| /openbmc/linux/Documentation/devicetree/bindings/power/reset/ |
| H A D | ltc2952-poweroff.txt | 3 This chip is used to externally trigger a system shut down. Once the trigger has
4 been sent, the chip's watchdog has to be reset to gracefully shut down.
21 assertion before executing shut down procedure.
|
| /openbmc/linux/drivers/power/reset/ |
| H A D | ltc2952-poweroff.c | 13 * Its function is to determine when a external shut down is triggered
24 * A level change indicates the shut-down trigger. If it's state reverts
25 * within the time-out defined by trigger_delay, the shut down is not
31 * Once a shut down is triggered, the driver will toggle this signal,
32 * with an internal (wde_interval) to stall the hardware shut down.
35 * The last action during shut down is triggering this signalling, such
131 * time-out (timer_trigger). Once the time-out is actually reached the shut
|
| H A D | at91-poweroff.c | 23 #define AT91_SHDW_CR 0x00 /* Shut Down Control Register */
24 #define AT91_SHDW_SHDW BIT(0) /* Shut Down command */
27 #define AT91_SHDW_MR 0x04 /* Shut Down Mode Register */
35 #define AT91_SHDW_SR 0x08 /* Shut Down Status Register */
|
| H A D | at91-sama5d2_shdwc.c | 34 #define AT91_SHDW_CR 0x00 /* Shut Down Control Register */
35 #define AT91_SHDW_SHDW BIT(0) /* Shut Down command */
38 #define AT91_SHDW_MR 0x04 /* Shut Down Mode Register */
44 #define AT91_SHDW_SR 0x08 /* Shut Down Status Register */
|
| /openbmc/phosphor-dbus-interfaces/yaml/xyz/openbmc_project/State/Shutdown/ |
| H A D | ThermalEvent.errors.yaml | 2 description: The system shut down due to processor overtemp.
5 description: The system shut down due to a GPU overtemp.
|
| H A D | Inventory.errors.yaml | 2 description: The system shut down due to not enough functional fans.
|
| H A D | Power.errors.yaml | 2 description: The system was shut down because a power fault was detected.
|
| /openbmc/qemu/qapi/ |
| H A D | yank.json | 56 # - nbd block device: Yanking it will shut down the connection to the
58 # - socket chardev: Yanking it will shut down the connected socket.
59 # - migration: Yanking it will shut down all migration connections.
|
| /openbmc/openbmc/meta-ibm/recipes-phosphor/dbus/fan-policy/swift/ |
| H A D | water-cooled.yaml | 158 for more than 25 seconds. Shut the system down. Count present
179 marked as nonfunctional for five seconds. Shut the system down.
208 'Shut the system down, log an event in the journal, and create an
234 'Shut down the system.'
|
| H A D | air-cooled.yaml | 158 for more than 25 seconds. Shut the system down. Count present
179 marked as nonfunctional for five seconds. Shut the system down.
208 'Shut the system down, log an event in the journal, and create an
234 'Shut down the system.'
|
| /openbmc/openbmc/meta-ibm/recipes-phosphor/dbus/thermal-policy/ibm-ac-server/ |
| H A D | thermal-policy.yaml | 3 # Shut down the system if more than three cores
133 too hot. Shut the system down.'
147 'Shut the system down and log an event.'
157 'Shut down the system.'
|
| /openbmc/linux/Documentation/hwmon/ |
| H A D | tmp108.rst | 35 the TMP108 has a one-shot mode where the device is normally shut-down. When a
37 and then the device is shut down automatically. (This driver only supports
|
| /openbmc/openbmc/meta-ibm/recipes-phosphor/dbus/fan-policy/witherspoon/ |
| H A D | water-cooled.yaml | 187 for more than 25 seconds. Shut the system down. Count present
208 marked as nonfunctional for five seconds. Shut the system down.
256 'Shut the system down, log an event in the journal, and create an
282 'Shut down the system.'
|
| H A D | air-cooled.yaml | 193 for more than 25 seconds. Shut the system down. Count present
214 marked as nonfunctional for five seconds. Shut the system down.
262 'Shut the system down, log an event in the journal, and create an
288 'Shut down the system.'
|
| /openbmc/linux/drivers/accessibility/speakup/ |
| H A D | DefaultKeyAssignments | 36 KeyPad-Enter Shut Up (until another key is hit) and sync reading cursor
37 InsKeyPad-Enter Shut Up (until toggled back on).
|
| /openbmc/linux/Documentation/ABI/stable/ |
| H A D | sysfs-driver-firmware-zynqmp | 71 shut down. This may result in the FPD power
72 domain being shut down provided that no other
75 The complete PS will be shut down, including the
79 The complete system/device is shut down.
|
| /openbmc/docs/designs/ |
| H A D | state-management-and-external-interfaces.md | 62 "ForceRestart": "Shut down immediately and non-gracefully and restart
64 "GracefulRestart": "Shut down gracefully and restart the system.",
65 "GracefulShutdown": "Shut down gracefully and power off.",
85 …ncy’ management power down actions. The command does not initiate a clean shut-down of the operati…
|
| /openbmc/linux/drivers/platform/surface/aggregator/ |
| H A D | ssh_packet_layer.h | 28 * Indicates that the packet transport layer has been shut down or is
29 * being shut down and should not accept any new packets/data.
174 * transport layer has been shut down, calls to this function will be ignored.
|
| H A D | ssh_request_layer.h | 26 * Indicates that the request transport layer has been shut down or is
27 * being shut down and should not accept any new requests.
|
| /openbmc/openbmc-test-automation/redfish/extended/ |
| H A D | test_fan_operation.robot | 87 [Documentation] Shut down when not enough fans.
90 # Previous test may have shut down the OS.
|
| /openbmc/linux/tools/arch/arm64/include/asm/ |
| H A D | barrier.h | 58 /* Only to shut up gcc ... */ \
91 /* Only to shut up gcc ... */ \
|
| /openbmc/qemu/tests/functional/ |
| H A D | test_aarch64_raspi4.py | 93 # TODO: Raspberry Pi4 doesn't shut down properly with recent kernels
94 # Wait for VM to shut down gracefully
|
| /openbmc/qemu/hw/misc/ |
| H A D | imx6_src.c | 198 /* CORE 3 is shut down */ in imx6_src_write()
211 /* CORE 2 is shut down */ in imx6_src_write()
224 /* CORE 1 is shut down */ in imx6_src_write()
|
| /openbmc/qemu/docs/system/i386/ |
| H A D | microvm.rst | 110 Triggering a guest-initiated shut down
118 The recommended way to trigger a guest-initiated shut down is by
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/ |
| H A D | idt,versaclock5.yaml | 88 shut down if the SD/OE pin is driven high. If 0, this disables the
89 shutdown functionality: the chip will never be shut down based on
|