1Cirrus Logic/Wolfson Microelectronics wm831x PMICs
2
3System PMICs with a wide range of additional features.
4
5Required properties:
6
7  - compatible : One of the following chip-specific strings:
8        "wlf,wm8310"
9        "wlf,wm8311"
10        "wlf,wm8312"
11        "wlf,wm8320"
12        "wlf,wm8321"
13        "wlf,wm8325"
14        "wlf,wm8326"
15
16  - reg : I2C slave address when connected using I2C, chip select number
17    when using SPI.
18
19  - gpio-controller : Indicates this device is a GPIO controller.
20  - #gpio-cells : Must be 2. The first cell is the pin number and the
21    second cell is used to specify optional parameters (currently unused).
22
23  - interrupts : The interrupt line the IRQ signal for the device is
24    connected to.
25  - interrupt-parent : The parent interrupt controller.
26
27  - interrupt-controller : wm831x devices contain interrupt controllers and
28    may provide interrupt services to other devices.
29  - #interrupt-cells: Must be 2. The first cell is the IRQ number, and the
30    second cell is the flags, encoded as the trigger masks from
31    ../interrupt-controller/interrupts.txt
32
33Optional sub-nodes:
34  - phys : Contains a phandle to the USB PHY.
35  - regulators : Contains sub-nodes for each of the regulators supplied by
36    the device. The regulators are bound using their names listed below:
37
38    dcdc1 : DCDC1
39    dcdc2 : DCDC2
40    dcdc3 : DCDC3
41    dcdc4 : DCDC3
42    isink1 : ISINK1
43    isink2 : ISINK2
44    ldo1 : LDO1
45    ldo2 : LDO2
46    ldo3 : LDO3
47    ldo4 : LDO4
48    ldo5 : LDO5
49    ldo7 : LDO7
50    ldo11 : LDO11
51
52    The bindings details of each regulator can be found in:
53    ../regulator/regulator.txt
54
55Example:
56
57wm8310: pmic@36 {
58	compatible = "wlf,wm8310";
59	reg = <0x36>;
60
61	gpio-controller;
62	#gpio-cells = <2>;
63
64	interrupts = <347>;
65	interrupt-parent = <&gic>;
66
67	interrupt-controller;
68	#interrupt-cells = <2>;
69
70	regulators {
71		dcdc1: dcdc1 {
72			regulator-name = "DCDC1";
73			regulator-min-microvolt = <600000>;
74			regulator-max-microvolt = <600000>;
75		};
76		ldo1: ldo1 {
77			regulator-name = "LDO1";
78			regulator-min-microvolt = <1700000>;
79			regulator-max-microvolt = <1700000>;
80		};
81	};
82};
83