| /openbmc/linux/drivers/soc/renesas/ |
| H A D | r9a06g032-smp.c | 55 u32 bootaddr; in r9a06g032_smp_prepare_cpus() local
73 bootaddr = temp; in r9a06g032_smp_prepare_cpus()
77 &bootaddr); in r9a06g032_smp_prepare_cpus()
85 pr_info("CPU#1: cpu-release-addr %08x\n", bootaddr); in r9a06g032_smp_prepare_cpus()
87 cpu_bootaddr = ioremap(bootaddr, sizeof(bootaddr)); in r9a06g032_smp_prepare_cpus()
|
| /openbmc/u-boot/disk/ |
| H A D | part_iso.c | 54 unsigned long newblkaddr,blkaddr,lastsect,bootaddr; in part_get_info_iso_verb() local
103 bootaddr = get_unaligned_le32(pbr->pointer); in part_get_info_iso_verb()
104 PRINTF(" Boot Entry at: %08lX\n",bootaddr); in part_get_info_iso_verb()
105 if (iso_dread(dev_desc, bootaddr, 1, (ulong *)tmpbuf) != 1) { in part_get_info_iso_verb()
108 bootaddr, dev_desc->devnum, part_num); in part_get_info_iso_verb()
|
| /openbmc/linux/arch/arm/mach-mstar/ |
| H A D | mstarv7.c | 77 u32 bootaddr = (u32) __pa_symbol(secondary_startup_arm); in mstarv7_boot_secondary() local
94 writew(bootaddr & 0xffff, smpctrl + MSTARV7_CPU1_BOOT_ADDR_LOW); in mstarv7_boot_secondary()
95 writew((bootaddr >> 16) & 0xffff, smpctrl + MSTARV7_CPU1_BOOT_ADDR_HIGH); in mstarv7_boot_secondary()
|
| /openbmc/u-boot/cmd/ |
| H A D | elf.c | 332 unsigned long bootaddr = 0; /* Address to put the bootline */ in do_bootvx() local
429 bootaddr = base + X86_BOOT_LINE_OFFSET; in do_bootvx()
436 if (!bootaddr) in do_bootvx()
437 bootaddr = simple_strtoul(tmp, NULL, 16); in do_bootvx()
497 memcpy((void *)bootaddr, bootline, max(strlen(bootline), (size_t)255)); in do_bootvx()
498 flush_cache(bootaddr, max(strlen(bootline), (size_t)255)); in do_bootvx()
499 printf("## Using bootline (@ 0x%lx): %s\n", bootaddr, (char *)bootaddr); in do_bootvx()
|
| /openbmc/u-boot/doc/ |
| H A D | README.vxworks | 45 via "bootaddr" environment variable. To check where the bootline should be
47 parameter called BOOT_LINE_ADRS. Assign its value to "bootaddr". A typical
48 value for "bootaddr" on an x86 board is 0x101200.
51 location pointed by "bootaddr" as the kernel bootline. If "bootargs" is not
|
| /openbmc/linux/drivers/remoteproc/ |
| H A D | rcar_rproc.c | 113 if (!rproc->bootaddr) in rcar_rproc_start()
116 err = rcar_rst_set_rproc_boot_addr(rproc->bootaddr); in rcar_rproc_start()
|
| H A D | da8xx_remoteproc.c | 142 if (rproc->bootaddr & 0x3ff) { in da8xx_rproc_start()
148 writel(rproc->bootaddr, drproc->bootreg); in da8xx_rproc_start()
|
| H A D | remoteproc_coredump.c | 284 elf_hdr_set_e_entry(class, ehdr, rproc->bootaddr); in rproc_coredump()
403 elf_hdr_set_e_entry(class, ehdr, rproc->bootaddr); in rproc_coredump_using_sections()
|
| H A D | st_remoteproc.c | 172 ddata->config->bootaddr_mask, rproc->bootaddr); in st_rproc_start()
196 dev_info(&rproc->dev, "Started from 0x%llx\n", rproc->bootaddr); in st_rproc_start()
|
| H A D | omap_remoteproc.c | 575 if (rproc->bootaddr & (SZ_1K - 1)) { in omap_rproc_write_dsp_boot_addr()
577 rproc->bootaddr); in omap_rproc_write_dsp_boot_addr()
581 value = rproc->bootaddr >> bdata->boot_reg_shift; in omap_rproc_write_dsp_boot_addr()
|
| H A D | xlnx_r5_remoteproc.c | 354 bootmem = (rproc->bootaddr >= 0xFFFC0000) ? in zynqmp_r5_rproc_start()
357 dev_dbg(r5_core->dev, "RPU boot addr 0x%llx from %s.", rproc->bootaddr, in zynqmp_r5_rproc_start()
|
| H A D | keystone_remoteproc.c | 192 ret = keystone_rproc_dsp_boot(ksproc, rproc->bootaddr); in keystone_rproc_start()
|
| H A D | pru_rproc.c | 605 names[pru->data->type], pru->id, (rproc->bootaddr >> 2)); in pru_rproc_start()
617 val = CTRL_CTRL_EN | ((rproc->bootaddr >> 2) << 16); in pru_rproc_start()
|
| H A D | imx_dsp_rproc.c | 334 rproc->bootaddr); in imx_dsp_rproc_start()
374 rproc->bootaddr); in imx_dsp_rproc_stop()
|
| H A D | qcom_q6v5_wcss.c | 273 writel(rproc->bootaddr >> 4, wcss->reg_base + Q6SS_RST_EVB); in q6v5_wcss_start()
476 writel(rproc->bootaddr >> 4, wcss->reg_base + Q6SS_RST_EVB); in q6v5_qcs404_wcss_start()
|
| H A D | ti_k3_dsp_remoteproc.c | 322 boot_addr = rproc->bootaddr; in k3_dsp_rproc_start()
|
| H A D | ti_k3_r5_remoteproc.c | 558 boot_addr = rproc->bootaddr; in k3_r5_rproc_start()
|
| H A D | remoteproc_core.c | 1405 rproc->bootaddr = rproc_get_boot_addr(rproc, fw); in rproc_fw_boot()
|
| /openbmc/linux/include/linux/ |
| H A D | remoteproc.h | 566 u64 bootaddr; member
|
| /openbmc/linux/Documentation/staging/ |
| H A D | remoteproc.rst | 217 The boot address, in case needed, can be found in rproc->bootaddr (remoteproc
|