1 /* SPDX-License-Identifier: GPL-2.0+ */ 2 /* 3 * (C) Copyright 2011 Logic Product Development <www.logicpd.com> 4 * Peter Barada <peter.barada@logicpd.com> 5 * 6 * Configuration settings for the Logic OMAP35x/DM37x SOM LV/Torpedo 7 * reference boards. 8 */ 9 10 #ifndef __CONFIG_H 11 #define __CONFIG_H 12 13 /* High Level Configuration Options */ 14 15 #define CONFIG_NR_DRAM_BANKS 2 /* CS1 may or may not be populated */ 16 17 #include <configs/ti_omap3_common.h> 18 19 /* 20 * We are only ever GP parts and will utilize all of the "downloaded image" 21 * area in SRAM which starts at 0x40200000 and ends at 0x4020FFFF (64KB) in 22 * order to allow for BCH8 to fit in. 23 */ 24 #undef CONFIG_SPL_TEXT_BASE 25 #define CONFIG_SPL_TEXT_BASE 0x40200000 26 27 #define CONFIG_MISC_INIT_R /* misc_init_r dumps the die id */ 28 #define CONFIG_CMDLINE_TAG /* enable passing of ATAGs */ 29 #define CONFIG_SETUP_MEMORY_TAGS 30 #define CONFIG_INITRD_TAG 31 #define CONFIG_REVISION_TAG 32 33 /* Hardware drivers */ 34 35 /* I2C */ 36 #define CONFIG_SYS_I2C_EEPROM_ADDR 0x50 /* EEPROM AT24C64 */ 37 38 /* Board NAND Info. */ 39 #ifdef CONFIG_NAND 40 #define CONFIG_SYS_NAND_ADDR NAND_BASE /* physical address */ 41 /* to access nand */ 42 #define CONFIG_SYS_MAX_NAND_DEVICE 1 /* Max number of */ 43 /* NAND devices */ 44 #define CONFIG_SYS_NAND_5_ADDR_CYCLE 45 #define CONFIG_SYS_NAND_PAGE_COUNT 64 46 #define CONFIG_SYS_NAND_PAGE_SIZE 2048 47 #define CONFIG_SYS_NAND_OOBSIZE 64 48 #define CONFIG_SYS_NAND_BLOCK_SIZE (128 * 1024) 49 #define CONFIG_SYS_NAND_BAD_BLOCK_POS NAND_LARGE_BADBLOCK_POS 50 #define CONFIG_SYS_NAND_ECCPOS {2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, \ 51 13, 14, 16, 17, 18, 19, 20, 21, 22, \ 52 23, 24, 25, 26, 27, 28, 30, 31, 32, \ 53 33, 34, 35, 36, 37, 38, 39, 40, 41, \ 54 42, 44, 45, 46, 47, 48, 49, 50, 51, \ 55 52, 53, 54, 55, 56} 56 57 #define CONFIG_SYS_NAND_ECCSIZE 512 58 #define CONFIG_SYS_NAND_ECCBYTES 13 59 #define CONFIG_NAND_OMAP_ECCSCHEME OMAP_ECC_BCH8_CODE_HW_DETECTION_SW 60 #define CONFIG_SYS_NAND_MAX_OOBFREE 2 61 #define CONFIG_SYS_NAND_MAX_ECCPOS 56 62 #endif 63 64 /* Environment information */ 65 66 #define CONFIG_PREBOOT \ 67 "setenv preboot;" \ 68 "saveenv;" 69 70 #define CONFIG_EXTRA_ENV_SETTINGS \ 71 DEFAULT_LINUX_BOOT_ENV \ 72 "mtdids=" CONFIG_MTDIDS_DEFAULT "\0" \ 73 "mtdparts=" CONFIG_MTDPARTS_DEFAULT "\0" \ 74 "mmcdev=0\0" \ 75 "mmcroot=/dev/mmcblk0p2 rw\0" \ 76 "mmcrootfstype=ext4 rootwait\0" \ 77 "nandroot=ubi0:rootfs rw ubi.mtd=fs noinitrd\0" \ 78 "nandrootfstype=ubifs rootwait\0" \ 79 "autoboot=mmc dev ${mmcdev}; if mmc rescan; then " \ 80 "if run loadbootscript; then " \ 81 "run bootscript; " \ 82 "else " \ 83 "run defaultboot;" \ 84 "fi; " \ 85 "else run defaultboot; fi\0" \ 86 "defaultboot=run mmcramboot\0" \ 87 "consoledevice=ttyS0\0" \ 88 "setconsole=setenv console ${consoledevice},${baudrate}n8\0" \ 89 "dump_bootargs=echo 'Bootargs: '; echo $bootargs\0" \ 90 "rotation=0\0" \ 91 "vrfb_arg=if itest ${rotation} -ne 0; then " \ 92 "setenv bootargs ${bootargs} omapfb.vrfb=y " \ 93 "omapfb.rotate=${rotation}; " \ 94 "fi\0" \ 95 "optargs=ignore_loglevel early_printk no_console_suspend\0" \ 96 "common_bootargs=run setconsole; setenv bootargs " \ 97 "${bootargs} "\ 98 "console=${console} " \ 99 "${mtdparts} "\ 100 "${optargs}; " \ 101 "run vrfb_arg\0" \ 102 "loadbootscript=load mmc ${mmcdev} ${loadaddr} boot.scr\0" \ 103 "bootscript=echo 'Running bootscript from mmc ...'; " \ 104 "source ${loadaddr}\0" \ 105 "loadimage=mmc rescan; " \ 106 "load mmc ${mmcdev} ${loadaddr} ${bootfile}\0" \ 107 "ramdisksize=64000\0" \ 108 "ramdiskimage=rootfs.ext2.gz.uboot\0" \ 109 "loadramdisk=mmc rescan; " \ 110 "load mmc ${mmcdev} ${rdaddr} ${ramdiskimage}\0" \ 111 "ramargs=setenv bootargs "\ 112 "root=/dev/ram rw ramdisk_size=${ramdisksize}\0" \ 113 "mmcargs=setenv bootargs "\ 114 "root=${mmcroot} rootfstype=${mmcrootfstype}\0" \ 115 "nandargs=setenv bootargs "\ 116 "root=${nandroot} " \ 117 "rootfstype=${nandrootfstype}\0" \ 118 "nfsargs=setenv serverip ${tftpserver}; " \ 119 "setenv bootargs root=/dev/nfs " \ 120 "nfsroot=${nfsrootpath} " \ 121 "ip=${ipaddr}:${tftpserver}:${gatewayip}:${netmask}::eth0:off\0" \ 122 "nfsrootpath=/opt/nfs-exports/omap\0" \ 123 "autoload=no\0" \ 124 "loadfdt=mmc rescan; " \ 125 "load mmc ${mmcdev} ${fdtaddr} ${fdtimage}\0" \ 126 "mmcbootcommon=echo Booting with DT from mmc${mmcdev} ...; " \ 127 "run mmcargs; " \ 128 "run common_bootargs; " \ 129 "run dump_bootargs; " \ 130 "run loadimage; " \ 131 "run loadfdt;\0 " \ 132 "mmcbootz=setenv bootfile zImage; " \ 133 "run mmcbootcommon; "\ 134 "bootz ${loadaddr} - ${fdtaddr}\0" \ 135 "mmcboot=setenv bootfile uImage; "\ 136 "run mmcbootcommon; "\ 137 "bootm ${loadaddr} - ${fdtaddr}\0" \ 138 "mmcrambootcommon=echo 'Booting kernel from MMC w/ramdisk...'; " \ 139 "run ramargs; " \ 140 "run common_bootargs; " \ 141 "run dump_bootargs; " \ 142 "run loadimage; " \ 143 "run loadfdt; " \ 144 "run loadramdisk\0" \ 145 "mmcramboot=setenv bootfile uImage; " \ 146 "run mmcrambootcommon; " \ 147 "bootm ${loadaddr} ${rdaddr} ${fdtaddr}\0" \ 148 "mmcrambootz=setenv bootfile zImage; " \ 149 "run mmcrambootcommon; " \ 150 "bootz ${loadaddr} ${rdaddr} ${fdtaddr}\0" \ 151 "tftpboot=echo 'Booting kernel/ramdisk rootfs from tftp...'; " \ 152 "run ramargs; " \ 153 "run common_bootargs; " \ 154 "run dump_bootargs; " \ 155 "tftpboot ${loadaddr} ${zimage}; " \ 156 "tftpboot ${rdaddr} ${ramdiskimage}; " \ 157 "bootm ${loadaddr} ${rdaddr}\0" \ 158 "tftpbootz=echo 'Booting kernel NFS rootfs...'; " \ 159 "dhcp;" \ 160 "run nfsargs;" \ 161 "run common_bootargs;" \ 162 "run dump_bootargs;" \ 163 "tftpboot $loadaddr zImage;" \ 164 "bootz $loadaddr\0" \ 165 "nandbootcommon=echo 'Booting kernel from NAND...';" \ 166 "run nandargs;" \ 167 "run common_bootargs;" \ 168 "run dump_bootargs;" \ 169 "nand read ${loadaddr} kernel;" \ 170 "nand read ${fdtaddr} spl-os;\0" \ 171 "nandbootz=run nandbootcommon; "\ 172 "bootz ${loadaddr} - ${fdtaddr}\0"\ 173 "nandboot=run nandbootcommon; "\ 174 "bootm ${loadaddr} - ${fdtaddr}\0"\ 175 176 #define CONFIG_BOOTCOMMAND \ 177 "run autoboot" 178 179 /* Miscellaneous configurable options */ 180 181 /* memtest works on */ 182 #define CONFIG_SYS_MEMTEST_START (OMAP34XX_SDRC_CS0) 183 #define CONFIG_SYS_MEMTEST_END (OMAP34XX_SDRC_CS0 + \ 184 0x01F00000) /* 31MB */ 185 186 /* FLASH and environment organization */ 187 188 /* **** PISMO SUPPORT *** */ 189 #if defined(CONFIG_CMD_NAND) 190 #define CONFIG_SYS_FLASH_BASE NAND_BASE 191 #endif 192 193 /* Monitor at start of flash */ 194 #define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_FLASH_BASE 195 196 #define CONFIG_ENV_SIZE (128 << 10) /* 128 KiB */ 197 198 #define CONFIG_SYS_ENV_SECT_SIZE (128 << 10) /* 128 KiB */ 199 #define CONFIG_ENV_OFFSET 0x260000 200 #define CONFIG_ENV_ADDR 0x260000 201 202 /* Defines for SPL */ 203 204 /* NAND: SPL falcon mode configs */ 205 #ifdef CONFIG_SPL_OS_BOOT 206 #define CONFIG_SYS_NAND_SPL_KERNEL_OFFS 0x280000 207 #endif 208 209 #endif /* __CONFIG_H */ 210