1* SiS I2C Multiple Touch Controller
2
3Required properties:
4- compatible: must be "sis,9200-ts"
5- reg: i2c slave address
6- interrupts: touch controller interrupt (see interrupt
7  binding [0])
8
9Optional properties:
10- pinctrl-names: should be "default" (see pinctrl binding [1]).
11- pinctrl-0: a phandle pointing to the pin settings for the
12  device (see pinctrl binding [1]).
13- attn-gpios: the gpio pin used as attention line
14- reset-gpios: the gpio pin used to reset the controller
15- wakeup-source: touchscreen can be used as a wakeup source
16
17[0]: Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
18[1]: Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt
19
20Example:
21
22	sis9255@5c  {
23		compatible = "sis,9200-ts";
24		reg = <0x5c>;
25		pinctrl-names = "default";
26		pinctrl-0 = <&pinctrl_sis>;
27		interrupt-parent = <&gpio3>;
28		interrupts = <19 IRQ_TYPE_EDGE_FALLING>;
29		irq-gpios = <&gpio3 19 GPIO_ACTIVE_LOW>;
30		reset-gpios = <&gpio2 30 GPIO_ACTIVE_LOW>;
31	};
32