1NXP LPC32xx SoC NAND MLC controller
2
3Required properties:
4- compatible: "nxp,lpc3220-mlc"
5- reg: Address and size of the controller
6- interrupts: The NAND interrupt specification
7- gpios: GPIO specification for NAND write protect
8
9The following required properties are very controller specific. See the LPC32xx
10User Manual 7.5.14 MLC NAND Timing Register (the values here are specified in
11Hz, to make them independent of actual clock speed and to provide for good
12accuracy:)
13- nxp,tcea_delay: TCEA_DELAY
14- nxp,busy_delay: BUSY_DELAY
15- nxp,nand_ta: NAND_TA
16- nxp,rd_high: RD_HIGH
17- nxp,rd_low: RD_LOW
18- nxp,wr_high: WR_HIGH
19- nxp,wr_low: WR_LOW
20
21Optional subnodes:
22- Partitions, see Documentation/devicetree/bindings/mtd/partition.txt
23
24Example:
25
26	mlc: flash@200a8000 {
27		compatible = "nxp,lpc3220-mlc";
28		reg = <0x200A8000 0x11000>;
29		interrupts = <11 0>;
30		#address-cells = <1>;
31		#size-cells = <1>;
32
33		nxp,tcea-delay = <333333333>;
34		nxp,busy-delay = <10000000>;
35		nxp,nand-ta = <18181818>;
36		nxp,rd-high = <31250000>;
37		nxp,rd-low = <45454545>;
38		nxp,wr-high = <40000000>;
39		nxp,wr-low = <83333333>;
40		gpios = <&gpio 5 19 1>; /* GPO_P3 19, active low */
41
42		mtd0@00000000 {
43			label = "boot";
44			reg = <0x00000000 0x00064000>;
45			read-only;
46		};
47
48		...
49
50	};
51