1Device-Tree bindings for ST IRB IP
2
3Required properties:
4	- compatible: Should contain "st,comms-irb".
5	- reg: Base physical address of the controller and length of memory
6	  mapped region.
7	- interrupts: interrupt-specifier for the sole interrupt generated by
8	  the device. The interrupt specifier format depends on the interrupt
9	  controller parent.
10	- rx-mode: can be "infrared" or "uhf". This property specifies the L1
11	  protocol used for receiving remote control signals. rx-mode should
12	  be present iff the rx pins are wired up.
13	- tx-mode: should be "infrared". This property specifies the L1
14	  protocol used for transmitting remote control signals. tx-mode should
15	  be present iff the tx pins are wired up.
16
17Optional properties:
18	- pinctrl-names, pinctrl-0: the pincontrol settings to configure muxing
19	  properly for IRB pins.
20	- clocks : phandle with clock-specifier pair for IRB.
21
22Example node:
23
24	rc: rc@fe518000 {
25		compatible	= "st,comms-irb";
26		reg		= <0xfe518000 0x234>;
27		interrupts	= <0 203 0>;
28		rx-mode		= "infrared";
29	};
30