1What:		/sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/operation_mode
2Date:		March 2010
3Contact:	Bruno Prémont <bonbons@linux-vserver.org>
4Description:	Make it possible to switch the PicoLCD device between LCD
5		(firmware) and bootloader (flasher) operation modes.
6
7		Reading: returns list of available modes, the active mode being
8		enclosed in brackets ('[' and ']')
9
10		Writing: causes operation mode switch. Permitted values are
11		the non-active mode names listed when read, optionally followed
12		by a delay value expressed in ms.
13
14		Note: when switching mode the current PicoLCD HID device gets
15		disconnected and reconnects after above delay (default value
16		is 5 seconds though this default should not be relied on).
17
18