1Generic Parallel-in/Serial-out Shift Register GPIO Driver
2
3This binding describes generic parallel-in/serial-out shift register
4devices that can be used for GPI (General Purpose Input). This includes
5SN74165 serial-out shift registers and the SN65HVS88x series of
6industrial serializers.
7
8Required properties:
9 - compatible		: Should be "pisosr-gpio".
10 - gpio-controller	: Marks the device node as a GPIO controller.
11 - #gpio-cells		: Should be two. For consumer use see gpio.txt.
12
13Optional properties:
14 - ngpios		: Number of used GPIO lines (0..n-1), default is 8.
15 - load-gpios		: GPIO pin specifier attached to load enable, this
16			  pin is pulsed before reading from the device to
17			  load input pin values into the the device.
18
19For other required and optional properties of SPI slave
20nodes please refer to ../spi/spi-bus.txt.
21
22Example:
23
24	gpio@0 {
25		compatible = "ti,sn65hvs882", "pisosr-gpio";
26		gpio-controller;
27		#gpio-cells = <2>;
28
29		load-gpios = <&gpio2 23 GPIO_ACTIVE_LOW>;
30
31		reg = <0>;
32		spi-max-frequency = <1000000>;
33		spi-cpol;
34	};
35