/openbmc/linux/Documentation/devicetree/bindings/power/supply/ |
H A D | max8925_battery.txt | 5 - batt-detect: whether support battery detect 8 - no-temp-support: whether support temperature protection detect 9 - no-insert-detect: whether support insert detect 13 batt-detect = <0>; 17 no-insert-detect = <0>;
|
/openbmc/linux/Documentation/devicetree/bindings/sound/ |
H A D | rt5640.txt | 38 - realtek,jack-detect-source 40 0: jack-detect is not used 41 1: Use GPIO1 for jack-detect 42 2: Use JD1_IN4P for jack-detect 43 3: Use JD2_IN4N for jack-detect 44 4: Use GPIO2 for jack-detect 45 5: Use GPIO3 for jack-detect 46 6: Use GPIO4 for jack-detect 48 - realtek,jack-detect-not-inverted 49 bool. Normal jack-detect switches give an inverted signal, set this bool [all …]
|
H A D | rt5651.txt | 19 - realtek,jack-detect-source 21 1: Use JD1_1 pin for jack-detect 22 2: Use JD1_2 pin for jack-detect 23 3: Use JD2 pin for jack-detect 25 - realtek,jack-detect-not-inverted 26 bool. Normal jack-detect switches give an inverted (active-low) signal, 27 set this bool in the rare case you've a jack-detect switch which is not
|
H A D | st,sta32x.txt | 46 - st,fault-detect-recovery: 47 If present, fault detect recovery is enabled. 52 - st,fault-detect-recovery: 78 - st,invalid-input-detect-mute: 79 If present, automatic invalid input detect mute is enabled. 99 st,invalid-input-detect-mute; // mute if no valid digital
|
H A D | rt5645.txt | 19 - hp-detect-gpios: 20 a GPIO spec for the external headphone detect pin. If jd-mode = 0, 21 we will get the JD status by getting the value of hp-detect-gpios. 75 hp-detect-gpios = <&gpio 19 0>;
|
/openbmc/openbmc/meta-facebook/meta-bletchley/recipes-bletchley/detect-gpio-present/ |
H A D | detect-sled-present_0.1.bb | 15 SRC_URI = " file://detect-sled-present \ 16 file://detect-sled-present@.service \ 23 install -m 0755 ${UNPACKDIR}/detect-sled-present ${D}${bindir}/ 26 install -m 0644 ${UNPACKDIR}/detect-sled-present@.service ${D}${systemd_system_unitdir} 33 SLED_PRESENT_INSTFMT="../detect-sled-present@.service:${TGT}.wants/detect-sled-present@{0}.service" 34 SYSTEMD_SERVICE:${PN} += "detect-sled-present@.service"
|
/openbmc/openbmc/meta-quanta/meta-gbs/recipes-gbs/gbs-detect-gpio-present/ |
H A D | gbs-detect-gpio-present.bb | 12 SRC_URI = " file://detect-gpio-present.sh \ 13 file://detect-gpio-present.service \ 18 install -m 0755 ${UNPACKDIR}/detect-gpio-present.sh ${D}${bindir}/ 21 install -m 0644 ${UNPACKDIR}/detect-gpio-present.service ${D}${systemd_system_unitdir} 25 SYSTEMD_SERVICE:${PN} = "detect-gpio-present.service"
|
/openbmc/linux/Documentation/devicetree/bindings/net/ |
H A D | smsc-lan87xx.txt | 12 - smsc,disable-energy-detect: 13 If set, do not enable energy detect mode for the SMSC phy. 14 default: enable energy detect mode 17 smsc phy with disabled energy detect mode on an am335x based board. 25 smsc,disable-energy-detect;
|
/openbmc/openbmc/meta-security/recipes-ids/suricata/files/ |
H A D | CVE-2024-38535.patch | 17 rust/src/http2/detect.rs | 8 ++++---- 20 diff --git a/rust/src/http2/detect.rs b/rust/src/http2/detect.rs 22 --- a/rust/src/http2/detect.rs 23 +++ b/rust/src/http2/detect.rs
|
/openbmc/linux/sound/firewire/digi00x/ |
H A D | digi00x-proc.c | 42 bool detect; in proc_read_clock() local 58 if (snd_dg00x_stream_check_external_clock(dg00x, &detect) < 0) in proc_read_clock() 60 snd_iprintf(buf, "External source: %s\n", detect ? "detected" : "not"); in proc_read_clock() 61 if (!detect) in proc_read_clock()
|
/openbmc/linux/drivers/gpu/drm/ |
H A D | drm_privacy_screen_x86.c | 17 bool (*detect)(void); member 68 .detect = detect_thinkpad_privacy_screen, 78 .detect = detect_chromeos_privacy_screen, 88 if (!arch_init_data[i].detect()) in drm_privacy_screen_lookup_init()
|
H A D | drm_bridge_connector.c | 161 struct drm_bridge *detect = bridge_connector->bridge_detect; in drm_bridge_connector_detect() local 164 if (detect) { in drm_bridge_connector_detect() 165 status = detect->funcs->detect(detect); in drm_bridge_connector_detect() 218 .detect = drm_bridge_connector_detect,
|
/openbmc/linux/drivers/input/mouse/ |
H A D | psmouse-base.c | 729 .detect = ps2bare_detect, 737 .detect = ps2pp_detect, 744 .detect = thinking_detect, 751 .detect = cypress_detect, 759 .detect = genius_detect, 767 .detect = intellimouse_detect, 776 .detect = im_explorer_detect, 784 .detect = synaptics_detect, 791 .detect = synaptics_detect, 800 .detect = synaptics_detect, [all …]
|
/openbmc/linux/Documentation/driver-api/media/drivers/ |
H A D | radiotrack.rst | 129 Default: BASE <-- 0xc8 (current volume, no stereo detect, 132 Card Off: BASE <-- 0x00 (audio mute, no stereo detect, 138 Volume Down: BASE <-- 0x48 (volume down, no stereo detect, 143 Volume Up: BASE <-- 0x88 (volume up, no stereo detect, 148 Check Stereo: BASE <-- 0xd8 (current volume, stereo detect, 160 BASE <-- 0x01 (audio mute, no stereo detect, radio 162 BASE <-- 0x03 (audio mute, no stereo detect, radio 165 BASE <-- 0x05 (audio mute, no stereo detect, radio 167 BASE <-- 0x07 (audio mute, no stereo detect, radio
|
/openbmc/u-boot/board/boundary/nitrogen6x/ |
H A D | nitrogen6x.c | 510 .detect = detect_i2c, 530 .detect = NULL, 550 .detect = NULL, 570 .detect = detect_i2c, 590 .detect = NULL, 610 .detect = detect_i2c, 630 .detect = detect_i2c, 650 .detect = NULL, 670 .detect = detect_i2c, 690 .detect = 0, [all …]
|
/openbmc/linux/drivers/usb/common/ |
H A D | Kconfig | 23 of registers that can be used to detect the vendor and product which 46 to detect USB ID pin, and another input GPIO may be also used to detect 48 device if an input GPIO is only used to detect Vbus pin.
|
/openbmc/openbmc/meta-facebook/meta-ventura/recipes-phosphor/gpio/phosphor-gpio-monitor/ |
H A D | led-amber-deassert@.service | 5 ExecStart=/usr/libexec/phosphor-gpio-monitor/frontled "%i leak detect deassert" "BLADE" "%i" 6 SyslogIdentifier=%i-leak-detect-deassert
|
H A D | led-blue-assert@.service | 5 ExecStart=/usr/libexec/phosphor-gpio-monitor/frontled "%i leak detect assert" "BLADE" "%i" 6 SyslogIdentifier=%i-leak-detect-assert
|
H A D | led-blue-deassert@.service | 5 ExecStart=/usr/libexec/phosphor-gpio-monitor/frontled "%i leak detect deassert" "BLADE" "%i" 6 SyslogIdentifier=%i-leak-detect-deassert
|
H A D | led-amber-assert@.service | 5 ExecStart=/usr/libexec/phosphor-gpio-monitor/frontled "%i leak detect assert" "BLADE" "%i" 6 SyslogIdentifier=%i-leak-detect-assert
|
/openbmc/linux/drivers/char/ipmi/ |
H A D | ipmi_poweroff.c | 514 int (*detect)(struct ipmi_user *user); member 520 .detect = ipmi_atca_detect, 523 .detect = ipmi_cpi1_detect, 526 .detect = ipmi_dell_chassis_detect, 529 .detect = ipmi_hp_chassis_detect, 534 .detect = ipmi_chassis_detect, 612 if (poweroff_functions[i].detect(ipmi_user)) in ipmi_po_new_smi()
|
/openbmc/linux/Documentation/ABI/testing/ |
H A D | sysfs-class-power-rt9471 | 24 This entry allows enabling the USB BC12 port detect function of rt9471 charger 26 port detect and report the usb port type when port detect is done. See
|
/openbmc/openbmc/meta-facebook/meta-ventura/recipes-phosphor/gpio/ |
H A D | phosphor-gpio-monitor_%.bbappend | 7 critical-leak-detect-assert@.service \ 8 leak-detect-assert@.service \ 9 leak-detect-deassert@.service \
|
/openbmc/linux/arch/arm/boot/dts/st/ |
H A D | stih410-pinctrl.dtsi | 15 usb-oc-detect = <&pio35 0 ALT1 IN>; 24 usb-oc-detect = <&pio35 2 ALT1 IN>;
|
/openbmc/openbmc/meta-openembedded/meta-oe/recipes-gnome/gmime/ |
H A D | gmime_3.2.15.bb | 12 file://iconv-detect.h \ 25 cp ${UNPACKDIR}/iconv-detect.h ${S}
|