| /openbmc/linux/Documentation/networking/ |
| H A D | can_ucan_protocol.rst | 22 The driver sends device management commands on this endpoint
25 The device sends CAN data frames and CAN error frames
28 The driver sends CAN data frames on the out endpoint
303 error frames (see ``uapi/linux/can/error.h``) and sends it using the
318 - Once Bus OFF recover is completed the device sends an error frame
328 #) Host sends command ``UCAN_COMMAND_RESET``, subcmd 0
329 #) Host sends command ``UCAN_COMMAND_GET``, subcmd ``UCAN_COMMAND_GET_INFO``
330 #) Device sends ``UCAN_IN_DEVICE_INFO``
331 #) Host sends command ``UCAN_OUT_SET_BITTIMING``
332 #) Host sends command ``UCAN_COMMAND_START``, subcmd 0, mode ``UCAN_MODE_BERR_REPORT``
|
| /openbmc/linux/sound/soc/xilinx/ |
| H A D | Kconfig | 7 mode, IP receives audio in AES format, extracts PCM and sends
9 encapsulates PCM in AES format and sends AES data.
|
| /openbmc/linux/Documentation/sound/cards/ |
| H A D | serial-u16550.rst | 18 sends the nonstandard MIDI command sequence F5 NN, where NN is the substream
37 module parameter is automatically set to 1. The driver sends the same data to
49 the outs module parameter is automatically set to 1. The driver sends
62 Out 3, and midiCnD8 to Out 4. Thus midiCnD15 sends the data to all 4 ports.
63 As a special case, midiCnD0 also sends to all ports, since it is not useful
|
| /openbmc/qemu/docs/specs/ |
| H A D | ivshmem-spec.rst | 143 - sends the ID and the file descriptor for the shared memory to the
145 - sends connect notifications for the new client to the other clients
147 - sends connect notifications for the other clients to the new client,
149 - sends interrupt setup messages to the new client (these contain file
154 When a client disconnects from the server, the server sends disconnect
179 The connection is one-way: the server sends messages to the client.
187 On connect, the server sends the following messages in order:
214 From then on, the server sends these kinds of messages:
|
| /openbmc/docs/designs/ |
| H A D | power-systems-memory-preserving-reboot.md | 168 #### 8 - Hypervisor Formats dump and sends notification to BMC
170 Once the hypervisor is started, it formats the dump and sends a notification to
181 NBD device id. PLDM sends the offload request to the hypervisor with the dump
190 #### 11 - Hypervisor sends down offload complete message
192 Hypervisor sends down offload complete message to BMC and BMC sends it to HMC.
197 HMC verifies the dump and send dump delete request to BMC BMC sends the dump
|
| /openbmc/linux/Documentation/hid/ |
| H A D | intel-ish-hid.rst | 194 independent. The sending side sends DMA_XFER message when the message is in
195 the respective host buffer (TX when host client sends, RX when FW client
196 sends). The recipient of DMA message responds with DMA_XFER_ACK, indicating
205 Here ISH acts as busmaster DMA controller. Hence when host sends DMA_XFER,
206 it's request to do host->ISH DMA transfer; when FW sends DMA_XFER, it means
243 - Host sends HOST_START_REQ_CMD, indicating that host ISHTP layer is up.
245 - Host sends HOST_ENUM_REQ_CMD (enumerate FW clients)
248 - For each FW ID found in that bitmap host sends
|
| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | debugfs-cxl | 7 attribute, the memdev driver sends an inject poison command to
28 attribute, the memdev driver sends a clear poison command to
|
| /openbmc/openbmc-test-automation/lib/ |
| H A D | bmc_network_security_utils.robot | 23 # By default it sends 4 ICMP echo request packets at 1 packets/second.
49 # By default it sends 4 ICMP echo request packets at 1 packets/second.
|
| /openbmc/linux/Documentation/driver-api/mei/ |
| H A D | iamt.rst | 45 When a local application sends a message addressed to the local Intel AMT host
89 and sends an event when the heartbeats stop.
91 configures the watchdog and sends the heartbeats.
|
| H A D | hdcp.rst | 11 according the HDCP 2.2 spec. The Intel graphics sends the created blob
|
| /openbmc/linux/Documentation/misc-devices/ |
| H A D | ibmvmc.rst | 152 RDMA of the HMC ID to the hypervisor, and then sends an Interface Open
154 hypervisor receives this information, it sends Add Buffer messages to the
156 connection. Finally, the hypervisor sends an Interface Open Response
181 and then sends a Signal Message. If a write() is attempted before VMC
185 state. When the hypervisor sends a message to the management, the data is
|
| /openbmc/linux/Documentation/admin-guide/ |
| H A D | edid.rst | 18 - The monitor sends no or bogus EDID data.
19 - A KVM sends its own EDID data instead of querying the connected monitor.
|
| /openbmc/linux/Documentation/userspace-api/media/v4l/ |
| H A D | vidioc-encoder-cmd.rst | 39 ``VIDIOC_ENCODER_CMD`` sends a command to the encoder,
57 call sends an implicit START command to the encoder if it has not been
61 call of a streaming file descriptor sends an implicit immediate STOP to
|
| /openbmc/libmctp/docs/bindings/ |
| H A D | vendor-ibm-astlpc.md | 311 The host sends commands to the BMC to signal channel initialisation, begin
324 The BMC sends commands to the host to begin transmission of a packet or to
337 The BMC sends status updates to the host to signal loss of function, loss of
365 2. The Tx side sends a `Tx Begin` message, indicating that the buffer ownership
368 4. The Rx side sends a `Rx Complete` once done, indicating that the buffer
399 | 4 | ✓ | ✓ | ✓ | The host sends the `Initialise` command …
415 | 4 | ✓ | ✓ | ✓ | The host sends the `Tx Begin` command, transferring ownership of its Tx …
418 | 7 | ✓ | ✓ | ✓ | The BMC sends the `Rx Complete` command, transferring ownership of its R…
429 | 4 | ✓ | ✓ | ✓ | The BMC sends the `Tx Begin` command, transferring ownership of its Tx b…
432 | 7 | ✓ | ✓ | ✓ | The host sends the `Rx Complete` command, transferring ownership of its …
|
| /openbmc/linux/Documentation/arch/sparc/ |
| H A D | adi.rst | 105 first. Hypervisor creates a sun4v error report and sends a
106 resumable error (TT=0x7e) trap to the kernel. The kernel sends
125 exception is sent to the kernel with TT=0x1a. The kernel sends
143 on a memory address, processor sends an MCD disabled trap. This
147 sends the task SIGSEGV signal with following info::
|
| /openbmc/linux/Documentation/staging/ |
| H A D | rpmsg.rst | 73 sends a message across to the remote processor on a given channel.
92 sends a message across to the remote processor on a given channel,
117 sends a message across to the remote processor, using the src and dst
139 sends a message across to the remote processor on a given channel.
156 sends a message across to the remote processor on a given channel,
178 sends a message across to the remote processor, using source and
263 The following is a simple rpmsg driver, that sends an "hello!" message
|
| /openbmc/openbmc/meta-openembedded/meta-networking/recipes-connectivity/ez-ipupdate/ |
| H A D | ez-ipupdate_3.0.11b7.bb | 1 SUMMARY = "daemon that sends updates when your IP changes"
|
| /openbmc/linux/drivers/hwtracing/stm/ |
| H A D | Kconfig | 54 This is a kernel space trace source that sends kernel log
63 This is a kernel space trace source that sends periodic
|
| /openbmc/linux/Documentation/driver-api/md/ |
| H A D | md-cluster.rst | 240 performing resync finishes, it sends RESYNCING with an empty range to
263 2. Node 1 sends a NEWDISK message with uuid and slot number
275 8. If node 1 gets the lock, it sends METADATA_UPDATED after
277 9. If not (get "no-new-dev" lock), it fails the operation and sends
319 resync_finish() also sends a BITMAP_NEEDS_SYNC message which
367 This sends a RE_ADD message to all other nodes and then
|
| /openbmc/linux/Documentation/devicetree/bindings/display/ |
| H A D | snps,arcpgu.txt | 5 framebuffer and sends it to a single digital encoder (usually HDMI).
|
| /openbmc/linux/Documentation/virt/hyperv/ |
| H A D | vmbus.rst | 114 * Unidirectional: Either side sends a message and does not
116 * Request/response: One side (usually the guest) sends a message
122 sending a request. Hyper-V sends back the same transactionID in the
173 ring buffer transitions from empty to non-empty. If the guest sends
175 unnecessary. If a guest sends an excessive number of unnecessary
179 Similarly, the host will interrupt the guest when it sends a new
258 The guest then tells Hyper-V to "send offers". Hyper-V sends an
|
| /openbmc/linux/fs/notify/fanotify/ |
| H A D | Kconfig | 9 notification system which differs from inotify in that it sends
|
| /openbmc/linux/Documentation/driver-api/ |
| H A D | ipmb.rst | 19 sends IPMI requests to a device (usually a Satellite Management
21 sends a response back to the BMC.
|
| /openbmc/linux/Documentation/networking/device_drivers/ethernet/marvell/ |
| H A D | octeon_ep.rst | 34 Octeon device processes them. The firmware also sends unsolicited notifications
|
| /openbmc/linux/scripts/kconfig/tests/preprocess/builtin_func/ |
| H A D | Kconfig | 6 # 'warning-if', if the first argument is y, sends the second argument to stderr,
|