Home
last modified time | relevance | path

Searched refs:multiplexer (Results 1 – 25 of 70) sorted by relevance

123

/openbmc/linux/drivers/i2c/muxes/
H A DKconfig23 tristate "GPIO-based I2C multiplexer"
27 GPIO based I2C multiplexer. This driver provides access to
35 tristate "General Purpose I2C multiplexer"
40 general purpose I2C multiplexer. This driver provides access to
48 tristate "LTC LTC4306/5 I2C multiplexer"
78 tristate "pinctrl-based I2C multiplexer"
83 multiplexer that uses the pinctrl subsystem, i.e. pin multiplexing.
91 tristate "Register-based I2C multiplexer"
95 register based I2C multiplexer. This driver provides access to
112 tristate "Mellanox CPLD based I2C multiplexer"
[all …]
/openbmc/u-boot/doc/device-tree-bindings/i2c/
H A Di2c-mux.txt1 Common i2c bus multiplexer/switch properties.
3 An i2c bus multiplexer/switch will have several child busses that are
5 multiplexer/switch will have one child node for each child
18 - Other properties specific to the multiplexer/switch hardware.
25 An NXP pca9548 8 channel I2C multiplexer at address 0x70
/openbmc/linux/drivers/mux/
H A DKconfig28 ADGS1408 8:1 multiplexer and ADGS1409 double 4:1 multiplexer
40 The driver builds a single multiplexer controller using a number
41 of gpio pins. For N pins, there will be 2^N possible multiplexer
54 The driver builds multiplexer controllers for bitfields in either
56 bitfields, there will be 2^N possible multiplexer states.
/openbmc/linux/drivers/net/mdio/
H A DKconfig222 tristate "Amlogic G12a based MDIO bus multiplexer"
228 This module provides a driver for the MDIO multiplexer/glue of
233 tristate "Amlogic GXL based MDIO bus multiplexer"
239 This module provides a driver for the MDIO multiplexer/glue of
240 the amlogic GXL SoC. The multiplexer connects either the external
250 BCM6368 based Broadcom SoCs. This multiplexer connects one of several
252 external and selection logic lies inside the same multiplexer.
261 iProc based Broadcom SoCs. This multiplexer connects one of several
263 external and selection logic lies inside the same multiplexer.
271 are controlled via GPIO lines. The multiplexer connects one of
[all …]
H A DMakefile34 obj-$(CONFIG_MDIO_BUS_MUX_MULTIPLEXER) += mdio-mux-multiplexer.o
/openbmc/linux/Documentation/devicetree/bindings/iio/adc/
H A Dxilinx-xadc.txt38 * "none": No external multiplexer is used, this is the default
40 * "single": External multiplexer mode is used with one
41 multiplexer.
42 * "dual": External multiplexer mode is used with two
46 Valid values for single external multiplexer mode are:
52 Valid values for dual external multiplexer mode are:
59 external multiplexer mode (either single or dual). If the device is
60 not using external multiplexer mode the property is ignored.
/openbmc/qemu/docs/system/
H A Dmux-chardev.rst1 .. _keys in the character backend multiplexer:
3 Keys in the character backend multiplexer
H A Dmux-chardev.rst.inc1 During emulation, if you are using a character backend multiplexer
23 Rotate between the frontends connected to the multiplexer (usually
/openbmc/linux/drivers/iio/multiplexer/
H A DKconfig10 tristate "IIO multiplexer driver"
13 Say yes here to build support for the IIO multiplexer.
/openbmc/u-boot/drivers/i2c/muxes/
H A DKconfig33 I2C mux/switch devices. It is x width I2C multiplexer which enables to
39 tristate "GPIO-based I2C multiplexer"
43 a GPIO based I2C multiplexer. This driver provides access to
/openbmc/linux/Documentation/hwmon/
H A Dda9055.rst18 multiplexer. The analogue input multiplexer will allow conversion of up to 5
H A Dda9052.rst19 multiplexer. The analogue input multiplexer will allow conversion of up to 10
/openbmc/linux/Documentation/devicetree/bindings/display/imx/
H A Dldb.txt14 multiplexer in the front to select any of the four IPU display
55 On i.MX5, the internal two-input-multiplexer is used. Due to hardware
59 to the four LVDS multiplexer inputs.
/openbmc/openbmc/meta-google/recipes-google/ncsi/files/
H A Dgbmc-ncsi-sslh.service2 Description=SSL/SSH multiplexer
/openbmc/linux/Documentation/devicetree/bindings/i2c/
H A Di2c-mux-reg.txt3 This binding describes an I2C bus multiplexer that uses a single register
8 - i2c-parent: The phandle of the I2C bus that this multiplexer's master-side
/openbmc/linux/drivers/gpu/vga/
H A DKconfig10 Many laptops released in 2008/9/10 have two GPUs with a multiplexer
/openbmc/openbmc/meta-openembedded/meta-oe/recipes-extended/tmux/
H A Dtmux_3.5.bb1 SUMMARY = "Terminal multiplexer"
/openbmc/linux/drivers/iio/
H A DMakefile37 obj-y += multiplexer/
/openbmc/linux/Documentation/devicetree/bindings/clock/
H A Dmicrochip,pic32.txt3 Microchip clock controller is consists of few oscillators, PLL, multiplexer
/openbmc/linux/Documentation/ABI/testing/
H A Dsysfs-bus-i2c-devices-pca954x7 written to control the behaviour of the multiplexer on
/openbmc/linux/arch/arm64/boot/dts/freescale/
H A Dfsl-lx2160a-qds.dts36 compatible = "mdio-mux-multiplexer";
104 compatible = "mdio-mux-multiplexer";
H A Dfsl-lx2162a-qds.dts34 compatible = "mdio-mux-multiplexer";
114 compatible = "mdio-mux-multiplexer";
/openbmc/linux/Documentation/devicetree/bindings/clock/st/
H A Dst,clkgen.txt4 A Clockgen node can contain pll, diviser or multiplexer nodes.
/openbmc/linux/drivers/usb/roles/
H A DKconfig9 multiplexer/demultiplexer switch is used to route the data lines on
/openbmc/linux/Documentation/devicetree/bindings/clock/ti/
H A Dcomposite.txt8 a multiplexer clock with multiple input clock signals or parents, one

123