| /openbmc/linux/drivers/net/fddi/skfp/h/ |
| H A D | fddimib.h | 19 typedef u_long Counter ; typedef
29 Counter count ;
195 Counter fddiMACFrame_Ct ;
196 Counter fddiMACCopied_Ct ;
197 Counter fddiMACTransmit_Ct ;
198 Counter fddiMACToken_Ct ;
199 Counter fddiMACError_Ct ;
200 Counter fddiMACLost_Ct ;
201 Counter fddiMACTvxExpired_Ct ;
202 Counter fddiMACNotCopied_Ct ;
[all …]
|
| /openbmc/openbmc-test-automation/ipmi/ |
| H A D | test_ipmi_poh_counter.robot | 2 Documentation This suite tests IPMI POH Counter Support in OpenBMC.
3 ... Feature: IPMI POH Counter Support
11 ... Get POH Counter Command Via IPMI
12 ... Verify Get POH Counter With Invalid Data Request Via IPMI
13 ... Verify POH Counter Reading With Wait Time
14 ... Verify POH Counter Reading With Host Power Off
15 ... Verify POH Counter Reading With Host Power On
17 ... Script compares Minutes per count and Counter reading for the above scenarios.
24 ... Comparison between Initial POH Counter reading and reading after wait
46 Get POH Counter Command Via IPMI
[all …]
|
| /openbmc/linux/Documentation/driver-api/ |
| H A D | generic-counter.rst | 4 Generic Counter Interface
10 Counter devices are prevalent among a diverse spectrum of industries.
15 Generic Counter interface enables drivers to support and expose a common
21 Counter devices can vary greatly in design, but regardless of whether
25 the Generic Counter interface.
45 When the Signal data is available for user access, the Generic Counter
64 count data. The Generic Counter interface provides the following
83 context of the Generic Counter interface, a counter consists of Counts
94 Counter interface represents the count data as a natural number.
97 for the count data. The Generic Counter interface provides the following
[all …]
|
| /openbmc/u-boot/doc/ |
| H A D | README.mpc83xx.ddrecc | 53 Single Bit Error Counter: 16
62 Counter did not reach Single-Bit Error Threshold.
119 Test Single-Bit Error Counter and Threshold
143 Single Bit Error Counter: 199
151 Observe that Single-Bit Error is 'on' which means that Single-Bit Error Counter
153 is Counter reached Threshold more than one time (it wraps back after reaching
|
| /openbmc/linux/arch/arm64/crypto/ |
| H A D | Kconfig | 164 - CTR (Counter) mode (NIST SP800-38A)
181 - CTR (Counter) mode (NIST SP800-38A)
212 - CTR (Counter) mode (NIST SP800-38A)
244 - CTR (Counter) mode (NIST SP800-38A)
263 - CTR (Counter) mode (NIST SP800-38A)
277 CCM (Counter with Cipher Block Chaining-Message Authentication Code)
293 CCM (Counter with Cipher Block Chaining-Message Authentication Code)
309 GCM (Galois/Counter Mode) authenticated encryption mode (NIST SP800-38D)
|
| /openbmc/bmcweb/redfish-core/include/generated/enums/ |
| H A D | metric_definition.hpp | 15 Counter, enumerator
58 {MetricType::Counter, "Counter"},
|
| /openbmc/linux/drivers/counter/ |
| H A D | Kconfig | 3 # Counter devices
22 tristate "Counter support"
24 This enables counter device support through the Generic Counter
82 tristate "Microchip Timer Counter Capture driver"
87 Select this option to enable the Microchip Timer Counter Block
|
| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-timer-stm32 | 12 The Counter Enable signal CNT_EN is used
54 | Prescaler +-> | Counter | +-> | Master | TRGO(2)
119 Counter is always ON.
|
| H A D | sysfs-driver-ccp | 50 whether Replay Protected Monotonic Counter support has been enabled.
61 whether an Replay Protected Monotonic Counter supported SPI is installed
|
| H A D | sysfs-bus-counter | 5 Indicates the cascading of Counts on Counter X.
14 Counter X.
342 Size of the Counter events queue in number of struct
351 the Counter. This should match the name of the device as it
359 belonging to the Counter.
366 belonging to the Counter.
|
| /openbmc/linux/Documentation/networking/device_drivers/ethernet/mellanox/mlx5/ |
| H A D | counters.rst | 123 Ring / Netdev Counter
137 .. flat-table:: Ring / Software Port Counter Table
140 * - Counter
425 - Counter is incremented when ptr ring is empty, so a slow path allocation
430 - Counter is incremented when an allocation which triggered a refill of the
435 - Counter is incremented when pages obtained from the ptr ring that cannot
440 - Counter is incremented when recycling placed page in the page pool cache.
444 - Counter is incremented when page pool cache was full.
448 - Counter is incremented when page placed into the ptr ring.
452 - Counter is incremented when page released from page pool because the ptr
[all …]
|
| /openbmc/linux/Documentation/devicetree/bindings/arm/omap/ |
| H A D | counter.txt | 1 OMAP Counter-32K bindings
|
| /openbmc/linux/Documentation/devicetree/bindings/timer/ |
| H A D | cirrus,clps711x-timer.txt | 1 * Cirrus Logic CLPS711X Timer Counter
|
| /openbmc/linux/Documentation/arch/mips/ |
| H A D | ingenic-tcu.rst | 4 Ingenic JZ47xx SoCs Timer/Counter Unit hardware
7 The Timer/Counter Unit (TCU) in Ingenic JZ47xx SoCs is a multi-function
|
| /openbmc/linux/arch/arc/boot/dts/ |
| H A D | skeleton_hs_idu.dtsi | 51 /* 64-bit Global Free Running Counter */
|
| /openbmc/u-boot/drivers/timer/ |
| H A D | Kconfig | 93 bool "Cadence TTC (Triple Timer Counter)"
165 bool "x86 Time-Stamp Counter (TSC) timer support"
168 Select this to enable Time-Stamp Counter (TSC) timer for x86.
|
| /openbmc/linux/tools/perf/scripts/python/ |
| H A D | mem-phys-addr.py | 26 load_mem_type_cnt = collections.Counter()
|
| /openbmc/linux/Documentation/driver-api/mmc/ |
| H A D | mmc-tools.rst | 30 - Counter value for the rpmb device will be read to stdout.
|
| /openbmc/linux/Documentation/admin-guide/perf/ |
| H A D | hisi-pcie-pmu.rst | 76 selected by configuring BDF to "bdf". Counter only counts the bandwidth of
102 Counter counts when TLP length within the specified range. You can set the
|
| /openbmc/linux/Documentation/arch/parisc/ |
| H A D | registers.rst | 14 CR 0 (Recovery Counter) used for ptrace
81 R (Recovery Counter trap) 0
|
| /openbmc/phosphor-host-ipmid/ |
| H A D | host-ipmid-whitelist.conf | 9 0x00:0x0F //<Chassis>:<Get POH Counter Command>
|
| /openbmc/linux/arch/arm/crypto/ |
| H A D | Kconfig | 179 - CTR (Counter) mode (NIST SP800-38A)
200 - CTR (Counter) mode (NIST SP800-38A)
|
| /openbmc/linux/tools/perf/Documentation/ |
| H A D | intel-hybrid.txt | 29 [Fixed Counter: Counts the number of instructions retired. Unit: cpu_atom]
31 [Number of instructions retired. Fixed Counter - architectural event. Unit: cpu_core]
|
| /openbmc/u-boot/include/ |
| H A D | ppc_asm.tmpl | 89 #define COUNTA 150 /* Breakpoint Counter (37-44) */
90 #define COUNTB 151 /* Breakpoint Counter (37-44) */
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/ |
| H A D | armada3700-periph-clock.txt | 29 14 counter Counter
|