| /openbmc/linux/Documentation/devicetree/bindings/misc/ |
| H A D | xlnx,sd-fec.txt | 29 configures the DIN_WORDS to be block based, while a value of 2 configures the
32 configures a width of "1x128b", 2 a width of "2x128b" and 4 configures a width
36 configures the DOUT_WORDS to be block based, while a value of 2 configures the
39 configures a width of "1x128b", 2 a width of "2x128b" and 4 configures a width
|
| /openbmc/linux/Documentation/userspace-api/media/drivers/ |
| H A D | max2175.rst | 52 - This configures FM band with a sample rate of 0.512 million
55 - This configures VHF band with a sample rate of 2.048 million
60 - This configures FM band with a sample rate of 0.7441875 million
63 - This configures FM band with a sample rate of 0.372 million
|
| H A D | imx-uapi.rst | 97 V4L2_CID_IMX_FIM_ICAP_CHANNEL configures which i.MX6 input capture
100 V4L2_CID_IMX_FIM_ICAP_EDGE configures which signal edge will trigger
|
| /openbmc/linux/drivers/thermal/mediatek/ |
| H A D | Kconfig | 18 This driver configures thermal controllers to collect
27 This driver configures LVTS (Low Voltage Thermal Sensor)
|
| /openbmc/linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | fsl,imx27-pinctrl.txt | 32 gpio_oconf configures the gpio submodule output signal. This does not
43 gpio_iconfa/b configures the gpio submodule input to functionblocks A and
|
| /openbmc/openbmc-test-automation/systest/ |
| H A D | test_boot_acceptance.robot | 29 # Script that configures every network port when connected to a loop. This
38 # This configures the cron to reboot the system and re-run the HTX profile.
|
| /openbmc/openbmc/poky/meta/recipes-extended/parted/files/ |
| H A D | autoconf-2.73.patch | 17 # or configures them incorrectly in some cases.
|
| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-filter-admv8818 | 17 This attribute configures the filter mode.
|
| /openbmc/linux/Documentation/devicetree/bindings/usb/ |
| H A D | maxim,max3421.txt | 11 The driver configures MAX3421E for active low level triggered interrupts,
|
| /openbmc/openbmc/poky/meta/recipes-extended/gperf/ |
| H A D | gperf_3.1.bb | 17 # The nested configures don't find the parent aclocal.m4 out of the box, so tell
|
| /openbmc/openbmc/poky/meta/recipes-devtools/bison/bison/ |
| H A D | autoconf-2.73.patch | 19 # or configures them incorrectly in some cases.
|
| /openbmc/linux/Documentation/devicetree/bindings/hwmon/ |
| H A D | lm87.txt | 10 - has-temp3: This configures pins 18 and 19 to be used as a second
|
| /openbmc/linux/Documentation/devicetree/bindings/net/can/ |
| H A D | ti_hecc.txt | 16 - ti,use-hecc1int: if provided configures HECC to produce all interrupts
|
| /openbmc/linux/drivers/clk/xilinx/ |
| H A D | Kconfig | 10 register set. This driver also configures the frequency based on the
|
| /openbmc/linux/arch/arm/boot/dts/marvell/ |
| H A D | armada-388-clearfog-base.dts | 49 * Annoyingly, the marvell phy driver configures the LED
|
| /openbmc/u-boot/doc/ |
| H A D | README.video | 60 time for the monitor to assert the HPD signal. This configures how long to
71 This configures a black border on the left and right resp. top and bottom
|
| /openbmc/linux/Documentation/devicetree/bindings/gpio/ |
| H A D | gpio-mm-lantiq.txt | 4 only gpios. This driver configures a special memory address, which when
|
| /openbmc/u-boot/board/toradex/apalis_imx6/ |
| H A D | Kconfig | 48 This option configures DCE mode unconditionally. Whithout this
|
| /openbmc/linux/Documentation/hwmon/ |
| H A D | max6620.rst | 27 The driver configures the fan controller in RPM mode. To give the readings more
|
| /openbmc/linux/drivers/phy/intel/ |
| H A D | Kconfig | 39 This driver configures ComboPhy subsystem on Intel gateway
|
| /openbmc/linux/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe/ |
| H A D | par_io.txt | 3 This node configures Parallel I/O ports for CPUs with QE support.
|
| /openbmc/linux/Documentation/virt/acrn/ |
| H A D | introduction.rst | 35 ACRN userspace allocates memory for the User VM, configures and initializes the
|
| /openbmc/linux/Documentation/ABI/removed/ |
| H A D | sysfs-mce | 21 configures how hard the kernel tries to recover even at some
|
| /openbmc/linux/Documentation/networking/dsa/ |
| H A D | lan9303.rst | 20 At startup the driver configures the device to provide two separate network
|
| /openbmc/openbmc/meta-phosphor/recipes-phosphor/configuration/ |
| H A D | entity-manager_git.bb | 3 and configures system sensors"
|