/openbmc/linux/drivers/media/platform/cadence/ |
H A D | Kconfig | 6 tristate "Cadence MIPI-CSI2 RX Controller" 12 Support for the Cadence MIPI CSI2 Receiver controller. 18 tristate "Cadence MIPI-CSI2 TX Controller" 24 Support for the Cadence MIPI CSI2 Transceiver controller.
|
/openbmc/linux/drivers/phy/amlogic/ |
H A D | Kconfig | 41 tristate "Meson G12A MIPI Analog DPHY driver" 48 Enable this to support the Meson MIPI Analog DPHY found in Meson G12A 81 Enable this to support the Meson MIPI + PCIE PHY found 86 tristate "Meson AXG MIPI + PCIE analog PHY driver" 93 Enable this to support the Meson MIPI + PCIE analog PHY 98 tristate "Meson AXG MIPI DPHY driver" 105 Enable this to support the Meson MIPI DPHY found in Meson AXG
|
/openbmc/linux/Documentation/devicetree/bindings/media/i2c/ |
H A D | tc358743.txt | 1 * Toshiba TC358743 HDMI-RX to MIPI CSI2-TX Bridge 3 The Toshiba TC358743 HDMI-RX to MIPI CSI2-TX (H2C) is a bridge that converts 4 a HDMI stream to MIPI CSI-2 TX. It is programmable through I2C. 20 MIPI CSI-2 clock is continuous or non-continuous. 25 For further information on the MIPI CSI-2 endpoint node properties, see
|
/openbmc/linux/Documentation/driver-api/soundwire/ |
H A D | summary.rst | 5 SoundWire is a new interface ratified in 2015 by the MIPI Alliance. 58 The MIPI SoundWire specification uses the term 'device' to refer to a Master 69 Programs all the MIPI-defined Slave registers. Represents a SoundWire 77 Driver controlling the Slave device. MIPI-specified registers are controlled 91 Bus implements API to read standard Master MIPI properties and also provides 133 MIPI specification, so Bus calls the "sdw_master_port_ops" callback 141 The MIPI specification requires each Slave interface to expose a unique 154 board-file, ACPI or DT. The MIPI Software specification defines additional 181 For capabilities, Bus implements API to read standard Slave MIPI properties 198 SoundWire MIPI specification 1.1 is available at: [all …]
|
/openbmc/linux/Documentation/devicetree/bindings/media/ |
H A D | imx.txt | 27 This is the device node for the MIPI CSI-2 Receiver core in the i.MX 28 SoC. This is a Synopsys Designware MIPI CSI-2 host controller core 39 - clocks : the MIPI CSI-2 receiver requires three clocks: hsi_tx 46 connecting with a MIPI CSI-2 source, and ports 1 49 MIPI CSI-2 virtual channel outputs.
|
/openbmc/linux/drivers/phy/rockchip/ |
H A D | Kconfig | 13 tristate "Rockchip MIPI Synopsys DPHY RX0 driver" 18 Enable this to support the Rockchip MIPI Synopsys DPHY RX0 52 tristate "Rockchip Innosilicon MIPI CSI PHY driver" 57 Enable this to support the Rockchip MIPI CSI PHY with 61 tristate "Rockchip Innosilicon MIPI/LVDS/TTL PHY driver" 66 Enable this to support the Rockchip MIPI/LVDS/TTL PHY with
|
/openbmc/linux/drivers/hwtracing/stm/ |
H A D | Kconfig | 7 Trace Protocol (STP) format as defined by MIPI STP standards. 20 exclusively until the MIPI SyS-T support was added. Use this 23 The receiving side only needs to be able to decode the MIPI 30 tristate "MIPI SyS-T STM framing protocol driver" 33 This is an implementation of MIPI SyS-T protocol to be used 39 addition to the MIPI STP, in order to extract the data.
|
/openbmc/linux/Documentation/trace/ |
H A D | sys-t.rst | 4 MIPI SyS-T over STP 7 The MIPI SyS-T protocol driver can be used with STM class devices to 11 In order to use the MIPI SyS-T protocol driver with your STM device, 33 Now, with the MIPI SyS-T protocol driver, each policy node in the 52 MIPI SyS-T message header. It is off by default as the STP already
|
/openbmc/linux/drivers/gpu/drm/bridge/ |
H A D | Kconfig | 19 tristate "Chipone ICN6211 MIPI-DSI/RGB Converter bridge" 26 ICN6211 is MIPI-DSI/RGB Converter bridge from chipone. 28 It has a flexible configuration of MIPI DSI signal input 177 tristate "Northwest Logic MIPI DSI Host controller" 190 This enables the Northwest Logic MIPI DSI Host controller as 211 tristate "Parade PS8640 MIPI DSI to eDP Converter" 222 MIPI DSI to eDP converter 225 tristate "Samsung MIPI DSIM bridge driver" 234 The Samsung MIPI DSIM bridge controller driver. 235 This MIPI DSIM bridge can be found it on Exynos SoCs and [all …]
|
/openbmc/linux/Documentation/driver-api/media/drivers/ccs/ |
H A D | ccs.rst | 5 MIPI CCS camera sensor driver 8 The MIPI CCS camera sensor driver is a generic driver for `MIPI CCS 62 The MIPI CCS driver supports CCS static data for all compliant devices, 78 vvvv or vv denotes MIPI and SMIA manufacturer IDs respectively, mmmm model ID 84 The ccs-regs.asc file contains MIPI CCS register definitions that are used 113 The PLL model implemented by the PLL calculator corresponds to MIPI CCS 1.1.
|
/openbmc/linux/drivers/media/platform/nxp/ |
H A D | Kconfig | 21 tristate "NXP i.MX8MQ MIPI CSI-2 receiver" 28 Video4Linux2 driver for the MIPI CSI-2 receiver found on the i.MX8MQ 32 tristate "NXP MIPI CSI-2 CSIS receiver found on i.MX7 and i.MX8 models" 39 Video4Linux2 sub-device driver for the MIPI CSI-2 CSIS receiver
|
/openbmc/linux/Documentation/admin-guide/media/ |
H A D | imx7.rst | 16 - MIPI CSI-2 Receiver 20 MIPI Camera Input ---> MIPI CSI-2 --- > |\ 39 This is the MIPI CSI-2 receiver entity. It has one sink pad to receive the pixel 40 data from MIPI CSI-2 camera sensor. It has one source pad, corresponding to the 48 sensor with a parallel interface or from MIPI CSI-2 virtual channel 0. It has 55 can interface directly with Parallel and MIPI CSI-2 buses. It has 256 x 64 FIFO 76 On this platform an OV2680 MIPI CSI-2 module is connected to the internal MIPI
|
H A D | platform-cardlist.rst | 24 cdns-csi2rx Cadence MIPI-CSI2 RX Controller 25 cdns-csi2tx Cadence MIPI-CSI2 TX Controller 45 rcar-csi2 R-Car MIPI CSI-2 Receiver 54 s5p-csis S5P/EXYNOS MIPI-CSI2 receiver (MIPI-CSIS)
|
H A D | imx.rst | 32 camera sensors over Parallel, BT.656/1120, and MIPI CSI-2 buses. 66 - MIPI CSI-2 Receiver for camera sensors with the MIPI CSI-2 bus 84 - Supports parallel, BT.565, and MIPI CSI-2 interfaces. 115 MIPI CSI-2 OV5640 sensor, requires the i.MX6 MIPI CSI-2 receiver. But 117 therefore does not require the MIPI CSI-2 receiver, so it is missing in 140 This is the MIPI CSI-2 receiver entity. It has one sink pad to receive 141 the MIPI CSI-2 stream (usually from a MIPI CSI-2 camera sensor). It has 142 four source pads, corresponding to the four MIPI CSI-2 demuxed virtual 146 This entity actually consists of two sub-blocks. One is the MIPI CSI-2 147 core. This is a Synopsys Designware MIPI CSI-2 core. The other sub-block [all …]
|
/openbmc/linux/drivers/gpu/drm/renesas/rcar-du/ |
H A D | Kconfig | 50 bool "R-Car DU MIPI DSI Encoder Support" 55 Enable support for the R-Car Display Unit embedded MIPI DSI encoders. 64 tristate "RZ/G2L MIPI DSI Encoder Support" 69 Enable support for the RZ/G2L Display Unit embedded MIPI DSI encoders.
|
/openbmc/linux/drivers/media/i2c/ccs/ |
H A D | Kconfig | 3 tristate "MIPI CCS/SMIA++/SMIA sensor support" 7 This is a generic driver for MIPI CCS, SMIA++ and SMIA compliant
|
/openbmc/linux/drivers/media/platform/samsung/exynos4-is/ |
H A D | Kconfig | 36 tristate "S5P/EXYNOS MIPI-CSI2 receiver (MIPI-CSIS) driver" 41 This is a V4L2 driver for Samsung S5P and EXYNOS4 SoC MIPI-CSI2 42 receiver (MIPI-CSIS) devices.
|
/openbmc/u-boot/arch/arm/mach-rockchip/rk3399/ |
H A D | Kconfig | 28 * HDMI, eDP, MIPI-DSI, MIPI-DSI/CSI and MIPI-CSI 41 * HDMI/DP/MIPI
|
/openbmc/linux/drivers/media/platform/sunxi/sun8i-a83t-mipi-csi2/ |
H A D | Kconfig | 3 tristate "Allwinner A83T MIPI CSI-2 Controller and D-PHY Driver" 14 Support for the Allwinner A83T MIPI CSI-2 controller and D-PHY.
|
/openbmc/linux/drivers/media/platform/sunxi/sun6i-mipi-csi2/ |
H A D | Kconfig | 3 tristate "Allwinner A31 MIPI CSI-2 Controller Driver" 14 Support for the Allwinner A31 MIPI CSI-2 controller, also found on
|
/openbmc/linux/Documentation/userspace-api/media/drivers/ |
H A D | ccs.rst | 5 MIPI CCS camera sensor driver 8 The MIPI CCS camera sensor driver is a generic driver for `MIPI CCS 62 The MIPI CCS driver implements a number of private controls under 63 ``V4L2_CID_USER_BASE_CCS`` to control the MIPI CCS compliant camera sensors.
|
/openbmc/linux/drivers/gpu/drm/panel/ |
H A D | Kconfig | 56 uses 24 bit RGB per pixel. It provides a MIPI DSI interface to 67 24 bit RGB per pixel. It provides a MIPI DSI interface to 134 The panel has a resolution of 1080x2246. It provides a MIPI DSI 144 KD35T133 controller for 320x480 LCD panels with MIPI-DSI 154 4-lane 800x1280 MIPI DSI panel. 157 tristate "Feiyang FY07024DI26A30-D MIPI-DSI LCD panel" 163 Feiyang FY07024DI26A30-D MIPI-DSI interface. 166 tristate "HIMAX HX8394 MIPI-DSI LCD panels" 173 720x1440 TFT LCD panel that uses a MIPI-DSI interface. 223 24 bit RGB per pixel. It provides a MIPI DSI interface to [all …]
|
/openbmc/linux/drivers/gpu/drm/stm/ |
H A D | Kconfig | 18 tristate "STMicroelectronics specific extensions for Synopsys MIPI DSI" 22 Choose this option for MIPI DSI support on STMicroelectronics SoC.
|
/openbmc/linux/Documentation/ABI/testing/ |
H A D | configfs-stp-policy-p_sys-t | 8 tagged with this UUID in the MIPI SyS-T packet stream, to 17 Include payload length in the MIPI SyS-T header, boolean. 28 MIPI SyS-T packet metadata, if this many milliseconds have
|
/openbmc/linux/drivers/i3c/master/ |
H A D | Kconfig | 17 Support for Synopsys DesignWare MIPI I3C Controller. 48 tristate "MIPI I3C Host Controller Interface driver (EXPERIMENTAL)" 52 Support for hardware following the MIPI Aliance's I3C Host Controller
|