| /openbmc/linux/drivers/mtd/nand/raw/ |
| H A D | nand_micron.c | 84 struct nand_onfi_vendor_micron *micron = (void *)p->onfi->vendor; in micron_nand_onfi_init() local
86 chip->read_retries = micron->read_retry_options; in micron_nand_onfi_init()
168 struct micron_nand *micron = nand_get_manufacturer_data(chip); in micron_nand_on_die_ecc_setup() local
172 if (micron->ecc.forced) in micron_nand_on_die_ecc_setup()
175 if (micron->ecc.enabled == enable) in micron_nand_on_die_ecc_setup()
183 micron->ecc.enabled = enable; in micron_nand_on_die_ecc_setup()
192 struct micron_nand *micron = nand_get_manufacturer_data(chip); in micron_nand_on_die_ecc_status_4() local
242 ret = nand_read_page_op(chip, page, 0, micron->ecc.rawbuf, in micron_nand_on_die_ecc_status_4()
252 rawbuf = micron->ecc.rawbuf + offs; in micron_nand_on_die_ecc_status_4()
259 rawbuf = micron->ecc.rawbuf + mtd->writesize + offs; in micron_nand_on_die_ecc_status_4()
[all …]
|
| /openbmc/linux/Documentation/devicetree/bindings/media/i2c/ |
| H A D | mt9m111.txt | 8 - compatible: value should be "micron,mt9m111"
25 compatible = "micron,mt9m111";
|
| /openbmc/u-boot/arch/arm/dts/ |
| H A D | imx6sx-sdb.dts | 118 compatible = "micron,n25q256a", "jedec,spi-nor";
126 compatible = "micron,n25q256a", "jedec,spi-nor";
|
| H A D | imx6sx-sabreauto.dts | 108 compatible = "micron,n25q256a";
116 compatible = "micron,n25q256a";
|
| H A D | zynq-minized.dts | 45 compatible = "micron,m25p128";
|
| /openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6sx-sdb.dts | 114 compatible = "micron,n25q256a", "jedec,spi-nor";
124 compatible = "micron,n25q256a", "jedec,spi-nor";
|
| /openbmc/u-boot/drivers/mtd/nand/spi/ |
| H A D | Makefile | 3 spinand-objs := core.o gigadevice.o macronix.o micron.o winbond.o
|
| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | sysfs-block-rssd | 4 Contact: Asai Thambi S P <asamymuthupa@micron.com>
|
| /openbmc/linux/drivers/mtd/nand/spi/ |
| H A D | Makefile | 3 spinand-objs += micron.o paragon.o toshiba.o winbond.o xtx.o
|
| /openbmc/u-boot/board/advantech/dms-ba16/ |
| H A D | dms-ba16_1g.cfg | 23 #include "micron-1g.cfg"
|
| /openbmc/linux/arch/arm/boot/dts/intel/socfpga/ |
| H A D | socfpga_arria10_socdk_qspi.dts | 15 compatible = "micron,mt25qu02g", "jedec,spi-nor";
|
| H A D | socfpga_cyclone5_vining_fpga.dts | 227 compatible = "micron,n25q128", "jedec,spi-nor";
244 compatible = "micron,mt25qu02g", "jedec,spi-nor";
|
| H A D | socfpga_cyclone5_socrates.dts | 83 compatible = "micron,n25q256a", "jedec,spi-nor";
|
| H A D | socfpga_cyclone5_sodia.dts | 119 compatible = "micron,n25q512a", "jedec,spi-nor";
|
| /openbmc/linux/arch/arm/boot/dts/ti/omap/ |
| H A D | am335x-sancloud-bbe-lite.dts | 44 compatible = "micron,spi-authenta";
|
| /openbmc/linux/drivers/mtd/spi-nor/ |
| H A D | Makefile | 14 spi-nor-objs += micron-st.o
|
| /openbmc/linux/arch/arm/boot/dts/qcom/ |
| H A D | qcom-ipq4019-ap.dk07.1-c1.dts | 60 compatible = "micron,n25q128a11", "jedec,spi-nor";
|
| H A D | qcom-ipq4019-ap.dk04.1.dtsi | 96 compatible = "micron,n25q128a11", "jedec,spi-nor";
|
| /openbmc/u-boot/doc/device-tree-bindings/spi/ |
| H A D | spi-stm32-qspi.txt | 32 compatible = "micron,n25q128a13", "spi-flash";
|
| /openbmc/linux/arch/arm64/boot/dts/qcom/ |
| H A D | ipq6018-cp01-c1.dts | 46 compatible = "micron,n25q128a11", "jedec,spi-nor";
|
| H A D | ipq5332-rdp468.dts | 23 compatible = "micron,n25q128a11", "jedec,spi-nor";
|
| H A D | ipq5332-rdp442.dts | 30 compatible = "micron,n25q128a11", "jedec,spi-nor";
|
| H A D | ipq9574-rdp449.dts | 32 compatible = "micron,n25q128a11", "jedec,spi-nor";
|
| H A D | ipq9574-rdp453.dts | 32 compatible = "micron,n25q128a11", "jedec,spi-nor";
|
| H A D | ipq9574-rdp454.dts | 32 compatible = "micron,n25q128a11", "jedec,spi-nor";
|