Home
last modified time | relevance | path

Searched +full:ati +full:- +full:band (Results 1 – 9 of 9) sorted by relevance

/openbmc/linux/Documentation/devicetree/bindings/input/
H A Diqs626a.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jeff LaBundy <jeff@labundy.com>
13 The Azoteq IQS626A is a 14-channel capacitive touch controller that features
14 additional Hall-effect and inductive sensing capabilities.
19 - $ref: touchscreen/touchscreen.yaml#
31 "#address-cells":
34 "#size-cells":
37 azoteq,suspend-mode:
[all …]
H A Diqs269a.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jeff LaBundy <jeff@labundy.com>
13 The Azoteq IQS269A is an 8-channel capacitive touch controller that features
14 additional Hall-effect and inductive sensing capabilities.
28 "#address-cells":
31 "#size-cells":
34 azoteq,hall-enable:
37 Enables Hall-effect sensing on channels 6 and 7. In this case, keycodes
[all …]
H A Dazoteq,iqs7222.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jeff LaBundy <jeff@labundy.com>
21 - azoteq,iqs7222a
22 - azoteq,iqs7222b
23 - azoteq,iqs7222c
24 - azoteq,iqs7222d
29 irq-gpios:
32 Specifies the GPIO connected to the device's active-low RDY output.
[all …]
/openbmc/linux/Documentation/PCI/
H A Dboot-interrupts.rst1 .. SPDX-License-Identifier: GPL-2.0
7 :Author: - Sean V Kelley <sean.v.kelley@linux.intel.com>
13 interrupt messages (Assert_INTx/Deassert_INTx). The integrated IO-APIC in a
15 MSI interrupts. If the IO-APIC is disabled (via the mask bits in the
16 IO-APIC table entries), the messages are routed to the legacy PCH. This
17 in-band interrupt mechanism was traditionally necessary for systems that
18 did not support the IO-APIC and for boot. Intel in the past has used the
20 protocol describes this in-band legacy wire-interrupt INTx mechanism for
21 I/O devices to signal PCI-style level interrupts. The subsequent paragraphs
29 When in-band legacy INTx messages are forwarded to the PCH, they in turn
[all …]
/openbmc/linux/drivers/input/misc/
H A Diqs626a.c1 // SPDX-License-Identifier: GPL-2.0+
8 * inductive keys as well as Hall-effect switches, and one for a trackpad that
227 .name = "event-prox",
233 .name = "event-prox-alt",
240 .name = "event-touch",
246 .name = "event-touch-alt",
253 .name = "event-deep",
259 .name = "event-deep-alt",
367 .name = "ulp-0",
378 .name = "trackpad-3x2",
[all …]
H A Diqs269a.c1 // SPDX-License-Identifier: GPL-2.0+
8 * inductive keys as well as Hall-effect switches, and one for each of the two
193 .name = "event-prox",
199 .name = "event-prox-alt",
206 .name = "event-touch",
212 .name = "event-touch-alt",
219 .name = "event-deep",
225 .name = "event-deep-alt",
301 struct iqs269_ch_reg *ch_reg = iqs269->sys_reg.ch_reg; in iqs269_ati_mode_set()
305 return -EINVAL; in iqs269_ati_mode_set()
[all …]
H A Diqs7222.c1 // SPDX-License-Identifier: GPL-2.0-or-later
116 [IQS7222_REG_GRP_CYCLE] = "cycle-%d",
117 [IQS7222_REG_GRP_CHAN] = "channel-%d",
118 [IQS7222_REG_GRP_SLDR] = "slider-%d",
120 [IQS7222_REG_GRP_GPIO] = "gpio-%d",
150 .name = "event-prox",
155 .name = "event-touch",
162 { .name = "event-press", },
164 .name = "event-tap",
171 .name = "event-swipe-pos",
[all …]
/openbmc/linux/sound/pci/hda/
H A DKconfig1 # SPDX-License-Identifier: GPL-2.0-only
2 menu "HD-Audio"
23 This option enables the HD-audio controller. Don't forget
27 will be called snd-hda-intel.
43 will be called snd-hda-tegra.
48 bool "Build hwdep interface for HD-audio driver"
51 Say Y here to build a hwdep interface for HD-audio driver.
52 This interface can be used for out-of-band communication
58 Say Y here to enable the HD-audio codec re-configuration feature.
60 codec setup, add extra verbs, and re-configure the codec dynamically.
[all …]
/openbmc/linux/Documentation/admin-guide/media/
H A Dbttv.rst1 .. SPDX-License-Identifier: GPL-2.0
8 ----------------------
12 ./scripts/config -e PCI
13 ./scripts/config -m I2C
14 ./scripts/config -m INPUT
15 ./scripts/config -m MEDIA_SUPPORT
16 ./scripts/config -e MEDIA_PCI_SUPPORT
17 ./scripts/config -e MEDIA_ANALOG_TV_SUPPORT
18 ./scripts/config -e MEDIA_DIGITAL_TV_SUPPORT
19 ./scripts/config -e MEDIA_RADIO_SUPPORT
[all …]