| /openbmc/linux/drivers/spi/ |
| H A D | spi-microchip-core-qspi.c | 93 #define REG_STATUS (0x10) macro
178 while (readl_relaxed(qspi->regs + REG_STATUS) & STATUS_RXFIFOEMPTY) in mchp_coreqspi_read_op()
190 while (readl_relaxed(qspi->regs + REG_STATUS) & STATUS_RXFIFOEMPTY) in mchp_coreqspi_read_op()
206 while (readl_relaxed(qspi->regs + REG_STATUS) & STATUS_TXFIFOFULL) in mchp_coreqspi_write_op()
218 while (readl_relaxed(qspi->regs + REG_STATUS) & STATUS_TXFIFOFULL) in mchp_coreqspi_write_op()
243 int intfield = readl_relaxed(qspi->regs + REG_STATUS) & STATUS_MASK; in mchp_coreqspi_isr()
249 writel_relaxed(IEN_TXDONE, qspi->regs + REG_STATUS); in mchp_coreqspi_isr()
254 writel_relaxed(IEN_RXAVAILABLE, qspi->regs + REG_STATUS); in mchp_coreqspi_isr()
260 writel_relaxed(IEN_RXDONE, qspi->regs + REG_STATUS); in mchp_coreqspi_isr()
376 ret = readl_poll_timeout(qspi->regs + REG_STATUS, status, in mchp_qspi_wait_for_ready()
|
| H A D | spi-microchip-core.c | 79 #define REG_STATUS (0x08) macro
143 while ((i < fifo_max) && !(mchp_corespi_read(spi, REG_STATUS) & STATUS_RXFIFO_EMPTY)) { in mchp_corespi_read_fifo()
219 while ((i < fifo_max) && !(mchp_corespi_read(spi, REG_STATUS) & STATUS_TXFIFO_FULL)) { in mchp_corespi_write_fifo()
|
| H A D | spi-meson-spifc.c | 26 #define REG_STATUS 0x10 macro
|
| /openbmc/linux/drivers/hwmon/ |
| H A D | max31760.c | 23 #define REG_STATUS 0x5A macro
91 ret = regmap_read(state->regmap, REG_STATUS, ®val); in max31760_read()
99 ret = regmap_read(state->regmap, REG_STATUS, ®val); in max31760_read()
110 ret = regmap_read(state->regmap, REG_STATUS, ®val); in max31760_read()
153 ret = regmap_read(state->regmap, REG_STATUS, ®val); in max31760_read()
|
| /openbmc/linux/drivers/net/ethernet/seeq/ |
| H A D | ether3.c | 122 while ((ether3_inw(REG_STATUS) & STAT_FIFOEMPTY) == 0) { in ether3_setbuffer()
328 while (ether3_inw(REG_STATUS) & (STAT_RXON|STAT_TXON)) in ether3_init_for_open()
422 while (ether3_inw(REG_STATUS) & (STAT_RXON|STAT_TXON)) in ether3_close()
462 ether3_inw(REG_STATUS), ether3_inw(REG_CONFIG1), ether3_inw(REG_CONFIG2)); in ether3_timeout()
529 if (!(ether3_inw(REG_STATUS) & STAT_TXON)) { in ether3_sendpacket()
557 status = ether3_inw(REG_STATUS); in ether3_interrupt()
673 if (!(ether3_inw(REG_STATUS) & STAT_RXON)) { in ether3_rx()
|
| H A D | ether3.h | 44 #define REG_STATUS (priv(dev)->seeq + 0x0000) macro
|
| /openbmc/linux/drivers/media/dvb-frontends/ |
| H A D | lgs8gl5.c | 38 #define REG_STATUS 0xa4 macro
205 val = lgs8gl5_read_reg(state, REG_STATUS); in lgs8gl5_start_demod()
244 u8 flags = lgs8gl5_read_reg(state, REG_STATUS); in lgs8gl5_read_status()
|
| /openbmc/linux/drivers/media/spi/ |
| H A D | gs1662.c | 26 #define REG_STATUS 0x04 macro
310 gs_read_register(gs->pdev, REG_STATUS, ®_value); in gs_query_dv_timings()
383 ret = gs_read_register(gs->pdev, REG_STATUS, ®_value); in gs_g_input_status()
|
| /openbmc/qemu/hw/intc/ |
| H A D | goldfish_pic.c | 23 REG_STATUS = 0x00, enumerator
80 case REG_STATUS: in goldfish_pic_read()
|
| /openbmc/linux/drivers/media/tuners/ |
| H A D | max2165_priv.h | 28 #define REG_STATUS 0x11 macro
|
| H A D | max2165.c | 226 max2165_read_reg(priv, REG_STATUS, &status); in max2165_debug_status()
|
| /openbmc/u-boot/drivers/gpio/ |
| H A D | pm8916_gpio.c | 25 #define REG_STATUS 0x08 macro
142 reg = pmic_reg_read(dev->parent, gpio_base + REG_STATUS); in pm8916_gpio_get_value()
|
| /openbmc/linux/drivers/mmc/host/ |
| H A D | moxart-mmc.c | 46 #define REG_STATUS 40 macro
187 *status = readl(host->base + REG_STATUS); in moxart_wait_for_status()
401 if (readl(host->base + REG_STATUS) & CARD_DETECT) { in moxart_request()
463 status = readl(host->base + REG_STATUS); in moxart_irq()
534 return !!(readl(host->base + REG_STATUS) & WRITE_PROT); in moxart_get_ro()
|
| /openbmc/linux/drivers/net/usb/ |
| H A D | net1080.c | 87 #define REG_STATUS ((u8)0x11) macro
267 if ((retval = nc_register_read(dev, REG_STATUS, &vp)) < 0) { in net1080_reset()
310 retval = nc_register_read(dev, REG_STATUS, &vp); in net1080_check_connect()
|
| /openbmc/linux/drivers/pwm/ |
| H A D | pwm-vt8500.c | 32 #define REG_STATUS 0x40 macro
61 while ((readl(vt8500->base + REG_STATUS) & mask) && --loops) in vt8500_pwm_busy_wait()
|
| /openbmc/linux/drivers/input/touchscreen/ |
| H A D | st1232.c | 29 #define REG_STATUS 0x01 /* Device Status | Error Code */ macro
96 error = st1232_ts_read_data(ts, REG_STATUS, 1); in st1232_ts_wait_ready()
|
| /openbmc/qemu/hw/ipack/ |
| H A D | tpci200.c | 55 #define REG_STATUS 0x0C macro
226 case REG_STATUS: in tpci200_read_las0()
268 case REG_STATUS: in tpci200_write_las0()
|
| /openbmc/linux/drivers/power/supply/ |
| H A D | sbs-battery.c | 37 REG_STATUS, enumerator
133 [REG_STATUS] =
586 ret = sbs_read_word_data(client, sbs_data[REG_STATUS].addr); in sbs_get_battery_presence_and_health()
1079 ret = sbs_read_word_data(chip->client, sbs_data[REG_STATUS].addr); in sbs_delayed_work()
|
| /openbmc/linux/drivers/crypto/qce/ |
| H A D | regs-v5.h | 12 #define REG_STATUS 0x100 macro
|
| H A D | common.c | 89 qce_write(qce, REG_STATUS, 0); in qce_setup_config()
571 *status = qce_read(qce, REG_STATUS); in qce_check_status()
|
| /openbmc/u-boot/include/linux/mtd/ |
| H A D | spinand.h | 137 #define REG_STATUS 0xc0 macro
|
| /openbmc/u-boot/drivers/spi/ |
| H A D | meson_spifc.c | 24 #define REG_STATUS 0x10 macro
|
| /openbmc/linux/drivers/media/i2c/s5c73m3/ |
| H A D | s5c73m3.h | 72 #define REG_STATUS S5C73M3_REG(0x0009, 0x5080) macro
|
| /openbmc/linux/sound/soc/apple/ |
| H A D | mca.c | 47 #define REG_STATUS 0x0 macro
290 mca_modify(cl, REG_STATUS, STATUS_MCLK_EN, STATUS_MCLK_EN); in mca_fe_enable_clocks()
298 mca_modify(cl, REG_STATUS, STATUS_MCLK_EN, 0); in mca_fe_disable_clocks()
|
| /openbmc/linux/include/linux/mtd/ |
| H A D | spinand.h | 160 #define REG_STATUS 0xc0 macro
|