| /openbmc/u-boot/drivers/pinctrl/renesas/ |
| H A D | Kconfig | 13 Support pin multiplexing control on Renesas RCar Gen3 R8A7790 SoCs.
23 Support pin multiplexing control on Renesas RCar Gen3 R8A7791 SoCs.
33 Support pin multiplexing control on Renesas RCar Gen3 R8A7792 SoCs.
43 Support pin multiplexing control on Renesas RCar Gen3 R8A7793 SoCs.
53 Support pin multiplexing control on Renesas RCar Gen3 R8A7794 SoCs.
63 Support pin multiplexing control on Renesas RCar Gen3 R8A7795 SoCs.
73 Support pin multiplexing control on Renesas RCar Gen3 R8A7796 SoCs.
83 Support pin multiplexing control on Renesas RCar Gen3 R8A77970 SoCs.
93 Support pin multiplexing control on Renesas RCar Gen3 R8A77990 SoCs.
103 Support pin multiplexing control on Renesas RCar Gen3 R8A77995 SoCs.
|
| /openbmc/linux/arch/arm/mach-davinci/ |
| H A D | Kconfig | 36 bool "DAVINCI multiplexing support"
40 Pin multiplexing support for DAVINCI boards. If your bootloader
41 sets the multiplexing correctly, say N. Otherwise, or if unsure,
45 bool "Multiplexing debug output"
48 Makes the multiplexing functions print out a lot of debug info.
50 multiplexing registers.
57 to change the pin multiplexing setup. When there are no warnings
|
| /openbmc/u-boot/drivers/pinctrl/ |
| H A D | Kconfig | 45 bool "Support pin multiplexing controllers"
49 This option enables pin multiplexing through the generic pinctrl
50 framework. Most SoCs have their own multiplexing arrangement where
87 bool "Support pin multiplexing controllers in SPL"
96 to adjust pin multiplexing in SPL in order to boot into U-Boot,
113 Support pin multiplexing control on QCA/Athores ar933x SoCs.
155 Support pin multiplexing control on QCA/Athores qca953x SoCs.
165 Support pin multiplexing control on Rockchip rv1108 SoC.
185 pin configuration and multiplexing. TI's AM335X SoCs are examples of
196 Support pin multiplexing control on STMicrolectronics STi SoCs.
[all …]
|
| /openbmc/linux/drivers/pinctrl/spear/ |
| H A D | pinctrl-spear1340.c | 212 * Pad multiplexing for making all pads as gpio's. This is done to override the
274 /* Pad multiplexing for fsmc_8bit device */
300 /* Pad multiplexing for fsmc_16bit device */
329 /* pad multiplexing for fsmc_pnor device */
368 /* pad multiplexing for keyboard rows-cols device */
398 /* pad multiplexing for keyboard col5 device */
435 /* pad multiplexing for spdif_in device */
467 /* pad multiplexing for spdif_out device */
503 /* pad multiplexing for gpt_0_1 device */
543 /* pad multiplexing for pwm0 device */
[all …]
|
| H A D | pinctrl-spear1310.c | 236 /* Pad multiplexing for i2c0 device */
272 /* Pad multiplexing for ssp0 device */
301 /* Pad multiplexing for ssp0_cs0 device */
367 /* Pad multiplexing for i2s0 device */
403 /* Pad multiplexing for i2s1 device */
439 /* Pad multiplexing for clcd device */
550 /* Pad multiplexing for smi 2 chips device */
622 /* Pad multiplexing for gmii device */
660 /* Pad multiplexing for rgmii device */
714 /* Pad multiplexing for smii_0_1_2 device */
[all …]
|
| H A D | pinctrl-spear320.c | 458 /* Pad multiplexing for CLCD device */
514 /* Pad multiplexing for EMI (Parallel NOR flash) device */
597 /* Pad multiplexing for FSMC (NAND flash) device */
690 /* Pad multiplexing for SPP device */
736 /* Pad multiplexing for SDHCI device */
893 /* Pad multiplexing for I2S device */
946 /* Pad multiplexing for UART1 device */
992 /* Pad multiplexing for UART1 Modem device */
1158 /* Pad multiplexing for UART2 device */
1204 /* Pad multiplexing for uart3 device */
[all …]
|
| /openbmc/u-boot/drivers/pinctrl/mscc/ |
| H A D | Kconfig | 12 Support pin multiplexing and pin configuration control on
21 Support pin multiplexing and pin configuration control on
30 Support pin multiplexing and pin configuration control on
39 Support pin multiplexing and pin configuration control on
48 Support pin multiplexing and pin configuration control on
|
| /openbmc/linux/arch/arm/mach-omap1/ |
| H A D | Kconfig | 42 bool "OMAP multiplexing support"
45 Pin multiplexing support for OMAP boards. If your bootloader
46 sets the multiplexing correctly, say N. Otherwise, or if unsure,
50 bool "Multiplexing debug output"
53 Makes the multiplexing functions print out a lot of debug info.
55 multiplexing registers.
63 to change the pin multiplexing setup. When there are no warnings
|
| /openbmc/u-boot/drivers/pinctrl/aspeed/ |
| H A D | Kconfig | 6 Support pin multiplexing control on Aspeed ast2500 SoC. The driver uses
15 Support pin multiplexing control on Aspeed ast2500 SoC. The driver uses
24 Support pin multiplexing control on Aspeed ast2600 SoC. The driver uses
|
| /openbmc/linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | pinmux-node.yaml | 7 title: Generic Pin Multiplexing Node
23 pin multiplexing nodes:
80 For hardware where pin multiplexing configurations have to be specified for
91 a single pin multiplexing configuration.
100 how pin IDs and pin multiplexing configuration are defined and assembled
|
| H A D | cortina,gemini-pinctrl.txt | 4 see further arm/gemini.txt. It is a purely group-based multiplexing pin
12 Subnodes of the pin controller contain pin control multiplexing set-up
15 Please refer to pinctrl-bindings.txt for generic pin multiplexing nodes
|
| H A D | renesas,rzn1-pinctrl.yaml | 23 - description: GPIO Multiplexing Level1 Register Block
24 - description: GPIO Multiplexing Level2 Register Block
51 A pin multiplexing sub-node describes how to configure a set of (or a
58 Integer array representing pin number and pin multiplexing
|
| H A D | brcm,bcm2835-gpio.txt | 46 The BCM2835 pin configuration and multiplexing supports the generic bindings.
60 Legacy pin configuration and multiplexing binding:
61 *** (Its use is deprecated, use generic multiplexing and configuration
|
| H A D | ste,nomadik.txt | 22 pin multiplexing node layout from the standard pin control bindings
25 Required pin multiplexing subnode properties:
29 group that will be combined with the function to form a multiplexing
|
| H A D | renesas,rza1-ports.yaml | 16 Pin multiplexing and GPIO configuration is performed on a per-pin basis
77 A pin multiplexing sub-node describes how to configure a set of (or a
96 Integer array representing pin number and pin multiplexing
|
| H A D | renesas,rza2-pinctrl.yaml | 16 Pin multiplexing and GPIO configuration is performed on a per-pin basis.
51 A pin multiplexing sub-node describes how to configure a set of
|
| /openbmc/u-boot/drivers/pinctrl/mvebu/ |
| H A D | Kconfig | 7 Support pin multiplexing and pin configuration control on
14 Support pin multiplexing and pin configuration control on
|
| /openbmc/u-boot/drivers/pinctrl/broadcom/ |
| H A D | Kconfig | 6 Support pin multiplexing and pin configuration control on
14 Support pin multiplexing and pin configuration control on
|
| /openbmc/linux/include/linux/ |
| H A D | scx200.h | 42 /* Pin Multiplexing and Miscellaneous Configuration Registers */
46 #define SCx200_PMR 0x30 /* Pin Multiplexing Register */
|
| /openbmc/u-boot/board/freescale/p1_p2_rdb_pc/ |
| H A D | README | 41 pins multiplexing. QE function needs to be disabled to access Nor Flash and
43 in hwconfig. In addition, QE-UEC and QE-TDM also have pins multiplexing, to
|
| /openbmc/linux/include/uapi/linux/ |
| H A D | atmsap.h | 90 #define ATM_MC_NONE 0 /* no multiplexing */
126 unsigned char fw_mpx_cap; /* forward multiplexing capability */
128 unsigned char bw_mpx_cap; /* backward multiplexing capability */
|
| /openbmc/u-boot/include/ |
| H A D | mpc8xx.h | 293 #define MAMR_AMA_MSK 0x00700000 /* Addess Multiplexing size A */
294 #define MAMR_AMA_TYPE_0 0x00000000 /* Addess Multiplexing Type 0 */
295 #define MAMR_AMA_TYPE_1 0x00100000 /* Addess Multiplexing Type 1 */
296 #define MAMR_AMA_TYPE_2 0x00200000 /* Addess Multiplexing Type 2 */
297 #define MAMR_AMA_TYPE_3 0x00300000 /* Addess Multiplexing Type 3 */
298 #define MAMR_AMA_TYPE_4 0x00400000 /* Addess Multiplexing Type 4 */
299 #define MAMR_AMA_TYPE_5 0x00500000 /* Addess Multiplexing Type 5 */
374 #define MBMR_AMB_TYPE_0 0x00000000 /* Addess Multiplexing Type 0 */
375 #define MBMR_AMB_TYPE_1 0x00100000 /* Addess Multiplexing Type 1 */
376 #define MBMR_AMB_TYPE_2 0x00200000 /* Addess Multiplexing Type 2 */
[all …]
|
| /openbmc/linux/Documentation/devicetree/bindings/memory-controllers/ |
| H A D | ti,gpmc-child.yaml | 208 Address and data multiplexing configuration.
211 1 for address-address-data multiplexing mode and
212 2 for address-data multiplexing mode.
|
| /openbmc/linux/Documentation/driver-api/tty/ |
| H A D | n_gsm.rst | 7 This line discipline implements the GSM 07.10 multiplexing protocol
111 Note that after closing the physical port the modem is still in multiplexing
114 a disconnect command frame manually before initializing the multiplexing mode
|
| /openbmc/linux/drivers/pinctrl/actions/ |
| H A D | pinctrl-owl.h | 198 * @mfpctl_reg: multiplexing control register offset
199 * @mfpctl_shift: multiplexing control register bit mask
200 * @mfpctl_width: multiplexing control register width
|