1*aee02b0fSDavid LechnerSitronix ST7586 display panel 2*aee02b0fSDavid Lechner 3*aee02b0fSDavid LechnerRequired properties: 4*aee02b0fSDavid Lechner- compatible: "lego,ev3-lcd". 5*aee02b0fSDavid Lechner- a0-gpios: The A0 signal (since this binding is for serial mode, this is 6*aee02b0fSDavid Lechner the pin labeled D1 on the controller, not the pin labeled A0) 7*aee02b0fSDavid Lechner- reset-gpios: Reset pin 8*aee02b0fSDavid Lechner 9*aee02b0fSDavid LechnerThe node for this driver must be a child node of a SPI controller, hence 10*aee02b0fSDavid Lechnerall mandatory properties described in ../spi/spi-bus.txt must be specified. 11*aee02b0fSDavid Lechner 12*aee02b0fSDavid LechnerOptional properties: 13*aee02b0fSDavid Lechner- rotation: panel rotation in degrees counter clockwise (0,90,180,270) 14*aee02b0fSDavid Lechner 15*aee02b0fSDavid LechnerExample: 16*aee02b0fSDavid Lechner display@0{ 17*aee02b0fSDavid Lechner compatible = "lego,ev3-lcd"; 18*aee02b0fSDavid Lechner reg = <0>; 19*aee02b0fSDavid Lechner spi-max-frequency = <10000000>; 20*aee02b0fSDavid Lechner a0-gpios = <&gpio 43 GPIO_ACTIVE_HIGH>; 21*aee02b0fSDavid Lechner reset-gpios = <&gpio 80 GPIO_ACTIVE_HIGH>; 22*aee02b0fSDavid Lechner }; 23