| /openbmc/linux/drivers/staging/sm750fb/ |
| H A D | ddk750_sii164.c | 80 * 0 = Input data is falling edge latched (falling
81 * edge latched first in dual edge mode)
82 * 1 = Input data is rising edge latched (rising
83 * edge latched first in dual edge mode)
88 * 0 = Input data is single edge latched
89 * 1 = Input data is dual edge latched
|
| /openbmc/linux/sound/soc/codecs/ |
| H A D | tas2764.c | 66 u8 latched[6] = {0, 0, 0, 0, 0, 0}; in tas2764_irq() local
70 for (i = 0; i < ARRAY_SIZE(latched); i++) in tas2764_irq()
71 latched[i] = snd_soc_component_read(tas2764->component, in tas2764_irq()
75 if (latched[0] & BIT(i)) { in tas2764_irq()
82 if (latched[0]) { in tas2764_irq()
84 latched[1], latched[2], latched[3], latched[4], latched[5]); in tas2764_irq()
|
| H A D | tas2770.h | 94 /* Latched-Interrupt Reg0 */
98 /* Latched-Interrupt Reg1 */
|
| /openbmc/linux/Documentation/devicetree/bindings/gpio/ |
| H A D | gpio-latch.yaml | 42 The number of clk-gpios and latched-gpios is not fixed. The actual number
55 latched-gpios:
74 - latched-gpios
90 latched-gpios = <&gpio3 21 0>, <&gpio3 22 0>,
|
| /openbmc/linux/Documentation/devicetree/bindings/sound/ |
| H A D | tlv320adcx140.yaml | 70 0 - (default) Odd channel is latched on the negative edge and even
71 channel is latched on the positive edge.
72 1 - Odd channel is latched on the positive edge and even channel is
73 latched on the negative edge.
|
| /openbmc/u-boot/drivers/ata/ |
| H A D | sata_sil.h | 85 HOST_CTRL_TRDY = (1 << 17), /* latched PCI TRDY */
86 HOST_CTRL_STOP = (1 << 18), /* latched PCI STOP */
87 HOST_CTRL_DEVSEL = (1 << 19), /* latched PCI DEVSEL */
88 HOST_CTRL_REQ64 = (1 << 20), /* latched PCI REQ64 */
|
| /openbmc/linux/drivers/gpu/drm/i915/display/ |
| H A D | intel_vrr.c | 61 * Without VRR registers get latched at:
64 * With VRR the earliest registers can get latched is:
68 * The latest point registers can get latched is the vmax decision boundary:
72 * latched) ASAP after a push is sent.
|
| /openbmc/linux/drivers/net/ethernet/broadcom/bnx2x/ |
| H A D | bnx2x_init.h | 639 /* [28] MCP Latched rom_parity
640 * [29] MCP Latched ump_rx_parity
641 * [30] MCP Latched ump_tx_parity
642 * [31] MCP Latched scpad_parity
761 * [7] clears Latched rom_parity in bnx2x_clear_blocks_parity()
762 * [8] clears Latched ump_rx_parity in bnx2x_clear_blocks_parity()
763 * [9] clears Latched ump_tx_parity in bnx2x_clear_blocks_parity()
764 * [10] clears Latched scpad_parity (both ports) in bnx2x_clear_blocks_parity()
|
| H A D | bnx2x_reg.h | 1123 interrupt; [21] RBCR Latched attn; [22] RBCT Latched attn; [23] RBCN
1124 Latched attn; [24] RBCU Latched attn; [25] RBCP Latched attn; [26] GRC
1125 Latched timeout attention; [27] GRC Latched reserved access attention;
1126 [28] MCP Latched rom_parity; [29] MCP Latched ump_rx_parity; [30] MCP
1127 Latched ump_tx_parity; [31] MCP Latched scpad_parity; */
1137 RBCR Latched attn; [22] RBCT Latched attn; [23] RBCN Latched attn; [24]
1138 RBCU Latched attn; [25] RBCP Latched attn; [26] GRC Latched timeout
1139 attention; [27] GRC Latched reserved access attention; [28] MCP Latched
1140 rom_parity; [29] MCP Latched ump_rx_parity; [30] MCP Latched
1141 ump_tx_parity; [31] MCP Latched scpad_parity; */
[all …]
|
| /openbmc/linux/drivers/net/ethernet/mellanox/mlxbf_gige/ |
| H A D | mlxbf_gige_intr.c | 27 /* This error condition is latched into MLXBF_GIGE_INT_STATUS in mlxbf_gige_error_intr()
40 * sent. The "tx_small_frame" condition is latched into the in mlxbf_gige_error_intr()
|
| /openbmc/linux/arch/x86/kernel/ |
| H A D | nmi.c | 141 * can be latched at any given time. Walk the whole list in nmi_handle()
396 * Only one NMI can be latched at a time. To handle in default_do_nmi()
400 * while its real NMI is sitting latched. This will cause in default_do_nmi()
447 * 3) latched
459 * first one finishes. We set the state to "latched", and the exit of
464 * rerun the NMI handler again, and restart the 'latched' NMI.
|
| /openbmc/linux/drivers/comedi/drivers/ |
| H A D | amplc_dio200_pci.c | 133 * 9. "Pattern occurred" latched signal, latches HIGH when pattern
135 * 10. "Pattern gone away" latched signal, latches LOW when pattern
139 * 12. Negated "pattern occurred" latched signal, latches LOW when
141 * 13. Negated "pattern gone away" latched signal, latches LOW when
|
| /openbmc/phosphor-power/phosphor-regulators/docs/config_file/ |
| H A D | or.md | 9 executed, such as a register read that clears latched fault bits.
|
| H A D | and.md | 9 executed, such as a register read that clears latched fault bits.
|
| /openbmc/linux/Documentation/devicetree/bindings/input/touchscreen/ |
| H A D | eeti.txt | 10 latched. This is necessary for platforms that lack
|
| /openbmc/linux/drivers/net/phy/ |
| H A D | marvell-88q2xxx.c | 60 /* The link state is latched low so that momentary link in mv88q2xxx_read_link_gbit()
91 /* The link state is latched low so that momentary link in mv88q2xxx_read_link_100m()
|
| /openbmc/linux/drivers/pwm/ |
| H A D | pwm-imx-tpm.c | 9 * - Changes to polarity cannot be latched at the time of the
213 * is latched into hardware when the next period starts. in pwm_imx_tpm_apply_hw()
233 * is latched into hardware when the next period starts. in pwm_imx_tpm_apply_hw()
|
| /openbmc/skeleton/libopenbmc_intf/ |
| H A D | gpio_configs.h | 26 /* Optional active high pin enabling writes to latched power_up pins. */
|
| /openbmc/linux/include/linux/ |
| H A D | rbtree_latch.h | 3 * Latched RB-trees
18 * implement a latched RB-tree which does allow for unconditional lookups by
|
| /openbmc/linux/include/linux/fsl/ |
| H A D | guts.h | 165 #define CCSR_GUTS_PMUXCR_SSI1_LA 0x00000000 /* Latched address */
169 #define CCSR_GUTS_PMUXCR_SSI2_LA 0x00000000 /* Latched address */
172 #define CCSR_GUTS_PMUXCR_LA_22_25_LA 0x00000000 /* Latched Address */
|
| /openbmc/linux/Documentation/virt/kvm/devices/ |
| H A D | arm-vgic-v3.rst | 132 GICR_ISPENDR0 registers get/set the value of the latched pending state for
139 to ISPENDR) this state is "latched", and only cleared when either the
143 ISPENDR writes are latched; if the device lowers the line level then the
|
| /openbmc/u-boot/arch/arm/mach-uniphier/ |
| H A D | Kconfig | 100 The boot mode pins are latched when the system reset is deasserted
|
| /openbmc/linux/Documentation/devicetree/bindings/iio/magnetometer/ |
| H A D | ti,tmag5273.yaml | 50 The low active interrupt can be configured to be fixed width or latched.
|
| /openbmc/linux/drivers/irqchip/ |
| H A D | irq-sni-exiu.c | 52 * Level triggered interrupts are latched and must be cleared during in exiu_irq_eoi()
88 /* clear interrupts that were latched while disabled */ in exiu_irq_enable()
|
| /openbmc/u-boot/drivers/net/phy/ |
| H A D | generic_10g.c | 38 /* Read twice because link state is latched and a in gen10g_startup()
|