1What:		/sys/class/leds/<led>/brightness
2Date:		March 2006
3KernelVersion:	2.6.17
4Contact:	Richard Purdie <rpurdie@rpsys.net>
5Description:
6		Set the brightness of the LED. Most LEDs don't
7		have hardware brightness support, so will just be turned on for
8		non-zero brightness settings. The value is between 0 and
9		/sys/class/leds/<led>/max_brightness.
10
11		Writing 0 to this file clears active trigger.
12
13		Writing non-zero to this file while trigger is active changes the
14		top brightness trigger is going to use.
15
16What:		/sys/class/leds/<led>/max_brightness
17Date:		March 2006
18KernelVersion:	2.6.17
19Contact:	Richard Purdie <rpurdie@rpsys.net>
20Description:
21		Maximum brightness level for this LED, default is 255 (LED_FULL).
22
23		If the LED does not support different brightness levels, this
24		should be 1.
25
26What:		/sys/class/leds/<led>/brightness_hw_changed
27Date:		January 2017
28KernelVersion:	4.11
29Description:
30		Last hardware set brightness level for this LED. Some LEDs
31		may be changed autonomously by hardware/firmware. Only LEDs
32		where this happens and the driver can detect this, will have
33		this file.
34
35		This file supports poll() to detect when the hardware changes
36		the brightness.
37
38		Reading this file will return the last brightness level set
39		by the hardware, this may be different from the current
40		brightness. Reading this file when no hw brightness change
41		event has happened will return an ENODATA error.
42
43What:		/sys/class/leds/<led>/trigger
44Date:		March 2006
45KernelVersion:	2.6.17
46Contact:	Richard Purdie <rpurdie@rpsys.net>
47Description:
48		Set the trigger for this LED. A trigger is a kernel based source
49		of LED events.
50		You can change triggers in a similar manner to the way an IO
51		scheduler is chosen. Trigger specific parameters can appear in
52		/sys/class/leds/<led> once a given trigger is selected. For
53		their documentation see sysfs-class-led-trigger-*.
54
55What:		/sys/class/leds/<led>/inverted
56Date:		January 2011
57KernelVersion:	2.6.38
58Contact:	Richard Purdie <rpurdie@rpsys.net>
59Description:
60		Invert the LED on/off state. This parameter is specific to
61		gpio and backlight triggers. In case of the backlight trigger,
62		it is useful when driving a LED which is intended to indicate
63		a device in a standby like state.
64