1What: /sys/kernel/debug/wilco_ec/h1_gpio 2Date: April 2019 3KernelVersion: 5.2 4Description: 5 As part of Chrome OS's FAFT (Fully Automated Firmware Testing) 6 tests, we need to ensure that the H1 chip is properly setting 7 some GPIO lines. The h1_gpio attribute exposes the state 8 of the lines: 9 - ENTRY_TO_FACT_MODE in BIT(0) 10 - SPI_CHROME_SEL in BIT(1) 11 12 Output will formatted with "0x%02x\n". 13 14What: /sys/kernel/debug/wilco_ec/raw 15Date: January 2019 16KernelVersion: 5.1 17Description: 18 Write and read raw mailbox commands to the EC. 19 20 You can write a hexadecimal sentence to raw, and that series of 21 bytes will be sent to the EC. Then, you can read the bytes of 22 response by reading from raw. 23 24 For writing, bytes 0-1 indicate the message type, one of enum 25 wilco_ec_msg_type. Byte 2+ consist of the data passed in the 26 request, starting at MBOX[0] 27 28 At least three bytes are required for writing, two for the type 29 and at least a single byte of data. Only the first 30 EC_MAILBOX_DATA_SIZE bytes of MBOX will be used. 31 32 Example: 33 // Request EC info type 3 (EC firmware build date) 34 // Corresponds with sending type 0x00f0 with 35 // MBOX = [38, 00, 03, 00] 36 $ echo 00 f0 38 00 03 00 > /sys/kernel/debug/wilco_ec/raw 37 // View the result. The decoded ASCII result "12/21/18" is 38 // included after the raw hex. 39 // Corresponds with MBOX = [00, 00, 31, 32, 2f, 32, 31, 38, ...] 40 $ cat /sys/kernel/debug/wilco_ec/raw 41 00 00 31 32 2f 32 31 2f 31 38 00 38 00 01 00 2f 00 ..12/21/18.8... 42 43 Note that the first 32 bytes of the received MBOX[] will be 44 printed, even if some of the data is junk. It is up to you to 45 know how many of the first bytes of data are the actual 46 response. 47