hold time (W_HOLD)
17- nxp,wsetup: Write setup time (W_SETUP)
18- nxp,rwidth: Read pulse width (R_WIDTH)
19- nxp,rhold: Read hold time (R_HOLD)
20- nxp,rsetup: Read setup time (R_SETUP)
21
22Optional subnodes:
23- Partitions, see Documentation/devicetree/bindings/mtd/partition.txt
24
25Example:
26
27	slc: flash@20020000 {
28		compatible = "nxp,lpc3220-slc";
29		reg = <0x20020000 0x1000>;
30		#address-cells = <1>;
31		#size-cells = <1>;
32
33		nxp,wdr-clks = <14>;
34		nxp,wwidth = <40000000>;
35		nxp,whold = <100000000>;
36		nxp,wsetup = <100000000>;
37		nxp,rdr-clks = <14>;
38		nxp,rwidth = <40000000>;
39		nxp,rhold = <66666666>;
40		nxp,rsetup = <100000000>;
41		nand-on-flash-bbt;
42		gpios = <&gpio 5 19 1>; /* GPO_P3 19, active low */
43
44		mtd0@00000000 {
45			label = "phy3250-boot";
46			reg = <0x00000000 0x00064000>;
47			read-only;
48		};
49
50		...
51
52	};
53